Canon Camera Lens 10 18mm User Manual

EF-S10-18mm f/4.5-5.6 IS STM  
ENG  
Instructions  
Handling Cautions  
Safety Precautions  
If the lens is taken from a cold environment into a  
warm one, condensation may develop on the lens  
surface and internal parts. To prevent condensation  
in this case, first put the lens into an airtight plastic bag  
before taking it from a cold to warm environment. Then  
take out the lens after it has warmed gradually. Do the  
same when taking the lens from a warm environment  
into a cold one.  
Do not look at the sun or a bright light source  
through the lens or camera. Doing so could result in  
loss of vision. Looking at the sun directly through the  
lens is especially hazardous.  
Whether it is attached to the camera or not, do not  
leave the lens under the sun without the lens cap  
attached. Thito prevent the lens from concentrating  
the sun’s rayshich could cause a fire.  
Do not leave the lens in excessive heat such as in a car  
in direct sunlight. High temperatures can cause the  
lens to malfunction.  
ions usin this instruction  
arning to pent lens or camera malfunction  
or damage.  
Usage Precautions  
When using this lens with an EOS REBEL T4
camera, please be sure to update the camera
firmware to version 1.0.4 or late
Supplementary notes on using the lens and  
aking pictures.  
If the EOS REBEL T4i/650D firware is an earli
version than 1.0.4, there is a st chance that the  
camera will stop operating. If thccurs, pleae remove  
the battery temporarily and inseragain for rect  
camera operation.  
For information on firmware updates, check the  
Canon website.  
ENG-2  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Safety Precautions  
This device complies with Part 15 of the FCC Rules.  
Operation is subject to the following two conditions: (1) This  
device may not cause harmful interference, and (2) this  
device must accept any interference received, including  
interference that may cause undesired operation.  
Do not make any changes or modifications to the equipment  
unless otherwise specified in the instructions. If such  
changes or modifications should be made, you could be  
required to stop operation of the equipment.  
CAN ICES-3 (B) / NMB-3 (B)  
This equipment has been tested and found to comply with  
the limits for a class B digital device, pursuant to part 15  
of the FCC Rules. These limits are designed to provide  
reasonable protection against harmful interference in a  
residential installation. This equipment generates,
can radiate radio frequency energy and, if not ins
used in accordance with the instructions, may ca
interference to radio communications
However, there is no guarantee thnterfeence w
occur in a particular installation. If s equipment do
cause harmful interference to raditelevision recepti
which can be determined by turning e equipmoff and  
on, the user is encouraged to try to cect the irference  
by one or more of the following measur
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment and  
receiver.  
• Connect the equipment into an outlet on a circuit different  
from that to which the receiver is connected.  
• Consult the dealer or an experienced radio/TV technician  
for help.  
ENG-3  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Shooting Precautions  
The EF-S10-18mm f/4.5-5.6 IS STM utilizes a stepping motor that drives the focus lens. The motor  
also controls the focus lens during zooming.  
1. When the camera is OFF  
The motor does not operate while the camera is OFF or when the camera is OFF due to the use of the auto power  
off function. Therefore, users must be aware of the following points.  
Manual focus adjustments are not possible.  
During zooming, delayed focus will occur.  
2. When the lens is in sleep mode  
If not operated for a certain period of time, this lens will eode in oto save power. Sleep mode  
differs from when the camera is OFF due to the use of the off functiIn this state, the motor will not  
operate even if the camera is ON. Therefore, ust be f the following points.  
Manual focus adjustments are not possible
During zooming, delayed focus will occur.  
To exit sleep mode, press the sbutto
3. During initial reset  
When the camera is ON or whehe camera is turnN by pressing the shutter button halfway down when the  
1
camera is OFF due to the use of e auto por off function* , the lens performs an initial reset of the focus lens.  
Although the image in the viewfir will pear out of focus during the initial reset, this does not mean that the  
lens has malfunctioned.  
2
Although the shutter can be released during the initial reset, users must wait approximately 1 second* after the  
initial reset has completed before shooting.  
*1: Applicable to the following EF-S lens compatible EOS cameras:  
EOS 7D, EOS 60D, EOS 60Da, EOS 50D, EOS 40D, EOS 30D, EOS 20D, EOS 20Da, EOS REBEL T3i/600D, EOS  
REBEL T2i/550D, EOS REBEL T1i/500D, EOS REBEL XSi/450D, EOS REBEL T3/1100D, EOS REBEL XS/1000D, EOS  
DIGITAL REBEL XTi/400D DIGITAL, EOS DIGITAL REBEL XT/350D DIGITAL, EOS DIGITAL REBEL/300D DIGITAL  
*2: The initial reset time varies depending on camera being used.  
ENG-4  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Nomenclature  
Focusing ring (6)  
Focus mode switch (6)  
Hood mount  
(7)  
Zoom position  
index (7)  
Filter mounting  
thread (10)  
Image stabilizer  
switch (8)  
Zoom ring (
Contacts (6)  
Lens mount index (6)  
For detailed information, reference page numbers are provided in parentheses (**).  
ENG-5  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Mounting and  
Detaching the Lens  
Setting the Focus  
Mode  
1
2
See your camera’s instructions for details on  
mounting and detaching the lens.  
Tin autofocus (AF) mode, set the focus  
moswitch to AF.  
To uonly manual focusing (MF), set the focus  
mode witch to MF, and focus by turning the  
ocusing ring.  
After detaching the lens, place the lens
the rear end up to prevent the lens sur
contacts from getting scratched.  
If the contacts get soiled, atchd, or h
fingerprints on them, corron or faulty  
connections can result. Thcamera and lens  
may not operate properly.  
After autofocusing in ONE SHOT AF mode, focus  
manually by pressing the shutter button halfway  
and turning the focusing ring. (Full-time manual  
focus)  
If the contacts get soiled or hfingeints on  
them, clean them with a soft clot
If you remove the lens, cover it with the dust  
cap. To attach it properly, align the lens mount  
index and the index of the dust cap as shown  
in the diagram, and turn clockwise. To remove it,  
reverse the order.  
Quickly rotating the focusing ring may result in  
delayed focus.  
Manual focus adjustments are not possible when  
the camera is OFF.  
ENG-6  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Zooming  
Hood (sold separately)  
3
4
73C hocuts out unwanted light and  
he front he lens from rain, snow,  
at.  
To ach the hood, align the hood’s attachment  
positmark with the red dot on the front of the  
ens, then turn the hood as shown by the arrow  
ntil the lens’ red dot is aligned with the hood’s  
stop position mark.  
To zoom, turn the lens’ zoom ring.  
Be sure to finish zooming before focusi
Zooming after focusing can affect the f
Blurring may temporarily occur if the zo
quickly rotated.  
Zooming when the camers OFF will res
delayed focus.  
Zooming during still image posure wesult in  
delayed focus. This causes astreakof light  
that are captured during exposure blurred.  
The hood can be reverse-mounted on the lens  
for storage.  
If the hood is not attached properly, vignetting  
(darkening of the perimeter of the picture) may  
occur.  
When attaching or detaching the hood, grasp the  
base of the hood to turn it. To prevent deformation,  
do not grasp the rim of the hood to turn it.  
ENG-7  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Image Stabilizer  
You can use the image stabilizer in AF or MF  
mode.  
5
The Image Stabilizer cannot compensate for a  
blurred shot caused by a subject that moved.  
The Image Stabilizer may not be fully effective  
if you shoot from a violently shaking vehicle or  
other transrtation.  
The Image abilizer consumes more power  
tharmahooting, resulting in fewer shots  
and a movie shooting time.  
This function provides optimal image stabilization  
depending on shooting conditions (such as  
shooting still subjects and following shots).  
n shootinstill subject, it compensates for  
era shake ill directions.  
compensates for vertical camera shake during  
ollowing shots in a horizontal direction, and  
mpensates for horizontal camera shake during  
following shots in a vertical direction.  
When you use a tripod, the Image Stabilizer  
should be turned off to save battery power.  
Even with a monopod, the Image Stabilizer will  
be as effective as during hand-held shooting.  
However, depending on the shooting environment,  
the Image Stabilizer effect may be less effective.  
The image stabilizer function also operates when  
the lens is used with an Extension Tube EF12 II.  
If you set the camera’s Custom Function to  
change the assigned button to operate the AF,  
the Image Stabilizer will operate when you press  
the newly assigned AF button.  
1
Set the STABILIZER swch to ON.  
If you are not going to use timage silizer  
function, set the switch to OFF
2
When you press the shutter button halfway,  
the Image Stabilizer will start operating.  
Make sure the image in the viewfinder is stable,  
then press the shutter button the rest of the way  
down to take the picture.  
ENG-8  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Image Stabilizer  
The image stabilizer for this lens is effective for hand-held shots in the following conditions.  
ON  
O
OFF  
OFF  
When panning subjects in motion.  
In semi-darkened areas sh as indoo
outdoors at night.  
In locations where flash ptography is  
prohibited, such as art musms anheater  
stages.  
In situations where your footing is uncertain.  
In situations where fast shutter settings  
cannot be used.  
ENG-9  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Filters  
(sold separately)  
Extension Tubes  
(Sold Separately)  
6
7
You can attach filters to the filter mounting  
thread on the front of the lens.  
You can attach extension tube EF12 II for  
magnified shots. The shooting distance and  
magnification are shown below.  
Only one filter may be attached.  
If you need a polarizing filter, use the Canon  
Circular Polarizing Filter PL-C B (67 mm).  
To adjust the polarizing filter, first remove the  
lens hood.  
cusing Distance  
Magnification (×)  
Close Long  
Range (mm)  
ose  
Long  
dnce distance distance distance  
0mm  
18mm  
Incompatible  
E
137  
142  
0.87  
0.70  
MF mode is recommended for accurate focusing.  
ENG-10  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Specifications  
8
Focal Length/Aperture  
Lens Construction  
Minimum Aperture  
Angle of View  
10-18mm f/4.5-5.6  
11 groups, 14 elements  
f/22-29*  
Diagonal: 107°30′ - 74°20′, Vertical: 74°10′ - 45°30′, Horizontal: 97°10′ - 64°30′  
Min. Focusing Distance  
Max. Magnification  
0.22 m/0.72 ft.  
0.15x (at 18 mm)  
Approx. 174 x 267 – 101 x 152 mm/6.85 1 – 3.97 x 5.98 inch  
(at 0.22 m/0.72 ft.)  
Field of View  
Filter Diameter  
67 mm  
Max. Diameter and Length Approx. 74.6 x 72.0 mm/2.9nch  
Weight  
Hood  
Approx. 240 g
EW-73C (Sol
E
Lens Cap  
Case  
1116 (Sold S
* Applies to 1/3-stop incrementsith 1/2-stop increts, it will be f/22-27.  
Equivalent to 16-29 mm in the mm film mat.  
The lens length is measured from mt surface to the front end of the lens. Add 24.2 mm when including the  
lens cap and dust cap.  
The size and weight listed are for the lens only, except as indicated.  
Extenders cannot be used with this lens. In addition, there are no close-up lenses designed for use with this lens.  
Aperture settings are specified on the camera. The camera automatically compensates for variations in the  
aperture setting when the camera is zoomed in or out.  
All data listed is measured according to Canon standards.  
Product specifications and appearance are subject to change without notice.  
ENG-11  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
0314Ni © CANON INC. 2014  
CT1-8599-001  

Belkin Network Router 8820AU00390 User Manual
Belkin Server F1DP116SEA User Manual
Black Box Switch SW590A R2 User Manual
Black Decker Laminate Trimmer 3270 User Manual
Black Decker Mixer MX40 User Manual
Blanco Indoor Furnishings 157 064 User Manual
Bose Portable Speaker AM267565 User Manual
Broan Stove RMIP33 User Manual
Chief Manufacturing Indoor Furnishings FSA 100 User Manual
Chromalox Switch KDS 1 User Manual