763
10 Sunnen Drive
St. Louis, MO 63143
telephone: 314-678-6336
fax: 314-781-2714
OPERATION MANUAL
For
Hot Plate-Style
Decanter Warmer
MODELS
Model 8702
8708 Dual In-Line Warmer
8851 Single Warmer
8852 Dual Warmer
Includes:
Installation
Use & Care
Model 8852
Model 8851
NOTE: All warmers shown with optional 8900-Series
Glass Decanters (available separately).
p/n 2M-77719 Rev. C
M763 130821
Download from Www.Somanuals.com. All Manuals Search And Download.
TABLE OF CONTENTS
Thank You for purchasing this
Wells Bloomfield appliance.
WARRANTY STATEMENT
SPECIFICATIONS
xi
1
2
3
3
4
5
5
FEATURES & OPERATING CONTROLS
PRECAUTIONS & GENERAL INFORMATION
AGENCY LISTING INFORMATION
INSTALLATION INSTRUCTIONS
OPERATION
Proper installation, professional
operation and consistent
maintenance of this appliance will
ensure that it gives you the very
best performance and a long,
economical service life.
CLEANING INSTRUCTIONS
EXPLODED VIEWS, PARTS LISTS & WIRE DIAGRAMS
This manual contains the
8852
8708
8851
6
7
8
information needed to properly
install this appliance, and to use,
care for the appliance in a man-
ner which will ensure its optimum
performance.
SPECIFICATIONS
MODEL
8708
STYLE
VOLTS 1ø WATTS
AMPS
POWER SUPPLY CORD
NEMA-5-15P
CEE 7/VII
120 VAC
220-240V
120 VAC
220-240V
120 VAC
220-240V
1.7
0.8
0.8
0.44
1.7
0.8
8708DSU
8708DSUUK
8851
Dual Step-Up
200
100
CW 3100
NEMA-5-15P
CEE 7/VII
8851S
Single
Dual
8851SUK
8852
CW 3100
200
200
NEMA-5-15P
CEE 7/VII
8852D
8852DUK
CW 3100
Decanter warmers operate at a warming temperature of approximately 185ºF ± 10ºF (85 ºC ± 6ºC).
1
Download from Www.Somanuals.com. All Manuals Search And Download.
FEATURES AND OPERATING CONTROLS
POWER CORD
WARMER PLATE
WARMER SWITCH
OPTIONAL DECANTER
(SHOWN FOR POSITION
ONLY)
IL2044a
SLIP-RESISTANT FEET
Fig. 1 Features & Operating Controls
Model 8852 shown. Features are similar for all models.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
PRECAUTIONS AND GENERAL INFORMATION
WARNING: ELECTRIC SHOCK HAzARD
l servicing requiring access to non-insulated components must be performed by qualified
rvice personnel. Do not open any access panels which require the use of tools.
ailure to heed this warning can result in electrical shock.
WARNING: INjURY HAzARD
l installation procedures must be performed by qualified personnel with full knowledge of all
pplicable electrical codes. Failure could result in property damage and personal injury.
ARNING: ELECTRIC SHOCK HAzARD
ewer must be properly grounded to prevent possible shock hazard. DO NOT assume a
umbing line will provide such a ground. Electrical shock will cause death or serious injury.
This appliance is intended for indoor commercial use only.
AUTION:
qUIPMENT DAMAGE
This appliance is intended for use to maintain the temperature of
hot liquids beverage products for human consumption. No other
use is recommended or authorized by the manufacturer or its
agents.
plug in or energize this
appliance until all Installation
Instructions are read and followed.
Damage to the warmer may
occur if these instructions are not
followed.
This appliance is intended for use in commercial establishments,
where all operators are familiar with the appliance use,
limitations and associated hazards. Operating instructions and
warnings must be read and understood by all operators and
users.
AUTION:
URN HAzARD
The following trouble shooting, component views and parts lists
are included for general reference, and are intended for use by
qualified service personnel.
Exposed surfaces of the warmer
may be HOT to the touch.
The warmer plate will be very hot
during operation and can cause
serious burns on contact.
This manual should be considered a permanent part of this
appliance. The manual must remain with the appliance if it is
sold or moved to another location.
Do not discard this
appliance as usual
trash at the end of its
useful life.
Recycle properly.
AGENCY LISTING INFORMATION
This warmer is
listed under UL file E9253.
LISTED E9253
This brewer meets
Standard 4 only when installed,
operated and maintained in accordance with the enclosed
instructions.
STD 4
3
Download from Www.Somanuals.com. All Manuals Search And Download.
INSTALLATION INSTRUCTIONS
READ THIS CAREFULLY BEFORE STARTING THE INSTALLATION
AUTION:
qUIPMENT DAMAGE
Unpack the unit. Inspect all components for completeness and
condition. Ensure that all packing materials have been removed
from the unit.
Dug in or energize this
appliance until all Installation
Instructions are read and
followed.
Damage to the Brewer will occur
if these instructions are not
followed.
Verify that the Spray Head Gasket and Spray Disk are properly
installed.
LEVELING THE UNIT
Verify that slip-resistant foot is installed at each corner of the
warmer.
Set warmer in its operating location. Level the warmer. A spirit
level should be placed on the top of the unit, at the edge, as a
guide when making level adjustments.
AUTION:
NSTABLE
qUIPMENT HAzARD
ELECTRICIAN’S INSTALLATION INSTRUCTIONS
It is very important for safety
and for proper operation that the
brewer is level and stable when
standing in its final operating
position. Provided adjustable,
non-skid legs must be installed at
each corner of the unit.. Failure
to do so will result in movement
of the brewer which can cause
personal Injury and/or damage to
brewer.
REFER TO ELECTRICAL SPECIFICATIONS - Page 1
Check the nameplate to determine correct electrical service
required for the Brewer to be installed.
Warmer models 8708, 8851, 8852, 8871 and 8872 are
equipped with a cord and plug. They require a 115 - 125 volt
15 amp circuit (50/60 Hz, 2 wire plus ground, with NEMA 5-15R
receptacle).
ARNING:
HOCK HAzARD
Brewer must be properly ground-
ed to prevent possible shock haz-
ard. DO NOT assume a plumbing
line will provide such a ground.
Electrical shock will cause death
or serious injury.
IMPORTANT:
The ground prong of the plug
is part of a system designed to
protect you from electrical shock
in the event of internal damage.
Never cut off the ground prong
nor twist a blade to fit an
existing receptacle. Contact a
licensed electrician to install the
proper circuit and receptacle.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATION
Place a decanter of hot beverage on a warmer plate.
CAUTION:
URN HAzARD
Press warmer switch for that warmer plate to ON ( I ).
xposed surfaces of the
warmer may be HOT to the touch.
The warmer plate will be very hot
during operation and can cause
serious burns on contact.
Press warmer switch to OFF (O) when a warmer plate is not in
use for any extended period.
SUGGESTION: Coffee loses its fresh flavor if allowed to set on a
warmer for too long. Discard stale coffee promptly.
DO NOT allow an empty decanter to set on a hot warmer. This
will damage the decanter. Discard any decanter that has been
allowed to boil dry.
Disconnect warmer from electric power if unused for prolonged
periods (i.e. overnight).
CLEANING INSTRUCTIONS
PROCEDURE: Clean Coffee Warmer
AUTION:
PRECAUTIONS: Disconnect warmer from electric power.
Allow warmer to cool.
URN HAzARD
Brewing and serving
temperatures of coffee are
extremely hot. Hot coffee will
cause serious skin burns.
FREqUENCY:
TOOLS:
Daily
Mild Detergent, Clean Soft Cloth or Sponge
AUTION:
HOCK HAzARD
1. Disconnect warmer from electric power.
Allow warmer to cool before cleaning.
Remove decanters.
Dmerge or immerse
warmer in water.
Do not pour or splash water onto
switches or wiring.
2. Wipe the warmer plates with a sponge dampened with warm
water and a mild detergent. Rinse with clean water and
allow to air dry.
IMPORTANT:
3. Wipe the exterior of the warmer with a soft clean cloth or
sponge moistened with clean water and allow to air dry.
DO NOT use steel wool, sharp
objects, or caustic, abrasive or
chlorinated cleansers to clean the
warmer.
Procedure is complete
5
Download from Www.Somanuals.com. All Manuals Search And Download.
8852 EXPLODED VIEW / PARTS LIST / WIRING DIAGRAM
4
1
2
LEFT
WARMER
SWITCH
3
2
1
RED
RIGHT
WARMER
SWITCH
BLACK
ELEMENT
WHITE
BLACK
3
2
1
BLACK
RED
6
7
5
WHITE
WHITE
ELEMENT
WHITE
POWER
CORD
GREEN
WIRING
DIAGRAM
8852
NOTE: Export Cord
White = Blue
8
Black = Brown
9
11
10
REPLACEMENT PARTS LIST
MODEL 8852 SLIM LINE DOUBLE WARMER
120V, 200 W
220/240V, 200W Export
IL2045
8852 Slim Line Double Warmer
8852
8852 UK
Part No.
8852 EU
Fig No
Description
1
2
PLATE COVER WARMER
ELEM WARMER FLAT 120V 100W
CORD & CAP
2D-70090
2N-70091UL
A6-WL0412
2K-70215
2N-70636UL
4
A6-WL0140
A6-WL0141
5
STRAIN RELIEF STR
2K-70648
E5-WL0136
2E-70247
6
BODY, WARMER
7
SWITCH ON-OFF LITED 120V
PANEL BOTTOM
2E-72946
8
E5-Z13605
2C-70316
DD-70315
2C-301522
9
FERRULE EYELET
10
11
BUMPERS RUBBER BLACK
SCREW 8X1/2 PH PAN DRILL
6
Download from Www.Somanuals.com. All Manuals Search And Download.
8708 EXPLODED VIEW / PARTS LIST / WIRING DIAGRAM
REPLACEMENT PARTS LIST
MODEL 8708 STEP-UP DOUBLE WARMER
1
2
6
UPPER
WARMER
UPPER
ELEMENT
WARMER
SWITCH
b
LOWER
WARMER
SWITCH
ELEMENT
7
a
c
8
d
LOWER
WARMER
4
3
5
POWER
CORD
9
10
a
IL2029
MODEL 8708 STEP-UP DOUBLE WARMER
Item No
Part No
Description
Application
1
2
3
4
5
2D-70090
E5-71203
A6-71206
E5-71204
E5-70339
A6-WL0412
A6-WL0141
A6-WL0140
2K-70215
2K-70648
2N-70091UL
2N-70635UL
2E-72946
2E-70247
2A-71732
2C-70127
2C-70098
2C-70099
2C-70132
PLATE COVER WARMER
COVER WARMER TOP
BODY SUB ASSY 8708 WARMER
COVER BACK WARMER
PLATE BOT S/A DBL STEP-UP
CORD & CAP ASSY
CORD & EURO PLUG TERM
CORD & UK PLUG ASSY TERM
STRAIN RELIEF STR
STRAIN RELIEF SMALL
ELEM WARMER 120V 100W
ELEM WARMER 100W 240V/85W
SWITCH ON-OFF LITED 120V
SWITCH ON OFF LTD BLACK 2
LEG ASSY LEVELING
120V
230V
230UK
120V
230V, 230UK
120V
230V, 230UK
120V
6
7
8
9
230V, 230UK
10
a
b
c
d
SCREW 8BX3/8 PH TR HD
CLIP
SCREW 8-32X3/8 PH PAN
NUT TNR ZI #8
Download from Www.Somanuals.com. All Manuals Search And Download.
8851 EXPLODED VIEW / PARTS LIST / WIRING DIAGRAM
1
POWER
SWITCH
ELEMENT
2
6
RED
3
2
1
WHITE
4
5
7
BLACK
WIRING
DIAGRAM
GREEN
POWER
CORD
8
9
EU
UK
4
4
11
10
IL2056
NOTE: 120V DIAGRAM SHOWN, 220V
SAME EXCEPT USE 220V ELEMENT,
CORD AND PLUG, WIRE COLORS.
PARTS LIST
PART Number
MODEL 8851S MODEL 8851S MODEL 8851S
#
DESCRIPTION
Cover Plate
120V
UK 230V
EU 230V
1
2
4
5
6
7
8
9
2D-70090
Element Heating
Assy. Power Cord w/Plug
Strain Relief, Power Cord
Body, Warmer
2N-70091UL
2E-70295
2N-70635UL
A6-WL0140
A6-WL0141
2K-70215
2K-70648
E5-WL0142
2E-70247
Switch, Lighted
2E-72946
Panel, Bottom
E5-Z13649
2C-70316
DD-70315
2C-70092
Ferrule Eyelet
10 Foot, Black Rubber
11 Screw, #8 STSM 5/8”
8
Download from Www.Somanuals.com. All Manuals Search And Download.
NOTES
Download from Www.Somanuals.com. All Manuals Search And Download.
10 Sunnen Drive, St. Louis, MO 63143
telephone: 314-678-6336 fax: 314-781-2714
Download from Www.Somanuals.com. All Manuals Search And Download.
|