Wall mount without a telephone stand
Cord connections
2
1
2
Desk mount option
Route line cord through the
stand.
1
Press here to remove
the stand.
T7100 Telephone User Card
Connect line cord to
wall jack.
Slide feature card plate
down.
Connect line cord to
wall jack.
Connect cords to the
telephone, refer to
“Cord connections”
illustrations.
Connect cord
to handset.
Place the telephone onto the
wall mount plate and slide it
down.
1-800-4 NORTEL
© 2003 Nortel Networks
P0605068 01
Wall mount with a telephone stand
Printed in Canada
3
1
Press here to remove
the stand.
Mount the stand as shown.
A
Your T7100 telephone
A
Telephone light
B
Flashes for incoming calls. Lights up when Message
Waiting Indication (MWI) is supported by system software.
Contact your system administrator for more information.
F
B
C
Adjustable display
Shows the time and date, call and feature information.
C
D
G
Connect cords to the telephone,
refer to “Cord connections”
illustrations.
2
® Release button
Ends an active call or feature.
Use the key hole slots
on the stand to mark
the location for the
screws. Tighten screws
for a secure fit.
H
Adjust the display
to your personal
preference.
D
E
Dial pad
4
√ Volume control
Adjusts the handset and ringer volume.
E
I
F
≤ Feature button
Starts or ends a feature.
Mount the telephone
onto the screws and
slide it down.
G
≥ Hold button
Places calls on hold.
Write your extension
number on this card.
H
I
Memory button
Connect line cord
to wall jack.
key hole slots
Feature card plate
Storage compartment for your feature card.
|