INSTALLATION INSTRUCTIONS
Acrylux Builder Series (Above Floor Rough)
Model 6030Y2A.102.XXX
Model 6030Y2A.202.XXX
Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please
read these instructions carefully before you begin. Local building codes vary by location. Observe all local plumbing and building codes.
RECOMMENDED TOOLS AND MATERIALS
Tape Measure
Mortar Compound (optional)
Pencil
Drill
Saber Saw
Level
Safety Glasses
Screws, 1" Flathead, Stainless
STUD LAYOUT:
The American Standard Acrylux Bathtub
will fit all standard 30" x 60" tub walls.
6030Y2A.102.XXX
6030Y2A.202.XXX
1"
14"
10"
25mm
19"
483mm
356mm
254mm
6"
152mm
31-1/2"
800mm
18"
457mm
Drain C
L
Floor Cut Out
6" x 10"
8"
203mm
(152 x 254mm)
59-7/8"
1521mm
60"
1524mm
30"
762mm
= stud location
LHO shown - Reverse for RHO
IMPORTANT:
• Allow tub to reach room temperature before installation.
• Read installation instructions carefully before starting project.
• Keep instructions for warranty information.
INSTALLATION INSTRUCTIONS
STEP 1. PREPARING ALCOVE
• Strip to bare studs.
• Alcove studs should be constructed as shown above.
• Floor must be clean, smooth, and level (check with level). Sub floor must
be installed as in the stud layout. Do not install tub on open floor joists.
• If required, cut hole in sub floor as shown above to accommodate drain.
STEP 2. INSTALLING TUB
• Trial fit tub in prepared alcove. With tub sitting flat on floor, check with
level on top of tub. Tub should be level from front-to-back and
side-to-side (Fig 1).
FIGURE 1. Check to assure tub is level.
• A floor leveling compound (smooth mortar) or a similar quick-setting
compound specifically made for leveling floors may be used to fully
support and level base.
• After tub is leveled, if alcove is larger than tub, shim between tub and
studs to create a tight fit. Screw tub flange to studs (Fig. 2).
CLEANING
• Do not use any abrasive cleaners or metal scrapers.
• If drywall mud or plaster gets on your shower, it may be carefully removed
with a wooden scraper made from a piece of scrap wood.
• Adhesive may be removed with mineral spirits.
®
®
• Ideal cleaners are Soft Scrub Gel or Comet Gel .
WARNING:
FIGURE 2. If necessary, shim between tub and studs
for tight fit and screw to each stud.
Some cleaning products are not suitable for use. Read all labels carefully.
DO NOT USE if they say “not suitable for use with ABS, acrylic, or polystyrene.
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c .
©
A S A m e r i c a , I n c . 2 0 0 8
754283-100 Rev. A
Download from Www.Somanuals.com. All Manuals Search And Download.
|