Model APS-25C
Owner's Manual
3 Button Remote Security System
Congratulations! Your purchase of this state-of-the-art security system
expresses a deep concern for the security of your vehicle, its contents,
andpassengers. Tofullyappreciatethemanyfunctionsandsafeguards
incorporated in this system, please spend a few minutes reading this
manual.Youmayfindunexpectedfeaturesthatcouldmeanthedifference
between“protected”and“fullyprotected”.
FEATURES :
2 Three Button Programmable Code Hopping RF Transmitters
Three Channel Receiver ( capable of accepting 4 transmitters )
Code Learning
Remote Panic in all modes
Protected Valet
7 Function LED - Arm / Disarm / Zones 1, 2, & 3 / Valet / Arming
Intrusion Alert with Memory
Audible Arm / Disarm / Defective Zone / Tamper Confirmation
Instant Siren Activation
Starter Disable
True Last Door Arming ( hardwire only )
Defective Zone By - Pass
Hardwire or Voltage Sense Selectable
Active or Passive Arming Selectable
User Programmable Permanent Chirp Delete
6 Tone Multi-Tone Siren
Additional Negative Trigger Input
RF Inhibit with Ignition On
Parking Light Flasher
Plug In Dual Stage Shock Sensor
OPTIONS :
Remote Trunk Release
Remote Keyless Entry
Multiple Vehicle Capable
Remote Starter
Remote Power Window Roll Up
Remote Garage Door Interface
128-8807
1 of 5
Download from Www.Somanuals.com. All Manuals Search And Download.
4. Whenever the system is triggered, the vehicle's parking lights will flash for the 30 second
alarm cycle, attracting added visual attention to the vehicle.
5. Whenever the system is armed, the vehicle's starter will be bypassed. If a thief should
choose to ignore the siren, the vehicle can not be started.
DISARMINGTHESYSTEM:
1. As you approach the vehicle, press and release the Unlock button on the keychain
transmitter.
CAUTION! Excessive pressure on the transmitter buttons will damage the internal components
on the circuit board. All that is required is a light push to the button.
2. The siren will "chirp" 2 times and the vehicle's parking lamps will flash two times.
3A. ACTIVE: The dash mounted LED will turn off, and remain off until the system is re-armed.
3B. PASSIVE: Never attempt to disarm the system from a distance that prevents you from
opening a door within 30 seconds. Since the system is programmed for passive arming,
it will begin to re-arm until a door is opened. Opening the door will suspend the passive
arming cycle.
INTRUSIONWARNINGSIGNALS:
The system will inform you if an intrusion attempt has occurred while you were away from
the vehicle. If an intrusion attempt has occurred, the siren will "chirp" 4 times when disarming
the system.
The vehicle's parking lights will also flash 3 times to indicate an intrusion has occurred. Enter
the vehicle and observe the dash mounted LED for further information.
1. If the LED is flashing one time... pause...one time... etc., then an intrusion attempt was
made to a light activated entry point, or the shock sensor was activated.
2. If the LED is flashing two times...pause...two times...etc., then an intrusion attempt was
made to the hood, trunk, or an optional sensor that has been connected to zone 2.
3. If the LED is flashing three times...pause...three times...etc., then an intrusion attempt was
made through one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory and will only be erased
from memory when the ignition key is turned on.
Push-Button LED Valet / SYSTEM OVERRIDE Switch:
The "Valet" switch allows you to temporarily bypass all alarm functions, eliminating the need
to hand your transmitter to parking attendants or garage mechanics. When the system is in
valet mode, all alarm functions are bypassed, however, the remote panic feature and remote
door locks (optional) will remain operational. To use the valet mode;
1. Enter the vehicle and turn the ignition key to the "on" position.
2. Press and hold the LED valet push-button switch for 5 seconds until the LED turns
on solid. The LED will remain on as long as the system is in the valet mode.
3. To return to normal operation, with the ignition switch on, press and release the LED valet
push-button switch one time. The LED will turn off indicating the unit has been returned
to the normal mode of operation.
In the event you lose your keychain transmitter, or if the transmitter fails to disarm the system,
the valet switch can be used as a system override switch. Open the car door (the alarm
Page 3
128-8807
3 of 5
Download from Www.Somanuals.com. All Manuals Search And Download.
will sound). Turn the ignition key on, and press and hold the LED valet switch on. The
alarm will stop sounding, and the vehicle can now be started.
NOTE: Always remember to exit Valet Mode to ensure that the vehicle remains protected at
all times.
ELIMINATING THE ARM / DISARM CHIRPS:
The normal arming and disarming confirmation "chirps" can easily be turned on and off using
the valet push-button switch. To do this...
1. Turn the ignition key on, and then off.
2. Within 10 seconds of turning the ignition key off, press and release the LED valet
push-button switch three times.
3a. If, before proceeding with step 2, the chirps were on, then you will hear 2 chirps to indicate
that the chirps have been turned off.
3b. If, before proceeding with step 2, the chirps were off, then you will hear 1 chirp to indicate
that the chirps have been turned on.
Note: Whenever the chirps are by-passed, the 3 chirp defect and 4 chirp intrusion indicator
will always operate. This feature will always warn you if there is a defective sensor
during the arming sequence or if the vehicle had been tampered with in your absence,
even if the normal arming and disarming chirps have been turn off.
REMOTEPANICOPERATION:
The Lock and Unlock buttons on your keychain transmitter also functions as a "panic" switch
for instant activation of the alarm in emergency situations. To use the remote panic switch;
1. Press and hold the arming button on the keychain transmitter for 3 seconds or more.
The alarm will immediately sound.
2. To stop the alarm, press and release the Trunk/Key button on the keychain transmitter.
If the button is not pressed, the alarm will automatically stop after 30 seconds.
CAUTION! Excessive pressure on the transmitter buttons will damage the internal
components on the circuit board. All that is required is a light push to the button.
TRUNKRELEASE:
This security system has an additional feature that can be wired to a number of different
optional accessories. Some of the more common uses for this "channel" are:
Remote Trunk Release - available for any vehicle with factory installed electronic
push-button trunk release.
Remote Car Starter - available for most automatic transmission, fuel injected vehicles.
Remote Window Roll Up - available for most vehicles equipped with power windows.
To activate the optional accessory:
Press and hold the Trunk/Key button on the keychain transmitter for approximately
3 seconds. If the system has been programmed differently by your installation center,
this output may be accessed by pressing buttons 1&2 simultaneously for 3 seconds.
NOTE: This feature will not operate when the vehicle's ignition key is turned "ON".
Page 4
128-8807
4 of 5
Download from Www.Somanuals.com. All Manuals Search And Download.
APS-25C
SYSTEM FUNCTIONS AT A GLANCE
DASH LED INDICATORS
RAPID FLASHING..............................................PASSIVE ARMING
SLOW FLASHING .............................................ARMED
OFF ....................................................................DISARMED
ON - SOLID........................................................VALET MODE
3 FLASH ... PAUSE ...........................................INTRUSION ZONE 3
2 FLASH ... PAUSE ...........................................INTRUSION ZONE 2
**1 FLASH ... PAUSE ...........................................INTRUSION ZONE 1
SIREN CHIRP INDICATORS
* 1 CHIRP ............................................................ ARM
* 2 CHIRPS .......................................................... DISARM
3 CHIRPS ......................................................... ARM / ZONE ACTIVE
4 CHIRPS ......................................................... DISARM / INTRUSION
PARKING LAMPS (Optional)
1 FLASH ............................................................ARM
2 FLASH ............................................................DISARM
3 FLASH ............................................................DISARM / INTRUSION
** Where applicable.
* These chirps are optional and may be disengaged.
Your System Has These Features Activated:
Starter Cut-out
Door Lock Interface
Shock Detector
Motion Detector
Hardwire
Optional Channel 2 Device
© 2010 Audiovox Electronic Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788
128-8807
Page 5
128-8807
5 of 5
Download from Www.Somanuals.com. All Manuals Search And Download.
|