Fire Alarm Systems | FMM-7045 Series Multiplex Addressable Manual Stations
FMM-7045 Series Multiplex Addressable
Manual Stations
Easy addressing with rotary switches
Low current draw
▶
▶
▶
▶
▶
▶
▶
Key-lock reset
Replaceable scored acrylic breakrod option
Terminal connections
ADA compliant
UL Listed
The FMM-7045 Series Multiplex Manual Stations are UL
Listed fire alarm initiating devices that can be connected
along with other multiplex devices on the D7039
Multiplex Expansion Module. The D7024 Addressable
Fire Alarm Control Panel (FACP) supervises the entire
multiplex loop, including the FMM-7045 or FMM-7045-D
manual stations, for troubles, alarms, and ground fault
conditions. Because each manual station occupies only
one address on the multiplex bus, it can be addressed
for any point within the 9 to 255 range allowed by the
multiplex expansion module.
These manual stations are generally installed near
building exits such as stairways and doors, allowing
persons evacuating the building to activate the fire
alarm. They have optional scored acrylic breakrods and
a pull handle that locks in the activated position, to allow
easy identification of alarm activation points.
Functions
Alarm Action
The single-action FMM-7045 has a white pull-down lever
in its center; while the dual-action FMM-7045-D has a
white push lever above the white pull-down lever in its
center. Pulling down the pull-down lever latches it into
place and sends an alarm signal to the control panel over
the multiplex bus. The pull-down lever cannot be reset
unless the correct key is inserted into the manual
station's lock and the unit opened. The latching lever can
then be restored to its normal position.
Certifications and Approvals
Listings and
Approvals:
UL UNIU: Boxes, Non-Coded (UL38)
CSFM: 7150-1615: 122
These manual stations are high-quality units constructed
entirely of non-toxic materials. They have a low profile
and rounded edges to fit most design applications. All
components are painted or have plated surfaces to
inhibit corrosion. Non-corroding screw terminals are
provided for wire connections. They are manufactured
in conformance with the standards set forth in the
Americans with Disabilities Act (ADA).
Complies with:
Americans with Disabilities Act (ADA 4.28.3)
National Fire Protection Association (NFPA 72)
Download from Www.Somanuals.com. All Manuals Search And Download.
|