OFFICE HEIGHT
Titan Drafting Tables
For WOB42, WOB48, WOB60,
WOB42-WA, and WOB48-WA
Assembly Instructions
Tools required: Phillips screwdriver, awl, or drill with 1⁄16" bit.
Parts Included:
B 1pc
C 1pc
F 2pcs
A 2pcs
Footrest Crossbar
(357⁄8" long)
Rear Crossbar
(347⁄8" long)
E 2pcs
D 1pc
Dust Cover
Adjustment Knobs
Tilt Adjustment Rods
G 2pcs
H 8pcs
I 20pcs
J 1pc
Side Frames,
Left & Right
Hinge Assemblies,
Left & Right
2" Allen Bolts
¾" Phillips Screws
Allen Wrench Key
To Assemble Base Frame
Unpack and inspect contents to confirm
1
you have all the parts listed above. Use
care to differentiate rear crossbar (
)
B
(34½" long) from footrest crossbar (
(35½" long).
)
C
Attach the rear crossbar ( ) and
B
2
footrest crossbar ( ) to one side frame
C
(
A
) using 2" Allen bolts ( ). Tighten
H
securely. Note: Threaded barrels
preattached to leg frames must be in
rear and facing out.
Attach other side frame ( ) to opposite
A
3
4
ends of crossbars in step two using 2"
Allen bolts ( ). Tighten securely.
H
Place dust cover ( ) over top of base
D
frame and attach using ¾" Phillips
screws ( ). Note: Wooden strip on dust
I
cover should be in front of table and
facing up.
Attach hinge assemblies ( ) to side
G
5
6
frames into pre-drilled holes using
Screw adjustment knobs ( ) into threaded barrels on each side frame. Set
¾" Phillips screws ( ) as shown in
E
I
7
8
adjustment rods so that connecting brackets are about 2" above side frames
for the time being with rods facing straight up and down and rear mounting
brackets facing out, as shown in diagram. Tighten knobs securely.
diagram. Pay close attention to correct
orientation of left and right hinges.
Tighten securely.
Base frame assembly is now complete. Set aside.
Insert tilt adjustment rods ( ) into
F
threaded barrels on each side frame.
Download from Www.Somanuals.com. All Manuals Search And Download.
|