EF-S10-22mm f/3.5-4.5 USM
ENG
Download from Www.Somanuals.com. All Manuals Search And Download.
Instruction
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Do not make any changes or modifications to the equipment
unless otherwise specified in the instructions. If such changes or
modifications should be made, you could be required to stop
operation of the equipment.
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to part 15 of the FCC
Rules. Tse limits are designed to provide reasonable protection
againshmful interference in a residential installation. This
ment generates, uses and can radiate radio frequency
y and, if not installed and used in accordance with the
inructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
a Safety Precautions
• Do not look at the sun or a bright light source
through the lens or camera. Doing so could
result in loss of vision. Looking at the sun directly
through the lens is especially hazardous.
• Whether it is attached to the camera or not, do
not leave the lens under the sun without the
lens cap attached. This is to prevent the lens from
concentrating the sun’s rays, which could cause a
fire.
Handling Cautions
• If the lens is taken from a cold environment i
a warm one, condensation may develoon th
lens surface and internal parts. To prevnt
condensation in this case, first put the lens ito n
airtight plastic bag before taking it from a cold to
warm environment. Then take out the lens after it
has warmed gradually. Do the same when taking
the lens from a warm environment into a cold one.
• Do not leave the lens in excessive heat such as in
a car in direct sunlight. High temperatures can
cause the lens to malfunction.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for
help.
This Class B digital apparatus complies with Canadian ICES-003.
ENG-2
Download from Www.Somanuals.com. All Manuals Search And Download.
Nomenclature
Zoom position index (→ 5)
Focusing ring (→ 4)
Hood mount (→ 7)
Distance scale (→ 5)
Filter mounting
Focus mode switch
thread (→ 6)
(→ 4)
Zoom ring (→ 5)
Contacts (→ 4)
Lens mount index (→ 4)
For detailed information, reference page numbers are provided in parentheses (→ **).
ENG-3
Download from Www.Somanuals.com. All Manuals Search And Download.
Mounting and Detaching the Lens
Setting the Focus Mode
1
2
See your camera’s instructions for details on
mounting and detaching the lens.
To shoot in autofocus (AF) mode, set the focus
mode witch to AF.
¡After detaching the lens, place the lens with the
rear end up to prevent the lens surface and
electrical contacts from getting scratched.
¡If the contacts get soiled, scratched, or ave
fingerprints on them, corrosion or faulty
connections can result. The camera and lens
may not operate properly.
use nly manual focusing (MF), set the focus
de switch to MF, and focus by turning the
focusing ring. The focusing ring always works,
regardless of the focus mode.
After autofocusing in ONE SHOT AF mode, focus
manually by pressing the shutter button halfway
and turning the focusing ring. (Full-time manual
focus)
¡If the contacts get soiled or have fingerprints on
them, clean them with a soft cloth.
¡If you remove the lens, cover it with the dust
cap. To attach it properly, align the lens mount
index and the ¢ index of the dust cap as shown
in the diagram, and turn clockwise. To remove
it, reverse the order.
ENG-4
Download from Www.Somanuals.com. All Manuals Search And Download.
Zooming
Infinity Compensation Mark
3
4
Infinity compensation mark
Distance index
To zoom, turn the lens’ zoom ring.
To compensate for shifting of the infinity focus
point tht results from changes in temperature.
infinty position at normal temperature is the
pnt at which the vertical line of the L mark is
alined with the distance indicator on the
distance scale.
Be sure to finish zooming before focusing.
Changing the zoom ring after focusing can affect
the focus.
For accurate manual focusing on subjects at
infinity distance, look through the viewfinder while
rotating the focusing ring.
ENG-5
Download from Www.Somanuals.com. All Manuals Search And Download.
Filters (Sold Separately)
Extension Tubes (Sold Separately)
5
6
You can attach filters to the filter mounting
thread on the front of the lens.
You can attach Extension Tube EF12 II for
magnified shots. The shooting distance and
magnification are shown below.
¡Only one filter may be attached.
¡If you need a polarizing filter, use the Canon
Circular Polarizing Filter (77mm).
Camera-to-Subject
Distance (mm)
Magnification
Near
Far
Incompatible
165 0.77×
Near
Far
10mm
22mm
EF12 II
155
0.58×
Althogh Extension Tube EF25 II can be attached,
t is not recommended because the lens-to-subject
distance will be very short.
Manual focusing is recommended for accurate
focusing.
ENG-6
Download from Www.Somanuals.com. All Manuals Search And Download.
Hood (Sold Separately)
7
The EW-83E hood can keep unwanted light out of the lens, and also protects the lens from rain,
snow, and dust.
To attach the hood, align the hood’s attachment posmark with the red dot on the front of the
lens, then turn the hood as shown by the arroil te lens' red dot is aligned with the hood's stop
position mark.
The hood can be reverse-mounted on the lens for storage.
¡Part of the picture may be blocked if the hood is not attached properly.
¡When attaching or detaching the hood, grasp the base of the hood to turn it. To prevent deformation, do not
grasp the rim of the hood to turn it.
ENG-7
Download from Www.Somanuals.com. All Manuals Search And Download.
Close-up Lenses (Sold separately)
8
Attaching a 500D (77mm) Close-up Lens
enables close-up photography.
Magnification will be 0.20× – 0.02×.
¡Close-up Lens 250D cannot be attached
because there is no size that fits the lens.
¡Manual focusing is recommended for accurate
focusing.
ENG-8
Download from Www.Somanuals.com. All Manuals Search And Download.
Specifications
9
Focal Length/Aperture
Lens Construction
Minimum Aperture
Angle of View
10 – 22 mm f/3.5 – 4.5
10 groups, 13 elements
f/22 – 29*
Diagonal: 107° 30’ – 63° 30’
Horizontal: 97° 10’ – 54° 30’
0.24 m/0.8 ft.
Vertical: 74° 10’ – 37° 50’
Min. Focusing Distance
Max. Magnification
Field of View
Filter Diameter
Max. Diameter and Length
Weight
0.17 × (at 22 mm)
approx. 189 × 291 – 92 × 138 mm/7.4 × 11.5 – 3.6 × 5.4 inch (at 0.24 m)
77 mm/3.0 inch
83.5 × 89.8 mm/3.3 × nch
385 g/13.6 oz
Hood
Lens Cap
EW-83E (Sold tel)
E-77U/E-7 II
Case
LP1319 (Sold separately)
* Applies to 1/3-stop increments. With 1/2-stop increments, it will be f/22-27.
¡Equivalent to 16-35 mm in the 35mm film format.
¡The lens length is measured from the mount surface to the front end of the lens. Add 21.5 mm to include the
E-77U lens cap and dust cap, and 24.2 mm for the E-77 II.
¡The size and weight listed are for the lens only, except as indicated.
¡The EF1.4X II/EF2X II extenders cannot be used with this lens.
¡Aperture settings are specified on the camera. The camera automatically compensates for variations in the
aperture setting when the camera is zoomed in or out.
¡All data listed is measured according to Canon standards.
¡Product specifications and appearance are subject to change without notice.
ENG-9
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
0812Ni © CANON INC. 2004
CT1-8517-008
|