English
Super hard sole plate
Saphir-jet electronic
Your Braun steam iron has a unique sole plate
made out of a special resistant alloy, polished
with sapphire particles. This process developed
by Braun makes the sole plate extremely durable
and scratch resistant. Even ironing over sharp-
edged fasteners, studs or zippers will not cause
scratches that may snag or damage sensitive
fabric. Thanks to its extra hardness, this sole
plate will maintain its easy gliding properties
throughout the life of the iron.
PV 2550
Type 4693
Steam iron
English
Use Instructions
Guarantee
Service Centers
Download from Www.Somanuals.com. All Manuals Search And Download.
Automatic shut-off
The temperature selector 1is marked with
provide constant steam even when the water
level in the tank is low.
* If pressed too frequently, it can drip.
Should this happen, wait a few seconds
before using it again.
Important: The automatic shut-off ist mercury-
free. The shut-off mechanism causes a slight
rattling noise in the iron during ironing. This
rattling noise is normal and in no case indicates
a fault of the iron.
these symbols:
min. The iron is connected
Jet of steam*
(coming from the
●
Synthetics (acrylic, acetate)
Spray (coming from the
●● Silk/rayon/nylon/polyester/
outlets pat the slim
nozzle 3): The spray
function can be used at
any temperature, to
dampen laundry. To do
so, press the button 6
(water spray = blue).
cotton blends/wool
pointed tip o):
The yellow pilot light 8will flash when the
automatic shut-off is activated within
approximately:
– 30 seconds – if the iron is standing
horizontally on its sole plate and not being
moved.
●●● Cotton/linen
max. Linen
Caution: Keep children
away from the jet of
steam and do not hold
your fingers in front of the
outlets pwhen activating this function.
Select the temperature you need according to
these symbols.
– 15 minutes – if the iron is left standing upright
on its heel and not being moved.
Spray, shot of steam, jet of steam
Before you start ironing, we recommend to press
the buttons 3 or 4 times, in order to activate
these functions.
Storage
When ironing within the red range
area the jet of steam function can
After ironing, always pull the plug out of the wall
outlet. Set the temperature selector 1to «min.»
be used (d). To do so, press the button 5at
intervals of no less than 5 seconds. The jet of
steam has been designed not only for steaming
hard to reach areas like pleats, inside of pockets
etc., but also for steaming hanging clothing (e. g.
velvet skirts, curtains etc.) (f). The jet of steam
functions between horizontal and upright
positions. Be careful not to touch sensitive
textiles with the hot sole plate.
To turn the iron on again: Move the iron briefly
and the yellow pilot light 8stops flashing. This
means that the electrical power is on again. You
can continue ironing as soon as the previously
selected temperature has been reached.
(b) and the steam regulator 4to « » (= steam
•
off) (c).
Dry ironing
To empty the iron hold it with the open water tank
opening 2downwards (g) and shake it 1 or 2
times. The swivel cord 9conveniently winds up
around the cord storage k.
Set the steam regulator 4in position « »
•
(= steam off) (c) for dry ironing. The water
spray 6may be used at any temperature
setting to dampen the laundry. The jet of steam
5and the shot of steam 6buttons can be
activated during dry ironing, provided that the
temperature selector 1is within the continuous
red area
Praktical Guidelines
Type of Water to be Used
This iron is designed for tap water. However,
if you have hard water we recommend to use a
mixture of 1/2 part tap water and 1/2 part distilled
water from drug stores or grocery stores.
IMPORTANT: Store the cool steam iron in a dry
place and always standing on its heel rest j.
The sole plate may be damaged by remaining
water if it is stored horizontally. The warranty
does not cover faults or damage resulting from
improper storage of the iron.
Spray / shot of steam
2-function button:
The functions «water
spray» and «shot of
steam» can be activ-
ated with a 2-function
button. The desired
function can be selected
by turning the button 6
as far as it will go. The
marking (blue = water
spray or red = shot of
Steam ironing
Temperature selection: Set the temperature
selector 1within the red
range steam (b) and wait
Important: Never use distilled water (battery
water). Do not add any additives (e. g. starch) to
the water.
Maintenance and Cleaning
To remove residues of minerals/starch from the
sole plate always use steel wool. Never use a
scouring pad, vinegar or other chemicals. The
steam vents mand jet of steam outlets pmay
be cleaned manually with a toothpick, if
necessary. Clean the sole plate regularly if you
use starch or other aids on the clothes for
ironing.
until the iron has reached the selected
temperature (i. e. the green pilot light 7goes
off). Steam ironing is possible in the entire red
range. Steam ironing at lower temperatures may
cause water drops instead of steam. Should this
happen, turn the steam regulator 4to the
To fill iron
1. Pull the plug out of the wall outlet.
2. Put the steam regulator 4in position « »
•
position « » (= steam off) (c).
steam) must point to the
respective function (e).
Turn the button from blue
(spray) to red (shot of
steam) anti-clockwise
and from red to blue clockwise (e).
•
(= steam off).
3. Open sliding shutter 2.
Steam regulator 4:
Select the quantity of
steam required (c) for
4. Place the iron in the upright position and fill
with water slowly through the tank opening 2
to the «max.» marking L(a), using the
beaker q.
Decalcifying / Self-cleaning
Braun automatic shut-off irons have a built-in
system (anti-calc. valve) to prevent calcification.
It allows you to clean residues from the steam
chamber. Do not use commercial decalcifiers;
they may damage the sole plate.
We recommend to use the self-cleaning function
every 3 months.
each garment with the
steam regulator 4. You
can increase the quantity
by turning the steam
5. Close sliding shutter.
Shot of steam*
(coming from the vents
in the sole plate):
When ironing within the
red area
the shot
of steam function can be
used. It gives an extra,
Selecting the temperature
regulator clockwise (wide
markings) to the end of the red marking.
Connect the iron to a safely located wall outlet
and select the ironing temperature with the
temperature selector 1(b). As soon as the
green pilot light 7goes out, the iron has
reached the temperature selected. To avoid
water dripping, always rest the iron upright while
heating it up keep the steam regulator 4in
Caution: While ironing do not turn the steam
regulator further, otherwise hot water may come
out from the sole plate (see section
«Decalcifying/Self-cleaning»).
particularly powerful shot of steam penetrating
deep into the textiles in order to straighten
creases, collars and pleats. The function «shot
of steam» can be used in normal ironing and
also horizontally for steaming hanging clothing
(e. g. velvet skirts, curtains etc.) (f). Press the
shot of steam button 6at intervals of no less
than 5 seconds. When steaming be careful not to
touch sensitive textiles with the hot sole plate.
position « » (= steam off) (c).
•
By turning the steam regulator anti-clockwise
you can reduce the quantity of steam or turn the
You will usually find the following symbols in your
garments:
steam off « » (= steam off) (see «Ironing
•
Guide»).
Constant steam: Your Braun steam iron is
equipped with a special tank configuration to
4
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Re-inserting the steam regulator with anti-calc.
valve
1. Re-insert the steam regulator so that the
Guarantee
We grant a 1 year guarantee on the product
commencing on the date of purchase.
double-arrow
the iron (F).
2. Then push it down carefully and at the same
time turn the button anti-clockwise.
3. Keep turning the button
to the marking « »
(= steam off).
aligns with the marking on
Within the guarantee period we will eliminate,
free of charge, any defects in the appliance
resulting from faults in material or workmanship
either by repairing, or exchanging parts or
exchanging the whole appliance as we may
choose.
•
1.Turn the steam regulator 4to the position
« » (= steam off).
•
4. Refill the tank with
water, heat the iron up
and press the button 6
3 to 4 times in the shot
of steam function
before ironing, to rinse
the iron.
2.Fill the water tank to the marking «max.» L
and turn the temperature selector 1to the
●●● marking («self-cleaning» = SC) (A).
3.Plug the iron into the socket and wait till the
green pilot light 7goes off.
4.Unplug the iron and hold it over a sink.
5.Turn the steam regu-
Not covered by this guarantee: damage arising
from improper use or storage (operation with
incorrect current/voltage, plugging it into an
unsuitabie power point, breakage use of
commercial decalcifyers, wet storage on the
ironing surface), normal wear and defects which
have a negligible effect on the value or operation
of the appliance.
lator 4clockwise to
ATTENTION: The iron must not be used without
the steam regulator and the anti-calc. valve.
the end of the red
The guarantee becomes void if repairs are
undertaken by unauthorised persons and if
original Braun parts are not used.
marking (B) and then
6.keep turning it to the
double-arrow marking
Ironing Guide
To begin ironing, it is best to start with fabrics
requiring a lower temperature (e. g. synthetics),
and continue with those requiring a higher
temperature (e. g. cotton, linen). Silk and silk-like
synthetics tend to waterspot, therefore before
using the water spray feature, test it on an
inconspicuous spot first.
. The steam regu-
lator will lift (C).
7.Pull out the steam
regulatortogetherwith
the valve vertically
(D). Do not touch the
lower end of the anti-
calc. valve with your
The guarantee only comes into force if the date
of purchase is confirmed by the dealer's stamp
and signature on the guarantee card and
registration card.
This guarantee extends to every country where
this appliance is supplied by Braun or its
appointed distributor and where no import
restrictions or other legal regulations hinder or
prevent service being given under guarantee.
fingers, to avoid a
possible greasy film.
8.Allow all water to drain
Fabrics
Temperature
regulator
setting
Steam
regulator
setting
through the steam
vents in the sole plate,
while shaking the iron slightly. (Caution: Hot
water and steam come out from the sole
plate.)
Synhetics
(acrylic, acetate)
●
(= steam off)
Service under the guarantee does not affect the
expiry date of the guarantee. The guarantee on
parts or entire appliances which are exchanged
ends when the guarantee on this appliance
expires.
•
Silk, rayon,
nylon, polyester,
cotton blends
●●
(= steam off)
to max.
•
9.Wait for the sole plate to cool down and then
clean it (see «Maintenance and Cleaning»).
10.Make sure that the sole plate is completely dry
before storing it.
Wool
●●
(= steam off)
to max.
In the event of a claim under this guarantee,
hand in the complete appliance with the valid
guarantee card to your dealer, or send both to
the nearest Braun Customer Service Centre.
•
Cotton
Linen
●●●
(= steam off)
to max.
•
Cleaning the anti-calc. valve on the steam
regulator
During the time the sole plate is cooling down we
recommend to decalcify the anti-calc. valve in
the following way:
All other claims including for damages resulting
from this guarantee are excluded unless our
liability is legally mandatory.
●●●
to max.
(= steam off)
to max.
•
Mixed fabrics: Always select the temperature
suited for the most sensitive fibre the garment
contains. Follow manufacturer’s instructions on
the label.
1. Put a small quantity of
white vinegar
(not vinegar essence)
Those claims arising out of the sales contract
with the vendor are not affected by this
guarantee.
or lemon juice into a
glass or bowl.
2. Immerse just the bot-
tom part of the valve in
the liquid, wait till it is
For UK only:
This guarantee in no way affects your rights
under statutory law.
Subject to chance without notice.
decalcified and care-
fully brush of remain-
ing residue (E). Do not use a metal brush.
3. Then, rinse it under running water without
touching the lower end of the valve.
This product conforms to the
EMC-Requirements as laid down by
the Council Directive 89/336/EEC.
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.
|