Accusplit Fitness Electronics 1590 User Manual

ACCUSPLIT®  
EAGLE1590  
OPERATING INSTRUCTIONS  
PEDOMETER  
DISPLAY MODES  
• STEP: STEP mode shows your  
step count since last reset, up  
to 100,000 steps.  
Congratulations on taking the first step to wellness with your  
purchase of an ACCUSPLIT pedometer. It’s easy to set up your  
new pedometer. Just follow the steps below, and start walking!  
• DIST: DISTANCE mode shows  
distance walked or jogged since  
last reset.  
SETTING UP YOUR PEDOMETER  
WEARING YOUR PEDOMETER  
• CAL: CALORIE mode shows  
calories burned through step  
activity since last reset.  
To record your distance and calories  
accurately, you will need to set your stride  
length and body weight.  
While gently holding the belt clip open, slide  
the pedometer onto your belt or the top edge  
of your pants or skirt. It should fit snugly and  
level, above one knee.  
Note: The pedometer should be as vertical  
as possible. Walkers with larger stomachs  
may find it helpful to wear the pedometer  
farther back on the body, toward one hip.  
The cover must be closed for the  
: CLOCK mode shows time of day.  
Finding Your Stride Length: Your stride  
length is the length of one of your steps,  
measured from “toe to toe.” To measure,  
walk 10 steps with your normal stride and  
measure the TOTAL DISTANCE from the  
toe of your starting step to the toe of your  
10th step (see diagram below). Divide the  
TOTAL DISTANCE by 10. This is your stride leash and clip to fasten the pedometer  
length. Example: If you walk 22 feet, your  
stride length is 2.2 feet.  
: ACTIVITY TIMER MODE  
shows total activity time in minutes  
and seconds since last reset. The  
timer runs automatically whenever  
steps are being recorded.  
pedometer to work. To avoid losing or  
dropping your pedometer, use the included  
• SCAN MODE: Rotates between  
showing steps, distance, calories  
and activity time.  
securely to your clothing.  
Current mode  
arrow indicator  
Attaching the Leash: Attach the pedometer  
to the leash by looping the leash around  
the pedometer belt clip. Next, clasp the  
waistband of your clothing with the attached  
clip. You can also use a safety pin to fasten  
Setting Your Stride Length: Press the  
black MODE button until arrow at the top  
of display points to “DIST.” Press the gray  
SET button once to enter setting mode.  
CAL DIST  
STEP  
S
C
A
N
ACTIVITY  
Display will shift to show stride (for example, the leash to your clothing, or loop the leash  
PEDOMETER  
“F 1.95” means stride is set to 1.95 feet).  
Press the gray SET button to increase stride  
length. Press the yellow RESET button to  
decrease stride length. Press the black  
MODE button to exit setting mode.  
through your belt or belt loop.  
TW15G  
1590  
ACCUSPLIT EAGLE  
First, loop the  
pedometer clip  
SET  
RESET  
(2S)  
MODE  
Next, loop the metal  
clip, then clasp clothing  
Yellow:  
RESET  
Black:  
MODE  
Gray:  
SET  
Setting Your Weight: Press the black  
MODE button until arrow at the top of the  
display points to “CAL.” Press the gray SET  
button once to enter setting mode. Display  
will shift to show weight in pounds. For  
example, “L 165” means weight is set to 165  
lbs. Press the gray SET button to increase  
weight setting. Press the yellow RESET  
button to decrease weight setting. Press  
black MODE button to exit weight setting  
mode.  
AUTO MOVEMENT SENSOR  
1. To lter out random movements, the  
unit remains in standby mode until  
5 continuous steps are registered.  
Only then are the 5 steps calculated  
in, and an Active indicator “”  
Or, loop a  
appears on the upper left of display.  
badge holder, then  
2. When regular walk/run movement  
stops, after 2 seconds the timer  
pauses and the unit switches to  
standby status (Active indicator “”  
disappears).  
put into pocket  
(Badge holder  
not included)  
Or, loop a belt or belt loop  
Setting the Clock: Press the black MODE  
button until the arrow on the top of display  
points to clock icon . Press the gray SET  
button once to enter clock setting mode,  
clock readout will flash. Press the yellow  
RESET button to advance hours. Press the  
gray SET button to advance minutes. Press  
black MODE button to exit clock setting  
mode.  
VIEWING YOUR RESULTS  
Once you put on your pedometer with the  
cover closed, it will automatically begin to  
record your steps, distance, calories burned,  
and activity time. Repeatedly press the  
black MODE button to cycle through the  
pedometer modes:  
STEPS DISTANCE CALORIES →  
TIME OF DAY ACTIVITY TIMER →  
SCAN STEPS  
RESETTING YOUR PEDOMETER  
Most people prefer to reset step, distance,  
and calorie counts daily. To reset: From  
STEP, DISTANCE, or CALORIE mode,  
press and hold the yellow RESET button  
for at least 2 seconds.  
Note: display will show “A” for AM and  
“P” for PM.  
10 steps  
ACCUSPLIT, Inc. • 2290M Ringwood Ave. • San Jose, CA 95131  
800-965-2008 • 925-226-0888 • FAX 925-463-0147 • www.ACCUSPLIT.com • [email protected]  
970-046  
Download from Www.Somanuals.com. All Manuals Search And Download.  

ACR Electronics Marine GPS System 2897 User Manual
Advantech Computer Hardware AIMB 766 User Manual
AGFA Camcorder 500 X User Manual
Airlink101 Network Card AWLL3026 User Manual
Alliance Laundry Systems Washer 1305 User Manual
Alpine CD Player CDA 7897 User Manual
Alpine Innovation Stereo Receiver 800i5e SMP User Manual
American Standard Outdoor Shower 7225703 User Manual
Apple Network Card Grr User Manual
BB Electronics Network Card 3PXCC1A User Manual