CAPTM CUSTOMIZABLE MICROCONTROLLERS
AT91CAP7A-STK® Starter Kit
for CAP Customizable Microcontroller
The CAP™ Starter Kit is the ideal vehicle for low-cost, no-risk evaluation of the customization capabilities
of Atmel’s CAP microcontroller. It is intended to familiarize the user with the CAP concept and architecture,
and is an ideal vehicle for students of electronic engineering to consolidate their knowledge of system-
on-chip design, both hardware and software.
CAP comprises a microcontroller-based system-on-chip with ARM® processor, memories, peripherals and
standard interfaces, together with a Metal Programmable (MP) Block for application-specific functions.
The CAP Starter Kit facilitates the mapping of application-specific IP blocks
emulates the functionality of the CAP MP Block, while at the same time provid
a development platform for software for the ARM processor. This enables the
hardware and software of simple applications, or modules of more complex
applications, to be tested at close to operational speed.
CAP Starter Kit Board
The AT91CAP7A-STK Starter Kit is built on a single PCB, including:
nAT91CAP7E ARM7TDMI®-Based
nFour Analog Inputs
Microcontroller System-On-Chip
nLight Sensor
n64M Bytes SDRAM Memory, 3.3V
nTemperature Sensor
n256M Bytes NAND Flash, 3.3V
nAltera® Cyclone® II EP2C8F256C7N (256BGA)
nVoltage Potentiometer
nVoltage Regulators (1.2V, 2.5V and 3.3V)
nAccess Points for CAP7 Power Measurements
nEight LED’s Four Push Buttons
nJTAG ICE Connector (CAP7)
nJTAG ISP Connector (FPGA)
nPOR Circuit for FPGA
nAltera Configuration PROM -EPCS4SI8N
n40-Lead Extension Connector (x3) for I/O
Access
n2.8 inch TFT Color LCD
nTwo Serial Ports (One Connected to the CAP7
Debug Unit)
nPOR Circuit for CAP7
nOne USB 2.0 Full Speed Device Port
n50 MHz OSC
nMini Joy Stick
|