Accusplit Fitness Electronics AE1700 SERIES User Manual

DISPLAY MODES  
step: STEP mode shows your step count  
since last reset, up to 100,000 steps.  
mi: DISTANCE mode (1740, 1790 only)  
shows distance walked or jogged since  
last reset.  
9789  
ACCUSPLIT AE1700 Series Pedometer  
kcal: CALORIE mode (1790 only) shows  
calories burned through step activity  
since last reset.  
(AE1720, AE1740, AE1790)  
Red:  
MODE  
Blue:  
SET  
White:  
RESET  
INSTRUCTIONS  
(1740, 1790  
only)  
AM/PM: CLOCK mode (1790 only)  
shows time of day.  
Congratulations on taking the first step to wellness  
with your purchase of an ACCUSPLIT pedometer.  
Its easy to set up your new pedometer.  
ACTIVITY TIMER MODE shows total activity time in minutes and  
seconds since last reset. The timer runs automatically whenever steps  
are being recorded.  
Just follow the steps below, and start walking!  
SETTING UP YOUR PEDOMETER  
To record your distance and calories accurately, you  
will need to set your stride length and body weight.  
Attaching the Leash: Attach the pedometer to the  
First, loop the  
pedometer leash slot  
leash by looping the leash through the pedometer  
leash slot. Next, loop the leash through the metal  
clip. Finally, clasp the waistband of your clothing  
with the metal clip. You can also use a safety pin  
to fasten the leash to your clothing, loop the  
leash through your belt or belt loop, or use a  
badge holder.  
Next, loop the metal  
clip, then clasp clothing  
Finding Your Stride Length (1740, 1790 only): Your  
stride length is the length of one of your steps,  
measured from “toe to toe.” To measure, walk  
10 steps with your normal stride and measure the  
TOTAL DISTANCE from the toe of your starting step  
to the toe of your 10th step (see diagram below).  
Divide the TOTAL DISTANCE by 10, and multiply  
the decimal portion by 12 to find your stride length  
in feet and inches. Example: If you walk 23 feet in  
10 steps, your stride length is 2.3 feet. Multiply  
0.3 x 12 = 4. Your stride length is 2 feet, 4 inches.  
VIEWING YOUR RESULTS  
Once you put on your pedometer with the cover  
closed, it will automatically begin to record your  
steps, distance (1740, 1790 only), calories burned  
(1790 only), and activity time. Repeatedly press the  
red MODE button to cycle through the pedometer  
modes:  
Or, loop a  
badge holder,  
then put into pocket  
(Badge holder  
Or, loop a belt or belt loop  
not included)  
Setting Your Stride Length (1740, 1790 only):  
Repeatedly press the red MODE button until “mi”  
appears. Press the blue SET button once to enter  
setting mode. Display will shift to show stride, in  
feet and inches. Press and hold down the blue  
SET button to increase stride length. Press the  
red MODE button to exit setting mode.  
STEP DISTANCE CALORIE CLOCK →  
ACTIVITY TIMER STEP  
their step counts tend to be a bit too high, or too low.  
All AE1700 models come with a sensitivity adjust-  
ment, to help account for individual differences.  
The adjustment switch has three positions: “+,” “-,”  
and center. The adjustment switch is located on  
the bottom of the pedometer, on the right-hand side  
when looking from the front.  
RESETTING YOUR PEDOMETER  
Most people prefer to reset step, distance, and  
calorie counts daily. To reset: From STEP, DISTANCE,  
or CALORIE mode, press and hold the white RESET  
button for at least 2 seconds.  
Note: Pressing the white RESET button resets  
stride length to 2' 0".  
Adjustment Procedure: Take 100 steps, then check  
STEPS display to see how many steps were actually  
counted. Repeat once to make sure results are  
about the same. If the pedometer counts fewer  
steps than you actually walked, slide the sensitivity  
adjustment towards the “+” icon. This will increase  
recorded steps by about 10%. If the pedometer  
counts more steps than you actually walked, slide  
the sensitivity adjustment towards the “-” icon. This  
will decrease recorded steps by about 10%.  
REPLACING THE BATTERY  
Setting Your Weight (1790 only): Repeatedly press  
the red MODE button until “kcal” appears. Press  
the blue SET button once to enter setting mode,  
then press and hold the blue SET button to increase  
weight (in pounds). Press the red MODE button to  
exit setting mode.  
When the display starts to dim or goes blank, it is  
time to replace the battery. Your pedometer uses  
one Type L1142 (LR43) 1.5 volt silver oxide battery.  
To replace:  
1. Insert a coin into the slot on the front of the  
case, and twist counterclockwise to loosen  
the battery door.  
Note: Pressing the white RESET button resets  
weight to 120 lbs.  
2. Remove battery door and take out the old  
battery. Replace it with a new battery. The  
battery’s positive (+) terminal should be  
FACE UP while you put it into the pedometer.  
Setting the Clock (1790 only): Repeatedly press  
the red MODE button until “AM” or “PM” appears.  
Press the white RESET button. The dash will stop  
flashing. Press and hold down the red MODE button  
until the correct hour is displayed; release button.  
Press and hold down the blue SET button until the  
correct minutes are displayed; release button.  
Press the white RESET button to exit setting mode.  
The dash will begin flashing. The clock is now set.  
WEARING YOUR PEDOMETER  
While gently holding the belt clip open, slide the  
pedometer onto your belt or the top edge of your  
pants or skirt. It should fit snugly and level, above  
one knee.  
Note: The pedometer should be as vertical as  
possible. Walkers with larger stomachs may find it  
helpful to wear the pedometer farther back on the  
body, toward one hip. The cover must be closed for  
the pedometer to work. To avoid losing or dropping  
your pedometer, use the included leash and clip to  
fasten the pedometer securely to your clothing.  
3. Put the battery door back on and twist the  
coin clockwise to tighten.  
Eat Right! Walk More! Live Well!  
e ACCUSPLIT Lifetyle  
Adjusting your Pedometer’s Measurement  
Sensitivity AE1700 pedometers are highly accurate  
step counters. However, some walkers may find that  
10 steps  
ACCUSPLIT, Inc. • 2290M Ringwood Ave. • San Jose, CA 95131  
800-965-2008 • 925-226-0888 • FAX 925-463-0147 • www.ACCUSPLIT.com • [email protected]  
970-049  
Download from Www.Somanuals.com. All Manuals Search And Download.  

3M Barcode Reader 390G User Manual
12Volt Air Compressor 12V6CF User Manual
Acnodes Computer Hardware MPC 6171A User Manual
Alesis Car Amplifier 12R User Manual
Alliance Laundry Systems Washer Accessories 802715 User Manual
Alpine CD Player CDA W560EG User Manual
Alpine Stereo Amplifier cda 9805 User Manual
AO Smith Water Heater ACGSS02407 User Manual
Apple Network Router U10C012 User Manual
Asus Network Card CRW 5224A U User Manual