TM
™
JP938BC/CC/SC/WC—GE Profile 30" Built-In CleanDesign Electric Cooktop
Counter Installation (in inches)
Cooktop Dimensions (in inches)
KW Rating
240V
8.1
6.1
20-7/8**
29-3/4**
Cooktop
3-1/4*
208V
13" MAX.
depth
Breaker Size
28-1/8
19-3/8
†
40 Amps
†
Note: Check local codes for required breaker size
19-5/8
Note: If installing with a GE Profile Performance™ or GE Profile™ Telescopic Downdraft
System, consult both cooktop and downdraft installation instructions packed with product
before installing. Cooktop gas/electric supply may need
30" MIN. to
unprotected
cabinet
1-1/2" MIN.
clearance to
side wall
18" MIN.
to cabinet
28-1/2
1-3/4" to
rear wall
from cut-out
to be re-routed to install downdraft.
Note: Consult cabinet and countertop manufacturer’s specs for flush mount installation
prior to install.
2-1/2"
Installation Information: Requires a 5" free area between the bottom of the
Required
cooktop to any combustible material, i.e., shelving. Free area not required when installing wall
oven underneath cooktop. Refer to installation instructions. Requires an 18" minimum from
cooktop to adjacent overhead cabinets. Units are furnished with a 48" flexible armored cable.
*Depth of unit at conduit location (rear) is 6-1/4"
1-3/4" MIN.
clearance to
side wall
**Stainless steel cooktop dimensions are
29-7/8" (width) and 21" (depth)
Before installing, consult installation instructions packed with product for current
dimensional data. 36" Ribbon cooktops are approved for use over GE 30" Single Wall Ovens
only. 30" Ribbon cooktops are approved for use over select GE 29" and GE 30" Single Wall
Ovens. Refer to cooktop and wall oven installation instructions packed with product for
current dimensional data.
from cut-out
Electrical junction
box 16" MIN.
below countertop
Cut should
not interfere
with cabinet
structure at
front
Filler Trim Kit
When replacing an old GE 30" cooktop (with larger opening) with Models
JP938/930/350/340, use the following one-piece trim kit to fill in the over-size hole.
Available at additional cost.
JXTR31W (True White)
JXTR31B (Black glass with black, white or bisque pattern)
Flush Mount Installation Kit
Accommodates both 30" and 36" installations. Not for use with stainless steel models.
JXFLMTW (True white glass)
JXFLMBB (Black glass with black, white or bisque pattern)
®
™
For answers to your Monogram, GE Profile or
GE appliance questions, visit our website at
WWW.GEAppliance.com or call
Listed by
Underwriters
Laboratories
R
®
Specification Revised 3/01
GE Answer Center service, 800.626.2000.
|