R
ALPHASONIK
Owner's Manual
CAPACITOR
PCP15LDE
Download from Www.Somanuals.com. All Manuals Search And Download.
I
N
S
T
A
L
L
A
T
I
WARNING!!!
Before making or breaking any electrical connections, please
make sure to read the following instructions on how to properly
charge and discharge the capacitor. Not following the charge / dis-
charge instructions can lead to permanent damage to the capacitor,
which is not covered under the manufacturer warranty.
O
N
For maximum performance, the capacitor should be installed as close
to your amplifier(s) as possible. The ideal location is one which allows for
short wiring runs while keeping the capacitors somewhat isolated from
the heat created by the amplifier system. The positive (+) power wire
should be kept as short as possible and be connected to the amplifier’s
battery supply input. We recommend that a high performance distribution
block be used to create a splice into this cable (see Fig. 1). You may also
use the capacitor itself as a distribution block by adding multiple power
wires to the terminals located on the top of the capacitor.
No fuses should be installed in the wire between the capacitor and the
amplifier system (make sure there is an appropriate fuse at the battery
in the main power supply cable). The ground cable for the capacitor
should also be made as short as possible and be connected directly to
the vehicle chassis at a bare metal location. Do not grounf the capacitor
directly to the amplifier ground terminal or ground cable. The capcitor and
all other components in the system should be grounded using separate
ground cables. It is ok to ground them to the same point on the chassis or
frame, just not connected directly to eachother. (see Fig. 1) The positive
(+) and negative (-) wires for the capacitor should be the same gauge as
the amplifier’s power and ground cables.
Download from Www.Somanuals.com. All Manuals Search And Download.
3
I
Charging
After mounting the capacitor in its final position, attach the ground to the
capacitor and the chassis grounding location. Next hold the supplied bulb be-
tween the (+) positive battery lead and the (+) positive terminal of the capaci-
tor. If using a bulb, it should light up for a short time (normally 15-30 seconds
or so) and then go out. After waiting for the capacitor to charge, remove the
bulb or resistor and immediately attach the power (+) cable to the capacitor.
The best way to ensure the cap is charged best is to keep the bulb attached
until you touch the main power (+) wire to the capacitor, then remove it.
N
S
T
A
L
L
A
T
I
O
N
Discharging
If you plan to store your vehicle or plan on not using the system for a long
period of time, we suggest to remove the capacitor. Anytime you disconnect
the capacitor’s power wire from the battery, you need to properly discharge
the capacitor. This is done by using the same supplied bulb as you used for
charging the capacitor. Take the bulb and place the ends across the negative
(-) and positive (+) terminals of the capacitor. This will cause the capacitor to
safely discharge so it can be stored away.
Download from Www.Somanuals.com. All Manuals Search And Download.
3
W
A
R
N
I
Investigate the layout of your vehicle thoroughly before drilling or cutting.
Take care when you work near the gas tank, gas lines, hydraulic lines, electri-
cal components and electrical wiring. Do not use the equipment unmounted.
Attach this system securely to prevent damage, particularly in the event of an
accident or aggressive driving. Do not mount the system so that wire con-
nections are unprotected or are subjected to pinching or damage from nearby
objects. Before connecting or disconnecting power connections at the system
power terminals, disconnect the +12V DC wire at the battery end. Confirm
that your source unit and other equipment are turned off while connecting the
input terminals. If you need to replace the power fuse, replace it only with
a fuse identical to the provided fuse. Using a fuse of different type or rating
may result in damage to the system, which is not covered by the manufac-
turer’s warranty. Do not install any product where it may be subjected to
excessive heat, moisture and dust or where it may be repeatedly kicked,
brushed or bumped. Make absolutely sure that the terminals for the products
are connected to the proper inputs and outputs from the music source. Never
run the wiring on the outside of the vehicle or under it where it can be dam-
aged by road hazards or any moving parts of the vehicle. Use existing wire
channels, sills, panels and molding strips inside the vehicle to hide the wiring
N
G
A
N
D
D
I
S
C
L
A
I
for safety and a neat appearance.
M
E
R
DISCLAIMER
IMPORTANT: Never cut any metal that is an integral part of the vehicle’s
safety or structural support system. If you are unsure, it is best to have the
product professionally installed by an Authorized Alphasonik Dealer. Never
sacrifice your safety for sound.
Download from Www.Somanuals.com. All Manuals Search And Download.
4
W
A
R
R
A
N
T
Alphasonik, Inc. warrants this product against all defects in material and
workmanship for a period of one (1) year from the date of original purchase
provided it was purchased from an Authorized Alphasonik, Inc. Dealer.
The conditions of this warranty and the extent of the responsibility of Alpha-
sonik, Inc. under this warranty are as follows:
Y
1. DATED PROOF OF PURCHASE IS REQUIRED FOR WAR-
RANTY SERVICE OF THIS PRODUCT. Information about Alphasonik, Inc.
or by contacting or writing Alphasonik, Inc. at the address listed on the back
of this booklet.
2. This warranty will become void if service is performed by
any one other than an approved Alphasonik, Inc. Warranty Service Center.
3. This warranty does not apply to any product which has
been subjected to misuse, neglect or accident, or which has had the war-
ranty seal broken, serial number altered, defaced or removed, or which has
been connected, installed adjusted or repaired other than in accordance with
the instructions furnished by Alphasonik, Inc.
4. This warranty does not cover car static, electrical interfer-
ence, adjustments or labor costs for the removal or reinstallation of the unit
for repair.
5. The sole responsibility of Alphasonik, Inc. under this war-
ranty shall be limited to the repair or replacement thereof, at the sole discre-
tion of Alphasonik, Inc.
6. If it becomes necessary to send the product or any defec-
tive part to Alphasonik, Inc. or an authorized service station, the product
must be shipped in its original or equivalent carton, fully insured, with ship-
ping charges prepaid. Alphasonik, Inc. will not assume any responsibility for
any loss or damage incurred in shipping.
Download from Www.Somanuals.com. All Manuals Search And Download.
5
W
A
R
R
A
N
T
7. This warranty is not transferable and protects the original
purchaser provided they reside and made their purchase in the United
States. International consumers may contact their local retailer or distributor
for warranty information.
8. ALL IMPLIED WARRANTIES, EXCEPT TO THE EXTENT
PROHIBITED BY APPLICABLE LAW, SHALL HAVE NO GREATER DURA-
TION THAN THE WARRANTY PERIOD SET FORTH ABOVE. UNDER NO
CIRCUMSTANCES SHALL ALPHASONIK INC. BE LIABLE FOR ANY LOSS
OR DAMAGE, DIRECT OR CONSEQUENTIAL, ARISING OUT OF THE
USE OR INABILITY TO USE THE PRODUCT. BECAUSE SOME STATES
DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY
LASTS OR EXCLUSIONS OR LIMITATIONS OF INCIDENTAL OR CONSE-
QUENTIAL DAMAGES, THE ABOVE LIMITATIONS OR EXCLUSIONS MAY
NOT APPLY TO YOU.
9. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS
AND YOU MAY ALSO HAVE OTHER RIGHTS THAT VARY FROM STATE
TO STATE.
10. Should you have any difficulties with the performance of
this product during warranty or with any Alphasonik, Inc. authorized service
center, you may contact the Alphasonik, Inc. National Service Manager at
the address listed on the back of the booklet card or call 714.670.8950 for a
listing of Authorized Warranty Service Centers in your area.
Y
C
O
N
T
I
N
U
E
D
INSTALLED WARRANTY
(When purchased from and installed by an Authorized Alphasonik, Inc.
Dealer)
Speaker and Accessories: 1-year over-the-counter defective exchange plus
1-year repair or replacement at the sole discretion of Alphasonik, Inc.
Electronics: 1-year over-the-counter defective exchange, plus 1-year repair
or replacements at the sole discretion of Alphasonik, Inc.
An Alphasonik Extended Warranty Registration Card must be submitted to
Alphasonik, Inc. within 30 days of purchase. To process any warranty claim,
Alphasonik, Inc. will require the dated proof of purchase, which must specifi-
cally show the model and serial number and that installation was provided
for the product in question. All other terms per Alphasonik, Inc.’s standard
one-year warranty apply.
Download from Www.Somanuals.com. All Manuals Search And Download.
6
ALPHASONIK INC.
7050 VILLAGE DRIVE BLDG. G
BUENA PARK, CALIFORNIA. 90621
TEL: (714)670-8950 · FAX: (714)670-8959
Download from Www.Somanuals.com. All Manuals Search And Download.
|