ADDONICS TECHNOLOGIES
Model: AD5SAHPM-E
Installation Guide
Front View
SiI4726 Manager Utility Installation
Note:
If you are configuring RAID sets or individual drive,
you need to install the SiI4726 Manager utility to
configure and monitor the RAID sets. Install the
utility from the CD that came with your package.
Port 5
Port 4
Port 3
Port 1
Port 2
1. Turn computer ON. Insert Driver Disk into CDROM.
2. The Addonics Technologies Driver Disk window pops
up.
3. Select SATA RAID Utilities. Go to: Other SATA RAID
Utilities link located on the bottom right of the Driver
Disk window. To extract the utility select your operating
system from the list.
eSATA Port
4. Extract the files into your system.
5. Install SiI4726 Manger by clicking the setup.exe.
Follow the instructions.
6. After software installation, turn your system off.
Side View
The SATARAID Utility Manual can found in the Driver Disk
under User Guides or can be downloaded from
ntroller/SiI476 Manager User Manual.pdf
4-Pin Floppy
Power Connector
Note: Independent drive configuration is only supported with
controllers with Silicon Image SiI3124 or SiI3132 chip set or
using the Addonics eSATA-USB adapter.
When the hardware port multiplier is connected to a SATA
Host controller with SiI3124 or SiI3132 chip, in the RAID
BIOS of the host controller, you will only see one drive and
that is the drive connected to port 1 on the hardware PM.
All the SATA drives connected to the hardware PM will show
in the SiI4726 Manager.
Jumper LED connections
TECHNICAL SUPPORT
Addonics Technologies
2466 Kruse Drive
Phone: 408 433-3899
Fax: 408 433-3898
San Jose CA 95131
Initial RAID configuration is programmed by connecting the
hardware port multiplier to:
Email:
Internet:
·
one of Addonics SATA controllers that has SiI3124 or
SiI3132 chip set.
Technical Support (8:30 am to 6:00 pm PST)
·
USB 2.0 connection (optional Addonics eSATA-USB
adapter is required)
Phone:
408 433-3855
Email:
Download from Www.Somanuals.com. All Manuals Search And Download.
|