Eureka Tents Tent Solar Shade User Manual

• Move back to where you started at the opposite side of  
the shelter. With the pole in one hand and web/grommet in  
the other, feed the pole up. Take care that the ferrules do  
not get caught on the sleeves. Push the pole evenly along  
its length to create an arc. Place the post end of the pole  
into the grommet to maintain tension across the top of the  
shelter. See fig.3.  
Your shelter is now freestanding. Move it to the desired  
location and secure. Since soil conditions vary greatly, we  
have included two methods to secure the shelter:  
1. On sand. Fill the four bags with sand and tie them to  
the four corner webs. Pull the bags out and away from the  
shelter until the floor is taut. Bury the bags in the sand.  
2. On turf. Drive a stake through the grommet on a  
corner web. Work your way around the shelter, squaring  
and staking the base as you go.  
ASSEMBLY  
INSTRUCTIONS  
SOLAR SHADE:  
Component List:  
1 Shelter Body,  
1 Pole Bag,  
2 Short Poles, 1  
1 Carry Bag,  
Long Pole,  
1 Stake Bag w/Stakes,  
See fig.5.  
4 Guy Out Cord  
4 Anchor Bags  
ASSEMBLY:  
• Unroll and unfold the shelter and lay it on the ground with  
the windows facing up.  
fig.3  
• Assemble the shockcorded poles. Try to prevent pole  
sections from snapping together, as this can damage the  
pole ends. Make certain each insert has seated firmly into  
each plain end.  
• Lift the top of the shelter. Push one of the short poles  
through a sleeve and down to a web/grommet at the base.  
At the top of the shelter, insert the post into the grommet.  
Repeat with the second pole into the last sleeve.  
See fig. 1.  
• Move to the base of the shelter. With a pole in one hand  
and web/grommet in the other, push the pole evenly along  
its length to create an arc. Place the post end into the  
grommet to maintain tension across the fabric. Repeat with  
the second pole. See fig.4.  
fig.5  
Your Shelter is ready!  
• Where soil conditions permit and  
when winds prevail, we recommend  
that you attach the guy out cords  
to the four loops on the sleeves  
and stake them out. Use the  
sliders on the cords to adjust  
tension. See fig.6.  
fig.1  
• Slide the long pole through the  
sleeve, across the top of the  
tent. Push the pole, don’t pull  
it. Continue until you reach  
the grommet on other side  
of the tent. Insert the post  
Take down: Open door, untie  
fig.6  
sand bags or pull up stakes. Pull  
posts out of the grommets and  
push poles out of the sleeves.  
Collapse the poles and stow. Fold the  
shelter onto itself in thirds. Roll up towards  
the door and stow.  
at the end of the pole into  
this grommet. See fig.2.  
fig.2  
fig.4  
REV C 4-09  
Download from Www.Somanuals.com. All Manuals Search And Download.  

ACP EP Memory Camera Accessories ACP EP User Manual
ADC Network Card 600F User Manual
Alpine Cooktop PXA H701 User Manual
Aluratek Computer Hardware AHDDU100F User Manual
Amcor Air Conditioner AOS090HR User Manual
American Standard Indoor Furnishings 0495221 User Manual
Apple Network Card Bluetooth Cable User Manual
Audiovox Car Stereo System GM 250 User Manual
Barco Projector H600 User Manual
Eureka Tents Tent Grand Manan Tour User Manual