MCD 268
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
Pull out the plastic
protective sheet
before use.
USB/AUX
DIM
A/V cord (R/W/Y)
Stand
Remote Control
2
User Manual
Quick Start Guide
1
FM wire antenna
Quick start guide
User manual
Setting the clock
1
In standby mode, press and hold CLOCK on the system.
2
When the hour digits flash, press VOLUME-/+ (VOL+/- on the remote control) to set the
hours.
3
Press CLOCK again and the minute digits flash.Then press VOLUME-/+ (VOL+/- on the
remote) to set the minutes.
4
Press CLOCK again to confirm the time setting.
Setting DVD menu options
IMPORTANT!
If the progressive scan feature is activated but the connectedTV does not support progressive
signals or the cables are not connected accordingly, see the user manual for proper progressive
scan setup or deactivate the progressive scan feature as below:
1)Turn off yourTV progressive scan mode or turn on to interlaced mode.
2) Press SYSTEM MENU on the remote to exit the system menu and then DISC and “1” to exit
progressive scan.
ANALOG AUDIO SETUP
DIGITAL AUDIO SETUP
PICTURE SETTING
HDMI SETUP
3D
DIVX (R) VOD
USB/AUX
DIM
Tip
See chapters "Preparations" and "System
Menu Options" in the User Manual for
detailed descriptions.
Playing a disc
1
e
i
Pr
Insert a disc into the slot loader.
S
i
n
d
e
t
➜ Make sure the label side is facing you.
➜ Make sure you have removed any other disc from the slot loader.
2
Playback will start automatically. If not pressÉÅ.
3
To stop playback, press 9.
Programming and tuning to radio stations
1
Press SOURCE (TUNER on the remote control) to select tuner source.
2
Press PROGRAM on the remote control for more than two seconds to program all available stations in order of
waveband.
3
Press PRESET ¡ / ™ until the desired preset station is displayed.
Playing a USB mass storage device
With the Hi-Fi system, you can use USB flash memory (USB 2.0 or USB1.1),
USB flash players (USB 2.0 or USB1.1), memory cards (requires an additional card reader to
work with this Hi-Fi system).
1
Insert the USB device’s USB plug into the socket
on the set.
2
IMPORTANT!
Slide down to
expose some
Press SOURCE once or more to select USB (or USB/AUX on the remote control).
buttons and jacks on
the front panel!
3
Play the USB’s audio files as you do with the albums/tracks on a CD,
Tip
Detailed playback features and additional functions are
described in the accompany owner's manual.
PDCC-JS/JW-0810
|