®
American DJ User Instructions
S-10S™
Single Channel Strobe Controller
Thank you for purchasing this
American DJ® product. For your con-
venience this strobe controller has
been tested and is ready to be used,
there is no assembly required.
Please read and understand the fol-
lowing instructions completely
before attempting installation or
Operating Instructions:
1. Be sure the input power matches
that of your unit and plug your unit
in.
2. Turn the power switch to on
position.
3. Select your desire control mode
(Flash/Stand-By/Audio)
using your new unit.
Flash Mode will allow you to manually adjust
the rate of the flash by turning the rate knob
in either a clockwise or counter-clockwise
position (Clockwise will increase the flash
rate and counterclockwise will decrease the
flash rate.
Caution! This apparatus must be
grounded. To prevent fire or electri-
cal shock, do not expose this appara-
tus under a high temperature or
humid area. There are no user ser-
viceable parts inside please do not
attempt any type of service or
repairs.
Stand-By mode is basically a black out mode
in this setting the strobe will not flash at all.
For all service issues please refer to
your authorized local American DJ
dealer
Audio mode will flash the strobe according to
beat detected by the controllers built-in
microphone.
Introduction:
Model: S-10S™
SPECIFICATIONS:
The S-10S™ is a single channel strobe
controller. It features three operating condi-
tions; Stand By (black out), Flash button,
Power: 110V-130V/60Hz
Weight: 2 lbs.
(manual), and Audio (sound active). This con-
troller also features a Variable Speed Control
Knob. The S-10S™ will control up to 6
American DJ® Super Strobe™, S150™, S-
100A™, and SNAPSHOT™strobes with 1/4”
mono cable.
Size:
6” x 2.5” x 2”
Sound Active
©
®
American DJ Supply -
Download from Www.Somanuals.com. All Manuals Search And Download.
|