Casablanca Fan Company Ventilation Hood W 28 User Manual

W-28 CEILING FAN/ LIGHT CONTROL  
DIAGRAM  
Owners Manual  
For an up-to-date list of selected models that will accept this control, ask your Casablanca  
showroom salesperson or contact Casablanca Fan Company at: 1-888-227-2178  
IMPORTANT NOTE: The fan must be supplied with three independent  
120V AC supply wires to provide power for the fan, the light, and neutral.  
INSTALLATION OF WALL CONTROL  
The fan must be supplied wit h t hree  
5. Wiring preparation, if required:  
CAUTION! To avoid overheating and possible  
damage to other equipment, do not install to  
control receptacle, fluorescent lighting fixture,  
motor-operated appliance, or transformer-  
supplied appliance.  
independent 120V AC supply wires to provide  
power for the fan, the light, and neutral.  
Installation is to be in accordance with all  
National Electrical Code and local codes  
Strip wires:  
• 3/ 8” for 14 guage  
• 1/ 2” for 16 and 18 guage  
NOTE: The wire connectors provided are suitable  
for copper wire only. Use to join the following  
wire combinations: One No. 14 guage with one  
No. 16 or 18 guage  
3/ 8” or 1/ 2”  
The fan may be turned ON and OFF by the  
W-28 wall control.  
The lights may be turned ON and OFF by the  
W-28 and the intensity adjusted from low to  
high.  
CAUTION! Failure to set the pull-chain speed  
to HIGH can result in faulty operation of the  
fan and damage to the W-28 wall control. To  
confirm fan is set to HIGH: Turn W-28 control  
to 'HI' - use pull-chain to find fastest speed.  
NOTE: W-28 is used to describe either Almond (-A) or  
White (-W) finish.  
The W-28 is designed to replace a standard wall  
switch and will fit wall boxes (metal or plastic)  
with a depth of 2” or greater.  
Not for use with fans that use one pull-  
chain switch to control both fan and light.  
6. Connect black lead of control to 120V AC hot  
wire. Connect the red lead to the light circuit  
controlled by slider on right side of unit. Connect  
yellow lead to fan motor(s) wire. The fan speed  
will be controlled by the left slider on the unit.  
If unit is used to control only one light circuit,  
place wire connector on unused lead. Secure these  
connections with the wire connectors.  
7. If a ground wire is provided in your electrical  
box, attach it to the ground screw near the  
bottom of the mounting plate.  
8. Install the W-28 in the wall box with the two  
long screws provided.  
Set the FAN pull chain switch to the HIGH speed  
setting.  
Turn the lights ON at the fan.  
OPERATION  
CAUTION: Ensure power is turned OFF  
at the breaker or fuse panel before  
starting installation.  
1. Raise the fan slider to increase fan speed, lower to decrease.  
2. For the fan, four speeds are available: Low 1, Low 2, Medium, and High.  
The bottom position is OFF.  
3. The light slider is a dimmer, the bottom is OFF, raise to increase intensity of the light.  
4. The toggle switch is a separate preset control—turns both the fan and light off or on to the  
current setting.  
1. Remove the screws and switch plate from the  
existing switch box.  
2. Remove the screws holding the switch in the  
switch box.  
3. Pull the existing switch from the switch box to  
expose the wire connections.  
4. Remove the three wires from the switch.  
ONE YEAR WARRANTY  
This product is warranted to the original purchaser by Casablanca Fan Company against defects in material and workmanship  
for one (1) year from date of purchase. During the warranty period, we will repair or, at our option, replace a defective  
product at no charge. For information on how to obtain service, contact Casablanca's Service Department by calling our  
toll-free number, 888-227-2178. Damage to the product caused by mishandling, improper installation or modification is  
not covered by this warranty. This warranty is given in lieu of all other warranties expressed or implied. Some states do  
not allow limitations of time on an implied warranty, therefore the above limitations may not apply in every case. This  
warranty states specific legal rights which may vary from state to state.  
CAUTION: Be sure no wires are pinched!  
9. Install the wall plate with the two color matched  
screws.  
10.Turn on power to test the controller.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
©Copyright 2000 Casablanca Fan Company  
P/ N 1943990 Rev.B  
P/ D JUL00PDG  

Bernard Welder Q150X 1 User Manual
Blackberry Cell Phone Smartphones User Manual
Blue Rhino Outdoor Fireplace 251828 User Manual
Brother Sewing Machine LS 2220 User Manual
Canon Digital Camera 115 HS User Manual
Casio Cell Phone C721 User Manual
Casio Clock ID 25B User Manual
Cecilware Convection Oven TF 1 2 User Manual
Celestron Binoculars C5 S User Manual
Chicago Electric Power Hammer 92880 User Manual