Cooking Hobs
VITROCERAMIC
Index
GB
GB
English
Instructions for use
Installation, 4
Use, 4
Maintenance, 4
Instructions for the installater
Installation, 6
Positioning, 6
Electrical connection, 6
Heating elements, 6
Assistance, 7
THIS APPLIANCE IS CONCEIVED FOR
DOMESTIC USE ONLY.THE MANUFACTURER
SHALL NOT IN ANY WAY BE HELD
RESPONSIBLE FOR WHATEVER INJURIES
OR DAMAGES ARE CAUSED BY INCORRECT
INSTALLATIONORBYUNSUITABLE,WRONG
OR ABSURD USE.
C320IX
Dear customer,
We thank you and con-gratulate you on your
choice. This new carefully de-signed product,
manu-facturedwiththehighestqualitymaterials,
has been carefully tested to satisfy all your
cooking demands.We would therefore request
you to read and follow these easy instructions
which will allow you to obtain ex-cellent results
right from the start. May we wish you all the
very best with your modern appliance!
THE MANUFACTURER
3
GB
Fig.3
Fig.4
Fig.4a
5
Instructions for the installer
The earth connection is compulsory in terms of the law.
Installation
GB
Should there be no cable andlor plug on the equipment, use
suitable absorption material for the working temperature as
well,asindicatedonthematrixplate.Undernocircumstance
must the cable reach a temperature above 50°C of the
ambient temperature. lf connecting directly to the mains
power supply, fit a multi-pole switch of a suitable size for the
rated capacity with a clearance distance which completely
disconnects the power line under overvoltage category
III conditions, consistently with the rules of installation (the
yellow/green earth wire must not be interrupted).
These Instrnctions are for the qualified technician, as a
guide to the installation, adjustment and maintenance,
according to the laws and standards in force. Any of these
operations must always be canied out when the appliance
has been disconnected from the electric system.
Positioning (Fig. 4-4a)
The appliance can be fitted into a working area as
illustrated on the figure. Apply the seal supplied over the
whole perimeter of the working area.
The plug or omnipolar switch must be easily reached on
the installed equipment.
N.B.: - The manufacturers dedine any responsibility in
the event of non-compliance with what is described
above and the accident prevention norms not being
respected and followed.
Electrical connection (Fig. 5)
Prior io carrying out the electrical connection, please ensure that:
- the plant characteristics are such as to follow what is indicated
on the matrix plate placed at the bottom of the working area;
- that the plant is fitted with an efficient earth connection,
following the standards and law provisions in force.
To avoid all risk,if the power cable becomes damaged,
it must only be replaced by the manufacturer, by
an authorised service centre, or by a qualified
electrician.
HEATING ELEMENTS
V
TYPE
single-circuit radiant
single-circuit radiant
W
REGULATION
energy regulator
energy regulator
Ø 145
1200
1700-1900
0+11
0+11
~ 230 V
Ø 180 - Ø 195
H05RR-F3x1.5
Fig.5
6
Assistance
Before contacting After-Sales Service:
GB
1. See if you can solve the problem yourself.
2. Switch the appliance on again to see if the problem
has been solved. if it has not, disconnect the
appliance from the power supply and wait for about
an hour before switching on again.
3. If the problem persists after this course of action,
contact After-Sales Service.
Specify:
• the nature of the fault,
• the model
• the service number (the number after the word
SERVICE on the rating plate on the rear of the
appliance)
• your full address,
• your telephone number and area code.
Never call on unauthorized technicians and always
refuse to purchase non-original spare parts.
The manufacturer declines all responsibility for possible inaccuracies contained in this pamphlet, due to printing or
copying errors.We reserve the right to make on our own products those changes to be considered necessary or useful,
without jeopardizing the essential characteristics.
7
GB
8
Notes
9
|