3M Water Dispenser CFS01 User Manual

3M Water Filtration Products  
Installation and Instruction Manual For:  
CFS01 Series, CFS02 Series,  
CFS11 Series, and CFS12 Series Housings  
Installer: Please leave this manual with owner/operator.  
Owner/Operator: Please retain for operation and future maintenance instructions.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
SAFETY INFORMATION  
Read, understand, and follow all safety information contained in these instructions prior to installation and use  
of the CFS Series Housings. Retain these instructions for future reference.  
Intended Use:  
The CFS Series Housings are intended for use in filtering potable water in the foodservice industry and have not been  
evaluated for other uses. These systems are typically installed at the point-of-entry, and must be installed as specified in  
the installation instructions.  
EXPLANATION OF SIGNAL WORD CONSEQUENCES  
Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury and/or  
property damage.  
WARNING  
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury and/or  
property damage.  
CAUTION  
Indicates a potentially hazardous situation, which, if not avoided, may result in property damage.  
CAUTION  
WARNING  
To reduce the risk associated with choking:  
Do not allow children under 3 years of age to have access to small parts during the installation of this product.  
To reduce the risk associated with the ingestion of contaminants:  
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.  
To reduce the risk associated with hazardous voltage due to an installer drilling through existing electric wiring or water  
pipes in the area of installation:  
Do not install near electric wiring or piping which may be in path of a drilling tool when selecting the position to mount the  
filter bracket.  
To reduce the risk of physical injury:  
• Depressurize system as shown in manual prior to cartridge removal.  
CAUTION  
To reduce the risk associated with property damage due to water leakage:  
• Read and follow Use Instructions before installation and use of this system.  
• Installation and Use MUST comply with all state and local plumbing codes.  
Protect from freezing, remove filter cartridge when temperatures are expected to drop below 40°F (4.4°C);  
• Do not install on hot water supply lines. The maximum operating water temperature of this filter system is 100°F (37.8°C).  
Do not install if water pressure exceeds 125 psi (862 kPa). If your water pressure exceeds 80 psi (552 kPa), you must install a pressure  
limiting valve. Contact a plumbing professional if you are uncertain how to check your water pressure.  
Do not install where water hammer conditions may occur. If water hammer conditions exist, you must install a water hammer arrester.  
Contact a plumbing professional if you are uncertain how to check for this condition.  
Do not use a torch or other high temperature sources near filter system, cartridges, plastic fittings or plastic plumbing.  
• On plastic fittings, never use pipe sealant or pipe dope. Use PTFE thread tape only, pipe dope properties may deteriorate plastic.  
• Take care when using pliers or pipe wrenches to tighten plastic fittings, as damage may occur if overtightening occurs.  
Do not install in direct sunlight or outdoors.  
Do not install near water pipes which will be in path of a drilling tool when selecting the position to mount the bracket.  
• Mount filter in such a position as to prevent it from being struck by other items used in the area of installation.  
• Ensure that the location and fasteners will support the weight of the system when installed.  
• Ensure all tubing and fittings are secure and free of leaks.  
• The disposable filter cartridge MUST be replaced every 6 months or at the rated capacity or if a noticeable reduction in flow  
rate occurs.  
IMPORTANT NOTES  
• Failure to follow instructions may void warranty.  
• Allow a minimum of 2” (5 cm) clear space under filter to facilitate cartridge change.  
• Install with the inlet and outlet ports as labeled. Make sure not to reverse connections.  
• The filter system may be used with metallic or non-metallic piping systems.Any non-metallic fittings used for the installation must be  
of adequate rating for the line pressure.  
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
Procedure for Installing Filter:  
Your new CFS Series Housing is designed to reduce particulate matter and/or chlorine taste and odor, depending  
upon the cartridge used.  
The CFS01 and CFS02 Series filter systems come with internal shut-off valves in the filter head, eliminating the need  
for external valves. The CFS11 and CFS12 Series filter systems require an external shut-off valve installed before the  
system. All housings have either a transparent (T) housing or an opaque (S) sump. Both housing styles come with  
3/4” NPT ports. Part number 6873231 is a mounting bracket and 3/4 x 1/2 reducing bushings, which are not sup-  
plied with models CFS11 and CFS12 Series. It must be ordered separately.  
Filter System Assembly:  
1. Turn off incoming water supply.  
IMPORTANT NOTES  
If bracket is provided, mount bracket onto filter head. Use mounting holes provided to mount system to a wall or support  
structure.  
For those systems with internal shut-off valves, turn the valve on the filter head to “OFF” position.  
2. Connect the incoming cold water supply to the filter system’s inlet water connection.  
3. Connect the outlet port of the system to the outlet water line.  
4. After all connections are complete, install cartridge, referring to the cartridge replacement instructions, if neces-  
sary.  
5. Turn on incoming water to the system.  
IMPORTANT NOTES  
For those systems with internal shut-off valves, turn the valve on the filter head to the “ON” position. Pressurize system.  
Check for leaks. Retighten connections if necessary. It is recommended that the unit be flushed for a maximum of 5  
minutes in order to remove entrapped air and carbon fines (if activated carbon cartridges are used).  
6. System is now ready for service.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Cartridge Replacement Instructions  
CAUTION  
To reduce the risk associated with property damage due to water leakage:  
• The disposable filter cartridge MUST be replaced every 6 months or at the rated capacity or if a noticeable reduction in flow  
rate occurs.  
1. Turn off incoming water supply.  
IMPORTANT NOTES  
For those systems with internal shut-off valves, turn the valve on the filter head to “OFF” position.  
For those systems with external shut-off valves, depress the pressure relief button on top of filter head to relieve pres-  
sure in filter.  
2. Unscrew sump from filter head. Empty water from sump and dispose of spent cartridge.  
3. Clean and inspect all components, including the o-ring seal. Lubricate o-ring seals with a light coating of food grade  
lubricant. Replace o-ring if there is visible damage.  
4. Install new cartridge(s) into sump (over center post in a two high unit).  
5. Screw sump into head until sump becomes snug and cartridge is sealed. HAND TIGHT IS SUFFICIENT. The use of a  
wrench for tightening is not recommended and may result in damage.  
6. Turn on incoming water supply.  
IMPORTANT NOTES  
For those systems with internal shut-off valves, turn handle to “ON” position. Wait until the filter is filled with water and  
check for leaks. Open and close the valve once to release trapped air.  
For those systems with external shut-off valves, depress pressure relief button on filter head until air is purged from  
system.  
Flush new cartridge for 5 minutes prior to service.  
Replace cartridge when there is a decided drop in water flow at faucet or tap or line pressure downstream of filter  
system drops below 20 psi (138 kPa). Do not leave valve in the “OFF” position for an extended period of time or use as a  
substitute for main water line valve.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Cartridge Selection Guide  
The CFS01/CFS11 Series and the CFS02/CFS12 Series are designed to use only 3M Water Filtration Products  
replacement cartridges. Use of replacement cartridges other than those specified below may seriously compromise  
water quality and/or cartridge life.  
Replacement Cartridges for CFS01 and CFS11 Series Housings  
Sediment  
Model No. Part No.  
Micron  
Description  
Uniform density sediment reduction  
Graded density  
Capacity  
N/A  
CFS8504-A  
55847-03  
56212-05  
56121-11  
10  
25  
5
CFS124  
N/A  
CFS110  
Sediment reduction  
N/A  
Chlorine Taste and Odor  
Model No. Part No.  
Micron  
Description  
Capacity  
10,000 gal. @ 2 gpm  
(37,854 lit. @ 7.6 lpm)  
CFS117  
CFS117-S  
CFS186-A  
55593-04  
5
Granular activated carbon  
Granular activated carbon  
built-in scale inhibition  
10,000 gal. @ 2 gpm  
(37,854 lit. @ 7.6 lpm)  
55594-12  
5
5
10,000 gal. @ 1.67 gpm  
(37,854 lit. @ 6.3 lpm)  
FSCTOB10N  
Ultra carbon block  
Sediment/Scale  
Model No. Part No.  
Micron  
Description  
Capacity  
Graded density design  
built-in scale inhibition  
CFS420IMF  
55609-04  
5
N/A  
Replacement Cartridges for CFS02 and CFS12 Series Housings  
Sediment  
Model No. Part No.  
Micron  
Description  
Capacity  
(2)  
55847-05  
CFS8504-B  
10  
Uniform density sediment reduction  
N/A  
(2)  
56212-05  
CFS124  
25  
5
Graded density  
N/A  
N/A  
(2)  
56121-11  
CFS110  
Sediment reduction  
Fine Silt Reduction  
Model No. Part No.  
Micron  
5 Absolute  
10 Absolute  
Description  
Fine silt reduction cartridge  
Capacity  
N/A  
CFSFSR-5  
55603-20  
CFSFSR-10  
55603-21  
Fine silt reduction cartridge  
N/A  
Chlorine Taste and Odor  
Model No. Part No.  
Micron  
Description  
Capacity  
(2)  
20,000 gal. @ 4 gpm  
(75,708 lit. @ 15.1 lpm)  
55593-04  
CFS117  
5
Granular activated carbon  
(2)  
Granular activated carbon  
built-in scale inhibition  
20,000 gal. @ 4 gpm  
(75,708 lit. @ 15.1 lpm)  
55594-12  
CFS117-S  
5
5
(2)  
20,000 gal. @ 3.34 gpm  
(75,708 lit. @ 12.6 lpm)  
FSCTOB10N  
CFS186-A  
Ultra carbon block  
See PDS sheets for stated NSF claims.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
CFS11 & CFS12 Head Assembly:  
6981401C  
O-ring: 63597210C  
Mounting Bracket: 6873231  
Housing, 1-high, opaque (S): 6981131C  
Housing, 1-high, transparent (T): 6981142  
Housing, 2-high, opaque (S): 6981133  
Housing, 2-high, transparent (T): 6981141  
CFS01 & CFS02 Head Assembly:  
6981502  
Center Post: 6981731 (2 high only)  
Wrench: 68434-32  
O-ring: 63597210C  
Housing, 1-high, opaque (S): 6981131C  
Housing, 1-high, transparent (T): 6981142  
Housing, 2-high, opaque (S): 6981133  
Housing, 2-high, transparent (T): 6981141C  
Center Post: 6981731 (2 high only)  
Wrench: 68434-32  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Limited Warranty  
CUNO Incorporated warrants this Product (excluding disposable filter cartridge(s)) to be free from defects in material and  
workmanship for ten (10) years from the date of purchase. The disposable filter cartridge is warranted from defects in  
material and workmanship for a period of one (1) year from the date of purchase. This warranty does not cover failures  
resulting from abuse, misuse, alteration or damage not caused by CUNO or failure to follow installation and use instruc-  
tions. If the Product is defective CUNO will replace the Product or refund your Product purchase price. CUNO will not be  
liable for any indirect, special, incidental, or consequential damages arising from the use of this Product. Some states do  
not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you.  
To obtain warranty service, mail your request to Warranty Claims, CUNO Incorporated, 400 Research Parkway, Meriden, CT  
06450. Proof of purchase (original sales receipt) must accompany the warranty claim, along with a complete description  
of the Product, model number and alleged defect. This warranty gives you specific legal rights and you may have other  
rights which vary from state to state, or country to country.  
a 3M company  
CUNO Incorporated,  
a 3M Company  
400 Research Parkway  
Meriden, CT 06450, USA  
Toll Free: 1.888.218.CUNO  
Worldwide: 203.237.5541  
Fax: 203.238.8701  
© 2008 3M Company. All rights reserved.  
3M is a trademark of 3M Company.  
CUNO are trademarks of 3M Company used under license.  
Isoplast is a trademark of the Dow Chemical Company.  
INSTR4075 0608  
Download from Www.Somanuals.com. All Manuals Search And Download.  

3M Water System NWS100 User Manual
Aastra Telecom Laptop REV 06 User Manual
Accton Technology Network Router VG3300 Series User Manual
Air King Fan AK55L User Manual
Allied Telesis Switch VERSION 543 26 User Manual
Alpine CD Player CDA 7839 User Manual
Amana Convection Oven AMC7159TAB0 User Manual
American Dryer Corp Clothes Dryer AD 575 User Manual
American Standard Furnace Gas Furnaces User Manual
Barco Computer Monitor MFGD 2320 User Manual