CAPTM CUSTOMIZABLE MICROCONTROLLERS
AT91CAP7X-DK Development Kit
for CAP Customizable Microcontroller
The AT91CAP7X-DK development board implements the fixed portion of the AT91CAP7 device as a
microcontroller standard product, tightly coupled to a high-density FPGA that emulates the MP Block.
The boards also include a range of memories and physical in
external system components. This configuration enables paral
the application under development at close to operational speed
penalty for hardware modifications. This enables software devel
to proceed in parallel with hardware development, and sign
reduces the design cycle time, increasing confidence in a right-fi
system solution.
The AT91CAP7X-DK development board or “kit” is composed o
associated boards, namely Motherboard, Mezzanine and M
Extension to be used jointly in order to develop AT91CAP7 pro
applications.
AT91CAP7X-DK Motherboard
The AT91CAP7X-DK motherboard features the following on-board interfa
n ATX power supply connector
n 2x Full-speed Host USB interfaces
n 100-base TX Ethernet PHY with three status
n Image Sensor expansion connector
n 16 push buttons arranged in a keypad form
n CAN bus interface
LEDs
n Software controlled Power LED
n 2x general-purpose LEDs
n DBGU serial communication port
n 4x analog inputs
n PIO expansion connectors (PIOA, PIOB, PIOC,
n AC97 interface with three 3.5 mm audio jack
PIOD)
connectors (MIC IN, LINE IN, LINE OUT)
n CAP Mezzanine extension connectors
n I2S audio codec with two 3.5 mm audio jack
(2x 320 pins)
connectors (LINE IN, LINE OUT)
n PCI64 form FPGA I/O extension connector
n 2x SD/MMC card slots
n Custom mezzanine-style FPGA I/O extension
n Atmel TWI serial EEPROM
n 1/4 inch TFT LCD VGA interface
n Touch Screen Controller
connector
n 3x USB device PHY interfaces with USB B
connectors (FPGA controlled)
|