INSTALLATION INSTRUCTIONS
THIS KIT IS UL APPROVED TO ALLOW CERTAIN MICROWAVE OVENS TO BE INSTALLED ABOVE CERTAIN CONVENTIONAL/CONVECTION WALL OVENS.
PLEASE SEE THE OPERATION MANUAL REGARDING BUILT-IN APPLICATIONS.
IF YOUR LOWER CONVENTIONAL OVEN IS NOT LISTED IN THE OPERATION MANUAL OR THE INSTALLATION INSTRUCTIONS OF THE MICROWAVE OVEN
AS AN APPROVED MAKE AND MODEL, THEN DO NOT INSTALL THE MICROWAVE OVEN IN ANY AREA WHERE HEAT AND STEAM ARE GENERATED; FOR
EXAMPLE, NEXT TO OR ABOVE A CONVENTIONAL RANGE OR ABOVE A CONVENTIONAL WALL OVEN.
Microwave Oven: DCM24
Lower Oven: EO127, EO130, MOV127, MOH127, MOV130, MOH130, PO127, PO130
Do not build-in above any other gas or electric wall oven.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING INSTALLATION!
• Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the Built-in Kit.
Remove the turntable from the oven cavity.
• Because the kit includes metal parts, due caution should be used in handling and installation to avoid the possibility of
injury.
• Do not remove permanently affixed labels, warnings or plates from the product. This may void the warranty.
• Please observe all local and national codes and ordinances.
• The installer should leave these instructions with the consumer who should retain for local inspector’s use and
for future reference.
1 FRONT FRAME
6 DUCT-A1: QTY 1
ASSEMBLY: QTY 1
7 DUCT-A2: QTY 1
2�BOTTOM DUCT:
8 DUCT-A3: QTY 1
QTY 1
9 DUCT-B: QTY 1
3�SCREW-A (1/2"
LENGTH): QTY 10
4�SCREW-B (1 3/4"
! DUCT-C: QTY 1
LENGTH): QTY 4
5�SCREW-C (1 3/16"
LENGTH): QTY 2
CORD BOX: QTY 1
1
Figure 4
Figure 5
SCREW-A
DUCT-A3
DUCT-A2
SCREW-A
SCREW-A
SCREW-A
DUCT-A1
SCREW-A
DUCT-A2
STEP 3 CORD BOX
1. Plug the oven electrical cord into the CORD BOX
RECEPTACLE and roll the remaining part of the cord into
the CORD BOX as shown in Figure 6-A.
Figure 6
6-A
CUSHION-A
2. Remove screw #2 from lower left rear of the oven. Insert
right flange of the CORD BOX into hold lip of the oven.
Using the screw #2 just removed from the oven, secure
the CORD BOX to the oven. See Figure 6.
CORD BOX
#2
STEP 4 INSTALLATION
1. Place oven on bottom duct and slide assembly partially
into cutout, leaving room to reach in and connect the cord
to the electrical outlet.
Figure 7
2. Slide the oven into place. Be sure the oven is placed at
the center of the opening.
SCREWS
BOTTOM
PLATE
CUSHION-B
3
STEP 5 FRAME INSTALLATION
Attach bottom duct with two SCREWS-C. Attach built-in
trim kit frame with four SCREWS-B. See figure 8.
Figure 8
SCREW-B
SCREW-C
SCREW-B
SCREW-B
SCREW-C
SCREW-B
OVER OVEN INSTALLATION
OVER WARMING OVEN INSTALLATION
TOP OF
MICROWAVE
SHELF
1 1/4
34
MICROWAVE
CUTOUT
MICROWAVE
CUTOUT
WARMING
OVEN CUTOUT
(ALL MODELS)
EPICURE,
PREFERENCE AND
MILLENNIA
SINGLE WALL
OVEN CUTOUT
RECOMMENDED
HEIGHT 36"
1440 Bridge Gate Drive • Diamond Bar, CA 91765
TINSEB423MRR0
4
|