BFH6500CN08EFM1.qxd:BFH6500CN08EFM1.qxd 2/1/08 4:57 PM Page 1
14.To prevent a possible fire, DO NOT block air intakes or
exhaust in any manner. DO NOT use on soft surfaces,
like a bed, where openings may become blocked.
15.To disconnect heater, turn controls to OFF, then remove
plug from outlet.
16.Avoid the use of an extension cord because the
extension cord may overheat and cause a risk of fire.
However, if you have to use an extension cord, the
cord shall be No. 14 AWG minimum size and rated not
less than 1875 watts.
17.If the heater will not operate, see specific instructions
on Auto Safety Shut-off.
18.DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed by
qualified personnel only.
19.DISCONTINUE USE IF PLUG OR OUTLET IS HOT. WE
RECOMMEND OUTLET BE REPLACED IF PLUG OR
OUTLET IS HOT TO TOUCH.
DIGITAL THERMOSTAT
Setting the Off Timer:
1. Select the Mode and/or temperature you wish the
heater to run in.
2. While the heater is running, press and hold the up and
down buttons simultaneously.
3. By pressing the up and down buttons, program the
heater to turn off in up to 16 hours from the current
time, in increments of 1 hour.
4. After setting the timer, the LED display will return to
show the current room temperature. A LED will
illuminate to show that the timer is activated.
5. After the predetermined length of time has passed, the
heater will automatically shut off.
AUTO SAFETY SHUT-OFF WITH INSTANT TIP OVER
PROTECTION
HEATER SAFETY
Your heater is equipped with a Digital Thermostat that
allows you to set your heater to your precise comfort level.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFEGUARDS
This heater is equipped with a patented,
Remote Control
Tower Fan
Heater
technologically-advanced safety system that requires the
user to reset the heater if there is a potential overheat
situation. When a potential overheat temperature is
reached, the system will automatically shut the heater off. It
can only resume operation when the user resets the unit.
For specific reset instructions please refer to the unit.
Setting the Digital Thermostat:
1. Press the Mode Button once for manual HI power. The
heater will run continuously on HI.
2. Press the Mode Button again for manual LO power.
The heater will run continuously on LO.
3. Press the Mode Button for a third time for Auto Mode
HI Power (AH) or press again for Auto Mode LO Power
(AL). In either of these modes you may then press the
up , and down buttons to preset your desired
temperature.
4. Once you have preset your desired temperature, the
display will return to current room temperature and
gradually increase until the room has reached the
preset temperature.
5. If the unit will not start in the digital thermostat mode,
please make sure the “preset temperature” is higher
than the current room temperature.
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:
MODEL BFH6500
To Reset the Heater:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance directly
into a 120 V AC electrical outlet.
If the unit shuts down:
1. Unplug unit.
2. Wait 10 minutes for unit to cool down.
3. Plug in and operate normally.
3. The heater is hot when in use. To avoid burns, DO NOT
let bare skin touch hot surfaces. If provided, use handles
when moving this heater. Keep combustible materials,
such as furniture, pillows, bedding, papers, clothes,
and curtains at least 3 ft (0.9 m) from the front of the
heater and keep them away from the sides and rear.
4. DO NOT run cord under carpeting. DO NOT cover cord
with throw rugs, runners, or the like. Arrange cord
away from traffic area and where it will not be tripped
over.
5. This heater is not intended for use in bathrooms, laundry
areas and similar indoor locations. NEVER locate
heater where it may fall into a bathtub or other water
container.
6. Extreme caution is necessary when any heater is used
by, or near children or invalids, and whenever the
heater is left operating and unattended.
7. Always unplug the heater when not in use.
8. When unplugging, be sure to pull by the plug and not
the cord.
9. DO NOT insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
10.DO NOT operate heater with a damaged cord or plug,
or after the heater malfunctions, has been damaged in
any manner. Return appliance to manufacturer for
examination, electrical or mechanical adjustment, or
repair.
Setting the On Timer:
1. While the heater is off, press and hold the up and down
buttons simultaneously.
2. By pressing the up and down buttons, program the
heater to turn on up to 16 hours in advance of current
time, in increments of 1 hour.
3. After the preset length of time has passed, the heater
will automatically turn on at the last mode setting that
was programmed. If no program was set, the heater
will turn on Auto Mode HI Power at 75°F (24°C) for a
preset time of 2 hours.
NOTE: After reaching the preset temperature, the unit will
briefly continue to run with fan only. This ensures a
consistent and accurate temperature reading.
Tip-Over Shut-Off:
When the unit is accidentally knocked over, it will instantly
shut off. To reset, simply place the heater in an upright
position. Press the MODE button and it will operate
normally.
PLEASE SAVE THESE
INSTRUCTIONS
NOTE: It is normal for the heater to cycle ON and OFF as it
maintains the preset temperature. To prevent the unit from
cycling, you need to raise the thermostat setting. When the
preset temperature is reached, the fan will run for 30
seconds without heat. This cool down process ensures an
accurate and consistent temperature reading. If you unplug
the heater, you will have to reset the digital thermostat
again by following the above instructions.
CONSUMER SAFETY INFORMATION
OSCILLATION INSTRUCTIONS
1. Select the desired temperature and mode settings and
press the oscillation (osc.) button.
2. To stop oscillation, press the oscillation button again.
3. Please do not manually turn the heater on the base; it
is designed to turn only by motorized oscillation.
PRE-OPERATING INSTRUCTIONS
THIS APPLIANCE HAS A POLARIZED
AC PLUG (one blade is wider than the
other). To reduce the risk of electric
1. Carefully remove your heater from the box. Make
certain to remove parts from both sides of the packing
foam. Please save carton for off-season storage.
2. Place heater on a firm level surface.
3. Your heater comes assembled.
4. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500 Watts,
this unit draws 12.5 Amps.
shock, this plug is intended to fit in a
polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a
NOTE: Digital thermostat has memory. The digital
thermostat will remember the previous temperature setting
after the unit has been turned off. However, if the unit is
unplugged, the digital thermostat will be reset and will no
longer remember the previous temperature setting.
qualified electrician to install the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR
DEFEAT THIS SAFETY FEATURE IN ANY WAY.
NOTE: The power light will illuminate when the heater is
turned on.
USING THE PROGRAMMABLE TIMER
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
TECHNICAL SPECIFICATIONS
Digital thermostat allows the user to program the heater to
turn on at a preset time, or turn off after a set amount of
time.
Read instructions before operating.
Retain for future reference.
11.A heater has hot and arcing or sparking parts inside.
DO NOT use it in areas where gasoline, paint, or
flammable liquids are used or stored.
Instruction Leaflet
INFO-LINE
12.Use appliance only for intended household use as
described in this manual. Any other use not
recommended by the manufacturer may cause fire,
electric shock, or injury to persons. The use of
attachments not recommended or sold by the
manufacturer may cause hazards.
Wattage:
Working Voltage:
1500W (+ 5% - 15%)
120V AC/60 Hz
¤
If after having read this leaflet, you have any
questions or comments on your heater,
call 1-800-253-2764 in North America.
13.DO NOT use outdoors.
126965/9100020008812
2 YEAR LIMITED WARRANTY
REMOTE CONTROL INSTRUCTIONS
1. Before operation, insert 2 “AAA” batteries into the back
of the remote control.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium) batteries.
CLEANING/MAINTENANCE
During Season Care:
This warranty gives you specific legal rights, and you may
also have other rights that vary from province to province,
state to state or jurisdiction to jurisdiction.
Sunbeam Products, Inc. doing business as Jarden
Consumer Solutions or if in Canada, Sunbeam Corporation
(Canada) Limited doing business as Jarden Consumer
Solutions (collectively “JCS”) warrants that for a period of
two years from the date of purchase, this product will be
free from defects in material and workmanship. JCS, at its
option, will repair or replace this product or any component
of the product found to be defective during the warranty
period. Replacement will be made with a new or remanu-
factured product or component. If the product is no longer
available, replacement may be made with a similar product
of equal or greater value. This is your exclusive warranty.
Do NOT attempt to repair or adjust any electrical or
mechanical functions on this product. Doing so will void
this warranty.
1. Always unplug the heater before cleaning.
2. Clean the unit with a soft cloth moistened with a mild
soap solution.
3. NEVER use abrasive or flammable solvents to clean
the unit.
4. After cleaning, be sure to completely dry the unit with
a cloth or towel.
After Season Care:
How to Obtain Warranty Service
In the U.S.A.
If you have any question regarding this warranty or would
like to obtain warranty service, please call 1-800-253-2764
and a convenient service center address will be provided
to you.
The remote control for this unit
has the capability of operating all
control panel functions. Please
note this remote control will not
work through walls.
In Canada
If you have any question regarding this warranty or would
like to obtain warranty service, please call 1-800-253-2764
and a convenient service center address will be provided
to you.
1. Store heater in a cool, dry location.
POWER: To turn the unit on press
the Mode/On Button. To turn the
unit off press the OFF button.
2. The manufacturer recommends that you store the unit
in its original carton.
In the U.S.A., this warranty is offered by Sunbeam
Products, Inc. doing business as Jarden Consumer
Solutions located in Boca Raton, Florida 33431. In
Canada, this warranty is offered by Sunbeam Corporation
(Canada) Limited doing business as Jarden Consumer
Solutions, located at 20 B Hereford Street, Brampton,
Ontario L6Y 0M1. If you have any other problem or claim in
connection with this product, please write our Consumer
Service Department.
This warranty is valid for the original retail purchaser from
the date of initial retail purchase and is not transferable.
Keep the original sales receipt. Proof of purchase is
required to obtain warranty performance. JCS dealers,
service centers, or retail stores selling JCS products do not
have the right to alter, modify or any way change the terms
and conditions of this warranty.
This warranty does not cover normal wear of parts or dam-
age resulting from any of the following: negligent use or
misuse of the product, use on improper voltage or
current, use contrary to the operating instructions,
disassembly, repair or alteration by anyone other than JCS
or an authorized JCS service center. Further, the warranty
does not cover: Acts of God, such as fire, flood,
hurricanes and tornadoes.
TIP: Over time, dust may accumulate on the front grills.
ꢀ
MODES: To scroll through the
various modes LO, HI, AL and AH
press the Mode/On Button until
you reach your desired setting.
This can be removed by wiping the unit with a damp
cloth. Always unplug unit and allow to cool prior to
cleaning.
OSCILLATION: To start oscillation, press the Osc. Button
once. To stop oscillation press the button again.
TROUBLESHOOTING
If your heater fails to operate:
• UNPLUG THE UNIT.
• Make sure the electrical outlet or circuit breaker is
working.
• Check for obstructions. If you find an obstruction turn
the heater OFF, and unplug the unit. Carefully remove
the obstruction and follow the reset instructions.
• The temperature may be set too low. Adjust the
thermostat until the heater restarts.
TEMPERATURE: To increase the temperature setting,
press the Temp Up button . To decrease the temperature
PLEASE DO NOT RETURN THIS PRODUCT TO ANY
OF THESE ADDRESSES OR TO THE PLACE OF
PURCHASE.
setting that you desire press the Temp Down button
.
TIMER: To activate the timer from the remote control, press
the button marked Timer. From there you can press the
Temp Up or Temp Down button , which will give you
the ability to program the heater to turn on or off in 1 hour
increments, up to 16 hours. For more information see the
programmable timer instructions above.
What are the limits on JCS’s Liability?
JCS shall not be liable for any incidental or consequential
damages caused by the breach of any express, implied or
statutory warranty or condition.
Except to the extent prohibited by applicable law, any
implied warranty or condition of merchantability or fitness
for a particular purpose is limited in duration to the
duration of the above warranty.
For your convenience a remote control holder is integrated
into the heater.
Please DO NOT attempt to open or repair the heater.
Please see the Warranty for Service Instructions.
If you have any questions regarding your product or
would like to learn more about other Bionaire® products,
please contact our Consumer Service Department at
1-800-253-2764 or visit our website at
JCS disclaims all other warranties, conditions or
representations, express, implied, statutory or otherwise.
JCS shall not be liable for any damages of any kind
resulting from the purchase, use or misuse of, or inability to
use the product including incidental, special,
consequential or similar damages or loss of profits, or for
any breach of contract, fundamental or otherwise, or for
any claim brought against purchaser by any other party.
Some provinces, states or jurisdictions do not allow the
exclusion or limitation of incidental or consequential
damages or limitations on how long an implied warranty
lasts, so the above limitations or exclusion may not apply
to you.
© 2008 Sunbeam Products, Inc. doing business as Jarden
Consumer Solutions. All rights reserved. Distributed by
Sunbeam Products, Inc. doing business as Jarden
Consumer Solutions, Boca Raton, Florida 33431.
Printed in China
Download from Www.Somanuals.com. All Manuals Search And Download.
|