Dell™ E151FP Color Display
Quick Setup Guide
Safety Instructions
Observe the following safety guidelines when connecting and using your display:
•
•
•
Be sure that your display is electrically rated to operate with the AC power available in your location.
Locate your display near an easily accessible electrical outlet.
Place the display on a solid surface and treat it carefully. The screen can be damaged if dropped, sharply
hit, or touched with a sharp or abrasive implement.
•
•
Put your display in a location with low humidity and a minimum of dust.
Never use your display if the power cable has been damaged. Do not allow anything to rest on the power
cable, and keep the cable away from where people could trip over it.
•
•
Never insert anything metallic into the display openings. Doing so may create the danger of electric shock.
To avoid electric shock, never touch the inside of the display. Only a qualified technician should open the
display’s case.
•
•
Be sure to hold the plug, not the cable, when disconnecting the display from an electrical outlet.
Openings in the display cabinet are provided for ventilation. To prevent overheating, these openings
should not be blocked or covered. Also, avoid using the display on a bed, sofa, rug, or other soft surface.
Doing so may block the ventilation openings in the bottom of the cabinet. If you put the display in a
bookcase or some other enclosed space, be sure to provide adequate ventilation.
Do not expose the display to rain or use it near water. If the display accidentally gets wet, unplug it and
contact an authorized dealer immediately. You can clean the exterior of the display with a damp cloth
when necessary, but be sure to unplug the display first.
•
•
If your display does not operate normally—in particular, if there are any unusual sounds or smells coming
from it—unplug the display immediately and contact an authorized dealer or service center.
Connecting Your Display to a Computer
(A) Make sure that the computer and monitor’s power are both turned off. Please follow the steps to install
your LCD monitor.
Step 2. Connect the power cord to your
Step 3. Connect the VGA-Cable
Step 1. Pull the base out.
LCD monitor.
that is directly attached to the
monitor, to the VGA output of the
graphics card on the computer.
(B) Connect the power cord at the back of the monitor to an AC power socket. Please make sure that the
socket is not blocked or covered, so you can disconnect the unit from AC supply if you need to. Your
monitor is equipped with an automatic power supply for a voltage range from 100 to 240 Volt at a
frequency of 50 to 60 Hz. Be sure that your local power is within the supported range. If you are unsure,
ask your electricity supplier.
(C) Turn on your computer and display. If the display does not display an image, refer to the troubleshooting
section of this guide.
Dell E151FP Color Display Quick Setup Guide
1
Microsoft Windows 98 Operating System
Windows 98 automatically detects the new display and displays the Add New Hardware Wizard dialog box if
the display driver is not already installed.
1. Insert the display CD into the CD-ROM drive, and click Next> twice when the Add New Hardware Wizard
dialog box appears.
2. Click the CD-ROM drive box to install the drivers from the CD and then click Next>.
3. Confirm that the driver was found on the CD, and click Next> twice to install the driver.
4. Click Finish to exit the Add New Hardware Wizard dialog box.
To manually install or update the driver, perform the following steps:
1. Click StartÆ SettingsÆ Control Panel and then double-click Display.
2. In the Display Properties window, click the Settings tab, and then click Advanced.
3. Click the Monitor tab, and then click Change.
4. When the Update Device Driver Wizard dialog box appears, follow the steps in the previous paragraph.
Setting Display Resolution
For optimal display performance while using Microsoft® Windows® XP, Windows 2000, Windows 98, Windows
95 or Windows NT®, set the display resolution to 1024 X 768 as follows:
1. Click StartÆ SettingsÆ Control Panel.
2. Double-click the Display icon in the Control Panel window, and the click the Settings tab.
3. In the Desktop area, move the slidebar to 1024 by 768 pixels. Then click OK.
Accessing the User’s Guide Online or via CD
To view the latest display User’s Guide, access the SUPPORT section of the Dell Web site
If you do not have Internet access, you can access the guide on the display CD:
1. Insert the display CD into your CD-ROM drive.
A start-up document should launch automatically; however, if the start-up document does not launch
automatically, click StartÆ Run, type D:\monitor.htm, and click OK. (Substitute the correct CD-ROM
drive letter if it is not the D drive.)
2. Click the appropriate icon to open the User’s Guide in the desired language.
NOTE: All applicable warranty and regulatory information regarding your display is contained in the User’s
Guide on your CD.
Troubleshooting Tips
Display Has No Power
If the display’s power indicator is off and no image appears on the display, perform the following checks:
•
•
•
•
Ensure that the power cable is fully inserted in the display’s power port and the electrical outlet.
Test the electrical outlet by plugging in a working electrical device such as a lamp.
Ensure that the power button has been depressed, and wait for the power indicator to light.
Try another power cable on the display. Use the computer’s power cable and turn on the display with the
signal cable disconnected. If the display is working correctly, a self-test pattern appears.
No Image Is Displayed on the Display
If the display power indicator is on but no image appears on the display, perform the following checks:
•
Ensure that the video connector is seated properly. Tighten the connector screws securely with your
fingers.
•
•
•
•
Ensure that the computer is on.
Increase brightness and contrast controls.
Turn off the display and unplug the signal cable. Check the cable connector for bent or broken pins.
With the signal cable still disconnected, turn on the display. If the display is working correctly, a self-test
pattern appears.
•
Perform a display reset or recall.
Dell E151FP Color Display Quick Setup Guide
3
IMPORTANT!
Before contacting Dell for technical assistance, refer to the Troubleshooting section in the User’s Guide on
your display CD. This section contains detailed information for resolving most display problems.
____________________________________
Information in this document is subject to change without notice.
2001 Dell Computer Corporation. All rights reserved.
Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly
forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Computer Corporation; Microsoft
and Windows are registered trademarks of Microsoft Corporation.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the
marks and names or their products. Dell Computer Corporation disclaims any proprietary interest in trademarks
and trade names other than its own.
November 2001
4
Dell E151FP Color Display Quick Setup Guide
|