Continuous Ink Supply System
for
CANON PIXMA IP6000
Installation Instruction
For ST Prefilled Version
Thi s Ver si on of t he Cont i nuous I nk Fl ow Syst em comes wi t h Pr ef i l l ed
Car t r i dges and Aut o Reset Chi ps. You j ust need t o f i l l t he
Reser voi r bot t l es and pr i nt ! The whol e oper at i on i s ver y easy. I t ’
s r eal l y an ef f ect i ve t ool t o save your money.
3、Installation Procedures:
1) First step
Put CISS on the left side of the printer. In the meantime, place all the tubes at correct position. Then pull the small
rubber plug out of Air hole, and insert the air filters into air holes as the pictures shown above.
2) Install cartridges
Pls turn on power.
Open the cover, the cartridge carriage will
move automatically to “Change Cartridge
Place”. Then take off original Cartridges.
Turn off the printer and unplug it.
3) Installation of continuous ink system
Take off the CIS cartridge’s bottom cap and Stick support arm 2.5cm distance from
the cartridges into cartridge carriage. left edge, 4cm distance from bottom side
Clip the tube like the part in red circle.
Clip the tube on the other side of the support Adjust the tube line, make sure cartridge
Move the cartridge carriage to the right side
arm as shown in the picture.
carriage can move to the both sides and the of printer. Check if there is any problem
tube line can come out through the bottom of when moving.
the cartridge like the position in red circle.
Too long is no good.
Twisted line is no good.
Install well.
4、Refill Ink
Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the picture shown above,
please use refill kits to fill ink into Reservoir bottles. Carefully pull out the rubber plugs from the ink refill holes (There
is possibility of ink spattering. Pls be careful.) Refill ink according to the colors. Then re-cap the rubber. (Please keep
the printer and the reservoir bottles at the same horizontal line during the process of refilling ink.)
5. Attention for Maintenance:
Take out the CISS including the inner cartridges and other components. Then remove support arm from printer, and
re-install original cartridges. Please inquire local dealer before sending to maintenance.
6. Notice:
1. Please don’t take out cartridge at random after installing the CIS system. Keep the reservoir bottles on the same
level with the printer.
2. Try to keep at least 1/2 inch of ink in the bottles.
3. Don’t place the Reservoir Bottles too much higher or lower than the printer.
4. Suggested using in a dry place between 15 and 35 degree. Avoid exposure to direct sunlight.
5. Don’t reverse or lean the continuous ink supply systems during shipping. Please make sure all the ink filling holes
and ventilation holes are closed tightly during transportation. Otherwise, the ink may leak.
6. Don’t sway the cartridge frequently. It may cause ink leakage.
7. Don’t pull out the connector of cartridge and don’t tear off adhesive tape at the bottom of cartridge.
7. Warning:
1. Not drinkable; keep it out reach of children.
2. Avoid exposure to direct sunshine and don’t keep it in high or freezing temperature.
3. Avoid collision and fallen down.
|