Gateway AMI 493 User Manual

Update...  
AMI 493 RAID controller firmware  
update and drive installation  
If you add a new hard drive to an existing array that has an  
AMI 493 controller (firmware version B147 or older), the  
Power Console Plus software will scan the drive in a  
continuous loop.  
To remedy this situation, do one of the following:  
Use the interim solution to install a new drive, perform  
a migration, or create a new array.  
- OR -  
Update the controller firmware to version B148 or greater.  
The firmware update is located on the technical support  
Important  
If the firmware is not available, perform the interim solution.  
Interim solution:  
1 Turn off the server.  
2 Install the new hard drive.  
3 Turn on the server.  
4 During the server startup procedure, press CTRL+H to open  
the WebBIOS utility and perform the RAID migration or  
create another array for the new drive.  
5 When done, exit WebBIOS, then reboot the server.  

Hitachi Computer Monitor 42PMA300A User Manual
Frigidaire FITS MORE COOKTOP FPGF3081K F User Manual
ELSA Erazor II User Manual
Cypress CY7C1514JV18 User Manual
Cypress CY7C1157V18 User Manual
Cannon C50GCIS User Manual
Atlantis Land A05 17BM L04 User Manual
Asus Computer Hardware M3N HT User Manual
Acnodes APW 5400 User Manual
3M MP8030 User Manual