EZ-KIT Lite for Analog Devices
ADSP-BF537 Blackfin Processor
Key Features
• ADSP-BF537 Blackfin Processor
• Max core clock rate 600 MHz
• 64 MB (32 M x 16) SDRAM
• 4 MB (2 M x 16) flash memory
• SMSC LAN83C185 10/100 PHY with
RJ45 connector
• CAN TJA1041 transceiver with
two modular connectors
• AD1871 96 kHz stereo DAC with
3.5 mm jack connector
• AD1854 96 kHz stereo ADC with
3.5 mm jack connector
• RS-232 UART line driver/receiver
• National Instruments Educational
Laboratory Virtual Instrumentation Suite
(NI ELVIS) interface
Overview
The ADSP-BF537 EZ-KIT Lite® provides developers with a cost-effective method
for evaluation of the ADSP-BF537 Blackfin® Processor and its rich set of system peripherals,
including the IEEE 802.3 10/100 Ethernet MAC and CAN 2.0B controller. A TCP/IP stack
with integrated device driver and example code is provided in VisualDSP++® release 4.0.
This evaluation kit was designed with an emphasis on modularity and expandability.
With this EZ-KIT Lite, users can learn more about Analog Devices ADSP-BF537 hardware
and software development and quickly prototype applications.
• Advanced USB-based debugger interface
• JTAG ICE 14-pin header
• Evaluation suite of VisualDSP++
development tools
• Flash utility for writing application boot
code and data to flash
The EZ-KIT Lite includes an ADSP-BF537 processor desktop evaluation board along
with an evaluation suite of the VisualDSP++ development and debugging environment
that is comprised of a C/C++ compiler, assembler, and linker. The kit also contains
sample processor application programs, CE-approved power supply, a USB cable, both
straight through and crossover Ethernet cables, a 3.5 mm male/male stereo cable,
and a pair of stereo headphones.
• Six general-purpose LEDs, four general-
purpose push-buttons
• Expansion Board Interface Cluster for
evaluating and interfacing with the
processor’s peripheral interfaces
Additionally, the ADSP-BF537 EZ-KIT Lite contains the National Instruments Educational
Laboratory Virtual Instrumentation Suite (ELVIS) interface. This interface will allow using the
oscilloscope, function generator, arbitrary waveform generator, DC voltage and current
measurement modules, and digital I/O. NI ELVIS is a LabVIEW™–based design and prototype
environment for university science and engineering laboratory curriculums. For more
• Discrete IDC Expansion ports for all
processor peripherals
• CE-certified
System Requirements
• Pentium® 500 MHz or higher
• Minimum of 256 megabytes of RAM
• Windows® 2000 or Windows XP
• One available USB connector
• 750 megabytes disk space
w w w. a n a l o g . c o m / p r o c e s s o r s / t o o l s
|