IMPORTANT NOTICE ABOUT
INSTALLATION MSC-2Dx N
Copyright© 2001 CAT EYE Co.,Ltd.
MSC2DxMM-010604
Printed in Japan
066600120
1
Magnet
1
2
9
E
Attach the magnet 9 temporarily to the right
side spoke of the front wheel.
For the sake of easy installation and operation, some components have been changed.
spoke
When installing to your bicycle, follow the explanation written in this sheet, not the Quick
Start manual.
Sensor
front fork
4
2Dx attachment
Attach the sensor 2 temporarily to the inside of the right front fork.
Adjust the position of the sensor 2 and the magnet 9 so that it
Parts
Make sure that the following parts are included in the package.
1
meets the conditions
ten them tightly.
and
in the “Important” column. Fas-
A
B
2
6 Rubber Pad
7 Band Holder Pad
8 Screw
1 Bracket (with 2Dx attachment)
2 Sensor
3
Reference: If the clearance between the speed sensor and the
magnet is wide, mount the sensor band 34 in an
opposite way as shown.
6
3 Sensor Band-A (L/S)
4 Sensor Band-B
5 Nylon Tie
2
8
9
4
8
9 Magnet
3
0 Attachment for Aerofork
5
3
4
In case of aerofork, apply the attachment 0.
6
7
10
Installation
Follow the following instruction
–
.
1
4
0
Wire
3
4
Important
Secure the wire along the front fork using the ny-
lon ties 5 and wind it round the brake cable up to
handlebar.
1
Attach the sensor and the magnet properly so that their
positions meet the following conditions and
.
A
B
Note: Allow enough wire clearance in the
The clearance between the sensor 2 and the mag-
net 9 should be about 5mm.
area marked with
.
5
A
B
5
Align center of the magnet 9 and the marking line of
the sensor 2 while rotating the front wheel.
Bracket
Use the rubber pad 6 or band holder pad 7 so
that the bracket’s band 1 fits your handlebar. Fix
it with the screw.
A
B
2
2
1
9
Reference: To release the band, pull it while
6
pushing the area marked with
.
press
9
7
about 5mm
entire view
Download from Www.Somanuals.com. All Manuals Search And Download.
marking line
pull
|