DR30GS, DR30GFS, DR30GIS, DR3GIFS
Document # PG05-007
Revised 09/13/12 Page 1/4
™
Distinctive 30” Wide
PLANNING
GUIDE
All Gas Ranges
warning
Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
•
•
This appliance must be installed in accordance with the
accompanying installation instructions.
All tolerances ±1/16” (±1.6 mm) unless otherwise noted.
45 9/16” (115.7 cm)
Front of open door
Front of knobs
NOTE: Neither version is
compatible with a raised vent.
28 9/16” (72.5 cm)
26 1/8” (66.4 cm)
24” (61.0 cm)
Front panel
Rear of front
1 1/8” (2.9 cm)
Ba
9” (22.9 cm)
Backguard
Grates extend
1” above trim
6” (15.2 cm)
backguard*
7.6 cm)
ackguard*
1 3/4” (4.4 cm) backguard*
See table for compatibility
*�
External handle
shown, some models
have integral handle
ls
35”
(88.9 cm)
to
37”
(94.0 cm)
F]S:
8.3 cm)
al stainless
el side panels
(removable)
Product width:
29 7/8” (75.9 cm)
OvERALL DEPth DImENSIONS - SIDE vIEW
Part number
Description
Compatibility
Standard on models DR30GIS, DR30GIFS
Optional on models DR30GS, DR30GFS
AER30GLBG
AERB30G03
AERB30G06
AERB30G09
Low profile (1 3/4 inch)
Optional on models DR30GS, DR30GFS
NOT compatible with models DR30GIS, DR30GIFS
3 Inch
6 Inch
9 Inch
Standard on models DR30GS, DR30GFS
NOT compatible with models DR30GIS, DR30GIFS
Optional on models DR30GS, DR30GFS
NOT compatible with models DR30GIS, DR30GIFS
AvAILAbLE bAckGUARDS
All specifications subject to change without notice.
Phone: (800) 793-0093
DR30GS, DR30GFS, DR30GIS, DR3GIFS
Document # PG05-007
Revised 09/13/12 Page 3/4
Distinctive 30” Wide
All Gas Ranges
PLANNING
GUIDE
SELF-RImmING INStALLAtION cUtOUt OPtIONS (mODELS DR30GIS AND DR30GIFS ONLy)
All tolerances +1/16” (+1.6 mm), -0 unless otherwise noted.
For all self-rimming installations:
Countertop height: 34 3/4” (88.3 cm) min.
36 7/8” (93.7 cm) max.
Countertop thickness: 1 5/8” (4.1 cm) max.
10” min. (25.4 cm)
Non-combustible
10” min. (25.4 cm)
to any combustibles
above counter both sides
*
Rear wall or
3/4” min. (1.9 cm)
countertop overhang
to any combustibles
rear wall required
*
countertop edge
above counter both sides
21”
(53.3 cm)�
to
24”
(61.0 cm)
21 1/8”
(53.7 cm)
20 3/4”
(52.7 cm)
25 5/8”
max.
(65.1 cm)
29 1/4” (74.3 cm)
25 3/4”
(65.4 cm
max
20 7/8”
(53.0 cm)
countertop opening
4.3 cm)
pening
to
30” (76.2 cm)
cabinet opening
below countertop
24 1/8”
(61.3 cm)
cm)
opening
countertop
Notch countertop
to width of cabinets
Cabinet face
below countertop
tch countertop
width of cabinets
Cabinet face
below countertop
t
cAbINEtS LESS thAN 24” DEEP, 3 1/4” SIDE
INStALLED, RANGE bAck FLUSh tO WALL (
cAbINEt DEPth GREAtER thAN 24” **
3 1/4” SIDE PANELS INStALLED, RANGE bAck
OvERhANGING cOUNtERtOP (tOP vIEW)
10” min. (25.4 cm)
No
to any combustibles
above counter both sides
10” min. (25.4 cm)
to any combustibles
above counter both sides
*
Rear wall or
3/4” min. (1.9 cm)
Countertop overhang
countertop edge
29 1/4” (74.3
29 1/4” (74.3 cm)
24”
(61.0 cm)
countertop ope
24 1/8”
(61.3 cm)
countertop opening
30” (76.2 cm)
cabinet opening
below countertop
Cabinet face
below countertop
Notch countertop
overhang to width of
cabinets
30” (76.2 cm)
cabinet opening
below countertop
Cabinet face
below countertop
Notch countertop
overhang to width of
cabinets
Countertop overhang
1 5/8” (4.1 cm) max.
Countertop overhang
1 5/8” (4.1 cm) max.
cAbINEt ExActLy 24” DEEP, 3 1/4” SIDE PANELS
REmOvED, RANGE bAck FLUSh tO WALL (tOP vIEW)
cAbINEt DEPth GREAtER thAN 24” **
3 1/4” SIDE PANELS REmOvED, RANGE bAck
OvERhANGING cOUNtERtOP (tOP vIEW)
* On models DR30GIS and DR30GIS, non-combustible surface required immediately behind range, as specified on previous page, when back of
backguard is less than 2 1/2” (6.4 cm) from rear wall.
** Models DR30GIS and DR30GIS include self-rimming trim piece that attaches to back of range and covers the edge of the countertop overhang in back.
*** To create a “built-in look” on the front of the cabinet, this dimension may be changed to 29 1/4” (74.3 cm). This configuration is only for models
DR30GIS and DR30GIS with side panels behind door removed.
All specifications subject to change without notice.
Phone: (800) 793-0093
DR30GS, DR30GFS, DR30GIS, DR3GIFS
Document # PG05-007
Revised 09/13/12 Page 4/4
Distinctive 30” Wide
All Gas Ranges
PLANNING
GUIDE
12
(3
6’ (183 cm)
long
12” (30.5 cm)
2 1/2”
(6.4 cm)
1” (2.5 cm)
3 1/2”
(8.9 cm)
4 1/4”
(10.8 cm)
UtILIty cLEARANcE bEh
bAck OF RANGE
ELECTriCaL r
gaS SUPPLY PrESSUrE rEQUirEMEnTS
Electrical Circuit
gas
Manifold
Min. gas Supply
Max. input
required
Type
Pressure* (wC)
Pressure (wC)
Pressure
120 Vac, 60 Hz, 15 Amps.,
dedicated, grounded
. @
, 60 Hz
Natural
LP
5”
6”
1/2 psi
1/2 psi
10”
11”
iMPOrTanT: The information above is for reference only. If the above
data does not agree with the product data label, use the data on the
product data label.
The gas inlet on the regulator accommodates a 1/2” NPT gas line
connection. The range can also accommodate a 3/4” NPT gas line
connection by removing the 1/2” to 3/4” adapter on the regulator inlet.
All specifications subject to change without notice.
Phone: (800) 793-0093
|