Behringer Microphone XM1800S User Manual

User’s Manual  
Version 1.1 June 2003  
Download from Www.Somanuals.com. All Manuals Search And Download.  
DYNAMIC MICROPHONE XM1800S  
4. HOW TO USE YOUR XM1800S MOST EFFECTIVELY  
Adjust the gain control in the microphone channel of your mixing console so that the peak LED lights  
up only occasionally or never at all. The EQ controls in the microphone channel should be set to  
mid-travel position to start with; low-cut filter and level attenuator should be turned off. Try to achieve  
the desired sound by experimenting with the microphone position. Place the microphone as close to  
the sound source as possible. The closer your mic gets to the sound source, the greater the bass  
response will be. On the other hand, as you move the sound source further away from the microphone,  
the bass response will gradually roll off (please see frequency response chart on next page).  
Only when the desired basic sound has been achieved, should you start to use equalizers and  
signal processors, if any at all. (Remember: less is often more!)  
All microphones have characteristic polar patterns that determine how well signals from around the  
area of the microphone are accepted or rejected.  
The super cardioid pattern is used by the XM1800S. Thus, the XM1800S excels in environments  
where a lot of undesired ambient noise exists. The XM1800S excellently reproduces those sound  
signals originated directly in front of the microphone while rejecting or minimizing sound signals  
originated in the area behind the microphone (please refer to the polar pattern on next page for  
detailed information).  
5. WARRANTY  
+
or send us a request by e-mail ([email protected]), fax (+49 2154 9206 4199), or  
telephone (+49 2154 9206 4166).  
6. SPECIFICATIONS  
Type:  
Dynamic  
Frequency response:  
Polar pattern:  
Impedance:  
Sensitivity:  
80 Hz - 15 kHz  
Super cardioid  
600  
-52 dBV (0 dBV = 1 V/Pa), 2.5 mV/Pa  
3-pin balanced XLR (male)  
Connector:  
Dimensions:  
Head length  
Main unit length  
Total length  
Weight:  
57.5 mm  
117.5 mm  
175 mm  
230 g  
6. SPECIFICATIONS  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
DYNAMIC MICROPHONE XM1800S  
POLAR DIAGRAM  
FREQUENCY RESPONSE CHART  
Fig. 6.1: Polar diagram and frequency response chart  
BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modifications may be  
made from time to time to existing products without prior notice. Specifications and appearance may differ from those listed or  
illustrated.  
The information contained in this sheet is subject to change without notice. No part of this sheet may be reproduced or transmitted  
in any form or by any means, electronic or mechanical, including photocopying and recording of any kind, for any purpose,  
without the express written permission of BEHRINGER Spezielle Studiotechnik GmbH.  
BEHRINGER is a registered trademark. ALL RIGHTS RESERVED. © 2003 BEHRINGER Spezielle Studiotechnik GmbH.  
BEHRINGER Spezielle Studiotechnik GmbH, Hanns-Martin-Schleyer-Str. 36-38, 47877 Willich-Münchheide II, Germany  
Tel. +49 2154 9206 0, Fax +49 2154 9206 4903  
6. SPECIFICATIONS  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  

2Wire Network Router 1000S User Manual
Abit Whiteboard Accessories KV7 User Manual
Abocom Network Card IFM56CB User Manual
Acer Laptop TM7100 Series User Manual
Acoustic Energy Speaker System Linear Centre User Manual
ADTX Work Light PLUS 90 User Manual
AEG Washer L 60460 FL User Manual
AKG Acoustics Microphone CK33 User Manual
Atlona Switch AT HD V81 User Manual
BB Electronics Computer Hardware 232PCC User Manual