C 1000S
Condenser Microphone
Description
The AKG Model C 1000 S gradient condenser microphone
uses a low noise pre-polarized backplate (electret) and is
ideal for a variety of recording and sound reinforcement
applications. Its polar pattern can be quickly converted from
cardioid to hypercardioid by placing an acoustical converter
over the end of the microphone capsule; this has virtually no
effect on the on-axis response of the microphone. The on-
axis response of the C 1000 S has a gentle (-6 db/octave)
roll-off below 200 Hz which has been tailored for the normal
close-in use of cardioid and hypercardioid microphones in
studio recording and sound reinforcement applications. The
microphone may thus be used in close-in application with no
need for further equalization. The C 1000 S may be powered
by a 9-volt battery or by phantom powering over a range
from 9 to 52 Vdc. The included PPC 1000 Polar Pattern
Converter allows quick changeover from cardioid to
hypercardioid. A silent on/off switch is recessed to prevent
inadvertent shut-off. The included Presence Boost Adapter
piece PB 1000 creates an emphasis of the higher frequencies
from 5 to 9 kHz by about 3 to 5 dB, which not only improves
the transmission of sibilances but may be also advantageous
when recording instruments requiring greater high frequency
content in their audio spectrum.
Specifications
Transducer Principle: Gradient pre-polarized
condenser
Frequency Response: 50–20,000 Hz (see family of
Features
response curves)
Polar Pattern:
Cardioid or hypercardioid
• Extended low and high frequency
response, tailored for close
Equivalent Noise Level: 20 dB-A
^
Sensitivity at 1,000 Hz: 6 mV/Pa = -45 dBV
Sound Pressure Level at 1% THD:
proximity to sound sources
137 dB (145 dB for 3% THD)
• Operates on 9 volt battery or
phantom power (9 to 52 Vdc)
• High acoustic level capability
(137 dB-SPL for 1.0 % THD)
S/N Ratio (A-weighted): 74 dB
Electr. Impedance:
Load Impedance:
Power Requirement:
≤ 200 ohms
≥ 2,000 ohms
Phantom powering, nominal
9-52 Vdc or 9 V battery
• PPC 1000 – Polar Pattern Converter
from cardioid to hypercardioid polar
pattern
• PB 1000 – Presence Boost Adapter
for increased intelligibility +3 to 5 dB
at 5 to 9 kHz
Connector:
Finish:
3-pin XLR type
Matte dark gray metallic enamel
Size:
Dia 1.3 in. (39 mm),
Length 8.7 in. (220 mm)
Net/Shipping Weight: 9.7 oz. (276 g)/1.8 lbs. (820 g)
Included Accessories: SA 43 Stand adapter
W 1000 Windscreen,
PPC 1000 Polar pattern converter
PB 1000 Presence boost adapter
Optional Accessories: N 62 AC Power supply
Download from Www.Somanuals.com. All Manuals Search And Download.
|