HeatSeal™
H520
G
F
D
I
O
E
P
T
K
c
Instruction Manual
Manuel d’utilisation
Bedienungsanleitung
Manuale d’istruzioni
Gebruiksaanwijzing
Manual de instrucciones
Manual de Instruções
Kullanım Kılavuzu
Οδηγίες
Brugsvejledning
FI
o
Käyttöopas
NO
o
Bruksanvisning
S
Q
o
Bruksanvisning
Instrukcja obsługi
Návod k obsluze
Használati útmutató
CZ
H
RUS
o
Руководствo по
зкcплyатации
Download from Www.Somanuals.com. All Manuals Search And Download.
2
3
1
5
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Specifications
GBC HeatSeal H520
Electrical
230V / 50Hz / 2.5A / 600W
Machine Dimensions
Machine Weight
550 x 190 x 114mm
6.3kg
Maximum Pouch Width
Minimum/Maximum Pouch Thickness
Maximum Thru-put Thickness
Warm-Up Time (2 x 75 mic)
Speed
320mm
2 x 75 mic (Total 150) / 2 x 175 mic (Total 360)
1mm
5 minutes
800mm per minute
Safety instructions
Important safeguards
m
m
YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS IMPORTANT
TO ACCO BRANDS EUROPE. IN THIS INSTRUCTION MANUAL AND ON
THE PRODUCT ARE IMPORTANT SAFETY MESSAGES. READ THESE
MESSAGES CAREFULLY.
WARNING: FOR YOUR PROTECTION DO NOT CONNECT
THE POUCH LAMINATOR TO ELECTRICAL POWER UNTIL
YOU READ THESE INSTRUCTIONS COMPLETELY. KEEP
THESE INSTRUCTIONS IN A CONVENIENT LOCATION FOR
FUTURE REFERENCE. TO GUARD AGAINST INJURY, THE
FOLLOWING BASIC SAFETY PRECAUTIONS MUST BE
OBSERVED IN THE SET-UP AND USE OF THIS PRODUCT.
m
THE SAFETY ALERT SYMBOL PRECEDES EACH SAFETY
MESSAGE IN THIS INSTRUCTION MANUAL.
m
THIS SYMBOL INDICATES A POTENTIAL PERSONAL
SAFETY HAZARD THAT COULD HURT YOU OR OTHERS,
AS WELL AS CAUSE PRODUCT DAMAGE OR PROPERTY
DAMAGE.
General safeguards
• Use the unit only for its intended purposes of laminating documents.
THIS WARNING IS FOUND ON THE PRODUCT.
• Do not place anything in the throat opening of the laminator other than
pouches/documents.
WARNING
cm
Electrical shock hazard.
• Place unit on a secure, stable work area to prevent the unit from
falling and possibly causing personal injury and damage to the unit.
Do not open. No user
servicable parts inside.
Refer servicing to qualified
service personnel.
• Follow all warnings and instructions marked on the unit.
• The socket outlet shall be installed near the equipment and shall be
easily accessible.
• Do not block the vent slots, this will cause the laminator to overheat.
This safety message means that you could be seriously hurt or killed if
you open the product and expose yourself to hazardous voltage.
• Never insert the loose end of the pouch first into the machine. This
could cause the machine to jam.
• Never attempt to do single sided lamination. This will cause the
machine to jam.
Special notice
• After laminating run a clean card through the machine to clean glue
residue off of the rollers. This will extend the life of the rollers.
Thank you, for your recent purchase of a GBC Pouch Laminator. Your
new laminator may emit a slight odour during the initial stage of
operation. It is normal and will diminish after several hours of operation.
Electrical safeguards
Cleaning
• The unit must be connected to a supply voltage corresponding to the
electrical rating shown on the unit.
Caution: Unplug this product before cleaning.
m• Wipe exterior only with a damp cloth. Do not use detergents
or solvents.
• Unplug the unit before moving it, or when it is not in use for an
extended period of time.
• Do not operate with a damaged supply cord or plug. Do not alter the
attachment plug. The plug is configured for the appropriate electrical
supply.
• Do not use aerosol dusters or cleaners
• Do not spray anything into the product, foreign substances
can be explosive.
• Do not overload electrical outlets beyond their capacity; fire or
electrical shock could result.
• The unit is intended for indoor use only.
Service
• Do not spill liquid of any kind on this product.
• Do not attempt to service or repair the pouch laminator yourself.
Unplug the unit and contact an authorised ACCO Brands Europe
service representative for any required repairs.
• Close supervision is required when this product is used near children.
Download from Www.Somanuals.com. All Manuals Search And Download.
ꢀ
G
Operation, hot lamination
Operation, cold lamination
1
1
Connect the power cord plug to the appropriate power source.
Connect the power cord plug to the appropriate power source.
2
3
2
3
4
Push the power button to “ON” position, the LCD display will
illuminate.
Push the power button to “ON” position. The LCD display will
illuminate (fig.1).
Using the lamination guide located on the machine (fig.1), select the
appropriate temperature setting for the pouch gauge thickness and
material you are laminating using the Up/Down Arrow keys.
The LCD display will automatically default to the “0” * Temp.
position.
Follow the instructions included with your GBC self adhesive
laminate or other pressure sensitive, non thermal laminating
pouches.
Temperature Setting Guidelines
When laminating thin paper with light ink coverage, set the temperature
dial to the low end of the film gauge range. Thick paper with heavy ink
coverage requires higher settings within the range. Temperature settings
will vary due to the finish, chemistry and heat absorption properties
of the material being laminated. If the laminated pouch is cloudy after
the first pass through the machine, adjust the temperature to the next
higher position and run it through again. If waviness occurs, reduce the
temperature to the next lower position. Always allow sufficient time for
the laminator temperature to adjust to the changes made to the settings.
Reverse feature
In the event of a misfeed or a jam follow these instructions.
1
Press the reverse button
and hold down (fig.5). This will reverse
the rotation of the rollers allowing the pouch to exit the front of the
machine.
4
When the laminator has reached the correct lamination temperature
the countdown to ready will indicate “Ready” 0 minutes on the LCD
display.
2
3
Pull the document out of the laminator.
After the document is out of the machine clean the rollers by
running the cleaning sheet through the laminator.
5
Centre the item to be laminated within the pouch left to right with
the top edge against the sealed edge of the pouch (fig.2).
Caution: Use caution when removing the laminated pouch
from the machine. It may be hot.
6
7
Insert the pouch with the sealed edge first into the machine (fig.3).
m
The laminated item will automatically exit at the rear of the machine.
After the pouch has stopped moving, carefully remove from the
machine and place on a cool flat surface for approximately one
minute for cooling (fig.4).
8
If you are finished laminating push the power switch to turn the
machine off.
Guarantee
Operation of this machine is guaranteed for two years from date of
purchase, subject to normal use. Within the guarantee period, ACCO
Brands Europe will at its own discretion either repair or replace the
defective machine free of charge. Defects due to misuse or use for
inappropriate purposes are not covered under the guarantee. Proof
of date of purchase will be required. Repairs or alterations made by
persons not authorised by ACCO Brands Europe will invalidate the
guarantee. It is our aim to ensure that our products perform to the
specifications stated. This guarantee does not affect the legal rights
which consumers have under applicable national legislation governing
the sale of goods.
Register this product online at www.accoeurope.com
Download from Www.Somanuals.com. All Manuals Search And Download.
ꢁ
New details to
be advised.
Service
G
ACCO Service Division
Freepost 193, Hereward Rise, Halesowen, West Midlands, B62 8AN.
N
I
Sannum & Stang
Gladengveien 16 0661 Oslo.
Tel: +4722685940, Fax: +4722686730, e-mail: [email protected]
ACCO UK Sales International
Oxford Road, Aylesbury, HP21 8SZ.
Tel: 00 44 1296 397444, Fax: 00 44 1296 311000
ACCO Italia Spa
Via Nenni 13, Settimo Torinese (TO) Via Regio Parco 10B/bis.
Tel: 011 896 11 11, Fax: 011 896 11 12
IRE
F
O
B
D
ACCO France
o
ACCO-Rexel Ltd
Clonshaugh Business & Technology Park, Clonshaugh Dublin 17.
Tel: 01 816 4300, Fax: 01 816 4302
Service Aprés-Vente, 8 Rue du 19 Mars 1962, 21601 Longvic, Cedex BP7/ZI.
Tel: 0802 872 356, Fax: 03 80 68 60 49
ACCO Benelux
Peppelkade 64, 3992AK Houten.
Q
S
ACCO Polska Sp. z o.o.
Al-Jerozolimskie 184, 02-486 Warszawa.
Tel: +42 22 570 18 01, Fax: +48 22 570 18 33
ACCO Benelux (Technische Dienst)
Peppelkade 64, 3992AK Houten, Nederland.
ACCO Nordic Region
Kontor 1, i norden AB Kanalvägen 16 194 61 Upplands Väsby.
Tel: 08 444 5191, Fax: 08 444 5199
FI
o
ACCO Deutschland
H ATernl:o+ld4s9tra-s7s1e851,/7838671-146S0c,oFranxd:o+rf4,9Ge-r7m1a8n1y./887-165
Somen Huoltopalvelu oy
Kanaamouka 1 00360 Helsinki. Tel: 956 050 510, Fax: 956 050 500
RUS
o
E
CZ
o
A
S
XERTEC a.s.
P AIsCaaCcOPIebrearli1a9S, L28820 Coslada (Madrid). Tel: 91 669 9391, Fax: 91 672 07 11
U Továren 770/1b, 102 00, Praha 10.
g
Oddi
Höfdabakka 3-7 IS-112 Reykjavik. Tel: 00354 515 5000, Fax: 00354 515 5101
ACCO Österreich
Sallmann Bürotechnik GmbH, Esshaverstrasse 16, 5020 Salzburg.
Tel: 0662 4345 160, Fax: 0662 4345 164, e-mail: [email protected]
T
Eraysan
Ankara Cad N.129, Sirkeci, Istanbul.
Tel: 0090 212 6591686, Fax: 0090 212 5226992, [email protected]
ACCO Schweiz
AUS
o
ACCO Australia Pty.
Level 2 Building B, 8 Lord Street, Botany. NSW. Australia 2019.
Tel: 2 9700 0180, Fax: 2 9700 0195
ABC Bürotechnik AG, Winkelbüel 4, 6043 Adligenswil.
Tel: 041 375 6060, Fax: 041 375 6061,
e-mail: [email protected]
c
Mailtech
Baldersbaekvej 8B 2635 Ishoj.
Tel: 045 43 73 37 37, Fax: 0045 43 73 73 37 07, e-mail: [email protected]
ACCO Brands Europe
Oxford House
Aylesbury HP21 8SZ
United Kingdom
Ref: H520/5278
Issue: 1 (03/07)
Download from Www.Somanuals.com. All Manuals Search And Download.
|