Q UICK START GUIDE
2.4 GHz Corded Cordless
Telephone with Caller ID/Call
W aiting 1485/1185
INSTALLATIO N
Table/Desk Installation
Modular
telephone
jack
Standard
electrical
outlet
NO TE: Install this telephone away from electronic
¥
equipment, such as personal computers,television
sets or microwave ovens. Avoid excessive heat,cold,
dust or moisture.
1
2
Connect the corded handset to the base.
Connect the telephone line cord. (figure a)
3
Connect the power cord to the base and
an electrical outlet not controlled by a wall
switch. (figure a) The answer ON/OFF light
goes on, and CL flashes in the message window.
Power Cord
figure a
Line Cord
Use only the power cord supplied with this
product.If you need a replacement,call 1-800-
222–3111.
a) Remove battery
compartment
cover by
4
Check for dial tone.
•
Lift the handset, you should hear a dial tone.
pressing on the
indentation and
sliding
NO TE: For Wall Mount Installation see page 5 in the
User Manual.
¥
downward.
Handset Charger Installation
1
Connect the power cord. Be sure to plug the cor d
into an electrical outlet not controlled by a wall
switch.
b) Align two holes
in plug with
c) Place battery pack in
compartment with
the wires in the
2
Install the handset batter y. Use NiCd Replacement
Battery 3301,SKU# 91076. (figure b)
socket pins,
and snap the
plug into place.
lower left corner,
along the bottom of
the battery pack.
3
Charge the handset batter y.
•
Place the handset in the remote charging
stand.The CHARGING light goes on.
d) Replace cover
•
Charge the battery at least 12 hours.
by sliding it up
into place.
4
Check for dial tone.
•
After the batteries are charged,lift the handset
figure b
and press ; you should hear a dial tone.
|