Vandal Resistant Sub Station with built in Color Pinhole Camera
for use with AX, IE, TC-M, or TD-H Systems
- INSTRUCTIONS -
The IE-SSV is a 2-gang stainless steel vandal proof and weather resistant sub station designed for use with the
systems listed above. It is constructed of 12 gauge stainless steel and has a stand alone color camera built in. The
unit either flush mounts into a 2-gang box, or surface mounts using the SBX-2G. Each unit includes a 12V DC power
supply for the camera, tamper proof screws, and a tool for installation.
INSTALLATION:
1. For flush mounting, install sub station in standard 2-gang electrical box with minimum 2-1/2" depth.
2. For surface mounting, use the SBX-2G surface mount enclosure (sold separately).
3. Only the 12V DC power supply included should be used to power the IE-SSV camera.
4. IMPORTANT! These units are designed for use in normal weather conditions, and to allow drainage and
evaporation of moisture that naturally gets into the unit. Do not apply caulking or silicone sealant around the
unit when installing, and do not use weather stripping around the perimeter of the box when mounting. If
sealing the unit is required, the bottom must remain unsealed. Sealing the unit will prevent or inhibit moisture from
dissipating from inside the unit, which may cause corrosion or deterioration of the internal components over time.
Front View
Back View
Camera
Speaker
Red Lit
Call button
Microphone
45cm
18”
50cm / 20”
67cm
26½”
50cm
20”
The view achieved if the subject is 20" from the
camera is: 18" Vertically and 26½” Horizontally
Transparent corner shadowing
on the picture is normal.
Page 1
Download from Www.Somanuals.com. All Manuals Search And Download.
WIRING DIAGRAMS: (cont’d)
AX System with pinhole camera being viewed on AX-8MV master, using AXW-AZ:
AXW-AZ
CEU
IE-SSV
LINE
Red
Blk
D1
E1
VIDEO IN
Standard CCTV
Monitor
Video output to monitor
or CCTV system (Yellow)
Full time video out to
standard monitor or DVR.
VIDEO OUT
12V DC power input for camera
(Red - Must use supplied transformer)
SENSOR
NC
NC
RELAY
NO
NO
AX-8MV
Plug into a Door Station input (RJ-45 jack)
PS-2420UL’s
AX-084C pictured
TD-H/B Selective Calling Handset System:
TD-H Masters:
TD-3H/B
TD-6H/B
TD-12H/B
TD-24H/B
DE-UR
TD-H Master
IE-SSV
C
1
2
1*
~
24
C
D
+
Red
Blk
* Connect to desired
station number, 1 ~ 12.
PS-1225UL
Video output to monitor
or CCTV system (Yellow)
D
+
-
12V DC power input for camera
(Red - Must use supplied transformer)
+
-
-
Page 3
Download from Www.Somanuals.com. All Manuals Search And Download.
IE-SSV BACK VIEW:
Red connector for 12V DC camera
power input (from included power supply)
Power supply dimensions:
1-⅝" W x 2-¼” H x 1-⅝” D
6' DC cord.
Yellow BNC connector for
video output
Color Camera
Call Button
Speaker
Microphone
Red:
Black:
D1 on AXW-AZ or IE Master, 1 on DE-UR
E1 on AXW-AZ or IE Master, 2 on DE-UR
SPECIFICATIONS:
Audio Power Source:
Supplied by master station
Speaker:
Baffle protected, water proof and puncture resistant, 2.4 oz. magnet
Microphone:
Baffle protected ECM
Call Button:
SPST limited stop button, momentary activation.
Call Annunciation:
Press button on sub and master rings. Chime tone on IE masters and ring tone on AX master for duration
set in system programming.
Communication:
Video Output:
Hands free at sub. IE master is handset, AX master is push-to-talk, release-to-listen or VOX.
75 Ohm / 1Vp-p composite video
Iris Control:
Auto
Minimum Illumination:
Camera image sensor:
Focal Length:
1.0 lux
1/3" CCD
3.7mm Cone Pinhole Lens
Effective Pixels:
Camera Power Source:
Faceplate:
510(H) x 492(V) NTSC
12V DC, 100mA (via included power supply)
12 gauge stainless steel
Mounting:
Flush mount into a 2-gang box (minimum 2-½” depth) or surface mount into SBX-2G (sold separately)
Tamper proof screws included (6x32 for use with flush 2-gang box) with T-10 TORX bit
When using SBX-2G, use the hardware included with that unit.
Color-coded prewired pigtails. Red wire = “D1 or 1"; Black wire = “E1 or 2”
Red connector = 12VDC power; Yellow connector = 75 Ohm / 1Vp-p video output (BNC).
Terminations:
Operating Temperature: 14 F ~ 140°F (-10°C ~ 60°C)
Audio Wiring:
2 conductor shielded cable is recommended. Use Aiphone #822202 or #821802.
Audio Wiring Distance:
Video Wiring:
See system that unit is being used with for distance specifications.
Independent BNC connection from substation pigtail to destination video device.
Dimensions (H x W x D): IE-SSV alone: 4-11/16" x 4-11/16" x 2"
With SBX-2G: 4-3/4" x 4-7/8" x 3-5/8" (Top) 2-3/8" (Bottom)
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
(425) 455-0510
TOLL FREE TECHNICAL SUPPORT: (800) 692-0200
TOLL FREE FAX LINE: (800) 832-3765
E-MAIL: [email protected]
Pg. 4
IE-SSV Instr.
0307JD
FAX (425) 455-0071
Download from Www.Somanuals.com. All Manuals Search And Download.
|