TM
Legacy Communications SmartSlot Card
(AP9620) — Installation and Start-up Guide
Warning: The Legacy Communications
SmartSlot Card must only be used in a
UPS that has an RJ-45 connector used
for serial communications. These units
RJ-45 connector
also have plastic tabs extending from the
SmartSlot.
Contents of Package
Sm ar t Sl ot
Legacy Communications SmartSlot Card
Serial Cable
Note: For USB operation, use the USB cable supplied with the UPS or a standard USB 2.0
compliant A-B cable.
Note: Connecting accesories to the Computer Interface Port is not supported.
Installing the card in the UPS
Note: You can install the card while the UPS is turned on. Both screws must be reinstalled in
order to ensure proper operation of the card.
1. Remove the two screws holding the cover
on the SmartSlot with a #2 Phillips-head
screwdriver.
2. Orient the card with the card guides and
slide it in. If the tabs on the housing do
not match the slots on the card, the card is
not compatible with the UPS.
3. Reinstall both screws removed in step 1.
Card status indicators
Solid Green
The card is operating correctly.
Flashing Green The card is initializing. After a few seconds it should turn solid green.
Solid Red
The card is incompatible with this UPS. Check apc.com for a firmware update.
The card has a fault. Call APC technical support.
Flashing Red
Connecting the communication cable
You must choose to use either the USB or the Computer
Interface Port. Only one can be functional at a time.
Note: The communication interfaces on the UPS are disabled
when the card is installed.
USB-B
Port
Computer Interface
Port (DB-9F)
|