CSX500 SETUP GUIDE
PRE-CONFIGURATION INFORMATION
Only qualified personnel should install the CSX500. This Setup Guide is intended for the experienced
network equipment installer.
This Setup Guide describes the tools needed to configure the CyberSWITCH CSX500.
For further details concerning the operation of the CSX500, refer to the HSIM-W84 documentation on
the QuickSet CD. The HSIM-W84 is similar to the CSX500. The difference is that the HSIM-W84 is a
NOTE
module that is installed into a host device, while the CSX500 is a standalone unit. All other information
pertaining to the device is the same.
ROUTER/SWITCH/INVERSE MUX
ENET
LAN
ASYNC
T1-1
T1-2
T1-3
T1-4
LNK
RX
TX
LNK
STS
LNK
LNK
LNK
STS
PWR
CPU
STS
STS
STS
CONSOLE
TELCO
WAN BRANCH OFFICE CONCENTRATOR
Figure 1 The CSX500
QuickSet CONFIGURATION SETUP
Tools needed
The following tools are required to configure the CSX500:
•
•
•
Personal Computer (PC)
Read Me First! instruction sheet (enclosed in the manual package)
QuickSet CD (located in the shipping box with your device)
Cabletron Systems highly recommends using the QuickSet utility to configure the CSX500. Using the
QuickSet CD will ensure a fast and correct installation. Using other methods may not produce correct or
as efficient results as the QuickSet CD.
NOTE
PN 9032534-03
Page 1 of 2
Download from Www.Somanuals.com. All Manuals Search And Download.
