12-1621.fm Page 1 Monday, July 12, 1999 9:13 AM
Cat. No. 12-1621
OWNER’S MANUAL
Please read before using this equipment.
CR-320
Big-Display AM/FM Clock Radio
with Dual Alarms
12-1621.fm Page 3 Monday, July 12, 1999 9:13 AM
PREPARATION
1. Press the tab and lift off the battery
compartment cover on the bottom of
the clock radio.
CONNECTING TO
AC POWER
Plug the clock radio’s power cord into a
standard AC outlet. The display flashes
and the BATTERY SENTINEL indicator
light next to the time display turns on
(see “Installing a Back-Up Battery”).
illus of battery compartment
cover removal
2. Snap the clock radio’s battery con-
tacts onto the battery’s terminals,
then insert the battery into the com-
partment. The BATTERY SENTI-
NEL indicator turns off.
illustration of cord
being plugged in
illustration of battery
installation
INSTALLING A BACK-UP
BATTERY
Note: If the BATTERY SENTINEL
indicator remains lit, press SNOOZE
to reset the indicator. If that does not
work, replace the back-up battery.
Your clock radio uses a 9V battery (not
supplied) to operate the clock and alarm
during a power failure. The display turns
off, but the clock keeps the time for at
least 8 hours, and the alarm will sound
(if set) for at least 10 minutes after pow-
er fails. For the best performance, we
recommend an alkaline battery, such as
RadioShack Cat. No. 23-553.
3. Replace the cover.
The BATTERY SENTINEL indicator
lights if the back-up battery is not in-
stalled or needs to be replaced.
Warning: Always dispose of old batter-
ies promptly and properly. Do not bury
or burn them.
Caution: Use only a fresh battery of the
required size and recommended type.
Note: To prevent unnecessary drain on
the battery, install it only after connect-
ing the clock radio to AC power.
3
12-1621.fm Page 4 Monday, July 12, 1999 9:13 AM
OPERATION
SETTING THE CLOCK
PLAYING THE RADIO
Setting the clock is simple. While hold-
ing down TIME SET, repeatedly press (or
hold down) SLOW FORWARD or SLOW
REVERSE. The time on the display ad-
vances or reverses by 1 minute each
time you press the button. (The PM indi-
cator lights for PM hours.)
1. Set ON/OFF/AUTO/ALARM to ON.
illustration of ON/OFF/AUTO/
ALARM set to ON
2. Set AM/FM to the desired band.
illus of REVERSE
and FORWARD
locations
illustration of AM/FM
location
To rapidly set the time, hold down FAST
FORWARD or FAST REVERSE.
Notes:
• The clock radio has a built-in AM
antenna. For the best AM recep-
tion, rotate the radio.
ADJUSTING THE DISPLAY
BRIGHTNESS
• The clock radio’s power cord acts
as the FM antenna. For the best
FM reception, fully extend the
power cord.
To change the brightness of the display,
set DIMMER LOW/HIGH on the side of the
clock radio to LOW or HIGH.
3. Rotate TUNING to the desired sta-
tion.
illustration of DIMMER
LOW/HIGH location
illustration of TUNING location
4
12-1621.fm Page 5 Monday, July 12, 1999 9:13 AM
4. Rotate VOLUME to the desired
3. While holding down ALARM SET,
repeatedly press SLOW FOR-
WARD or SLOW REVERSE to
advance or reverse the alarm
time. Or, to rapidly advance or
reverse the alarm time, hold down
ALARM SET and press FAST FOR-
WARD or FAST REVERSE.
sound level.
illustration of VOLUME location
5. To turn off the radio, set ON/OFF/
AUTO/ALARM to OFF.
illustration of ALARM SET,
REVERSE and FORWARD
locations
USING THE ALARM
Setting the Alarm Time
4. Set ALARM 1+2 to ALARM 2 and
repeat Step 3 to set the second
alarm time. The ALARM 2 indicator
lights on the lower left of the clock
display.
You can set the clock radio so an
alarm sounds or the radio plays at one
or two different times (ALARM 1 and
ALARM 2).
5. Set
ON/OFF/AUTO/ALARM
to
Follow these steps to set the alarm
times.
ALARM to have the buzzer sound
at the set time(s), or to AUTO to
have the radio turn on at the set
time(s). The alarm indicator lights
on the lower left of the clock dis-
play.
1. Set
ON/OFF/AUTO/ALARM
to
AUTO or ALARM.
2. Set ALARM 1+2 to ALARM 1.The
ALARM 1 indicator lights on the
upper left of the clock display.
6. Rotate VOLUME for the desired
alarm or radio volume.
7. Set ALARM 1+2 to 1, 1+2, or 2 to
have the alarm sound at either or
both set times. The indicators for
the selected alarm(s) light.
illustration of ALARM 1+2
location
To silence the buzzer or radio when it
sounds, set ON/OFF/ALARM to OFF. If
you do not turn off the alarm or radio,
it continues to sound for 59 minutes.
5
12-1621.fm Page 6 Monday, July 12, 1999 9:13 AM
Remember to set ON/OFF/AUTO/
ALARM to ALARM or AUTO if you want
it to go off at the set wake-up time the
next day.
USING THE SLEEP
TIMER
Press SLEEP to set the sleep timer so
the radio plays for 59 minutes and
then automatically turns off.
To display the set wake-up time, set
ALARM 1+2 to 1 or 2, then press
ALARM SET.
To set a sleep time of less than 59
minutes, hold down SLEEP and re-
peatedly press (or hold down) SLOW
FORWARD or SLOW REVERSE until
the display shows the desired min-
utes. (Or, hold down FAST FORWARD
or FAST REVERSE to rapidly change
the minute setting.)
USING SNOOZE
To silence the alarm, but have it
sound again in a few minutes, press
SNOOZE. This silences the alarm for
about 7 minutes. You can use this fea-
ture as many times as you want.
To turn off the radio before the set
sleep time has elapsed, set ON/OFF/
AUTO/ALARM to ON, then to OFF, AU-
TO, or ALARM.
To see the time (minutes and sec-
onds) since you first pressed SNOOZE,
hold down SNOOZE.
6
12-1621.fm Page 7 Monday, July 12, 1999 9:13 AM
CARE AND MAINTENANCE
To enjoy your clock radio for a long time:
THE FCC WANTS YOU TO
• Keep the clock radio dry. If it gets
wet, wipe it dry immediately.
KNOW
Your clock radio might cause TV or ra-
dio interference even when it is operat-
ing properly. To determine whether your
clock radio is causing the interference,
turn off your clock radio. If the interfer-
ence goes away, your clock radio is
causing the interference. Try to elimi-
nate the interference by:
• Use and store the clock radio only in
normal temperature environments.
• Handle the clock radio gently and
carefully. Don’t drop it.
• Keep the clock radio away from dust
and dirt.
• Wipe the clock radio with a damp
cloth occasionally to keep it looking
new.
• moving your clock radio away from
the TV or another radio
• connecting your clock radio to an
outlet that is on a different electrical
circuit from the TV or another radio
Modifying or tampering with the clock ra-
dio’s internal components can cause a
malfunction and invalidate its warranty.
If your clock radio is not performing as it
should, take it to your local RadioShack
store for assistance.
• contacting your local RadioShack
store for help
If you cannot eliminate the interference,
the FCC requires that you stop using the
clock radio.
7
12-1621.fm Page 8 Monday, July 12, 1999 9:13 AM
SPECIFICATIONS
Bands ........................................................................................... AM: 530–1710 kHz
FM: 88–108 MHz
Power Output .............................................................................. 320 mW (maximum)
Speaker .............................................. 3 Inch (7.6 cm) Ferrite, Dynamic-Type, 8 Ohm
Alarm ................................................................................................................. 96 dB
Power Requirements ................................................................ 120V AC, 60 Hz, 6 W
Back-up Battery ............................................................................................... 9V DC
3
3
1
Dimensions (HWD) ................................ 2 /5 × 9 /5 × 6 /8 Inches (65 × 240 × 155 mm)
Weight ............................................................................................. 1 lb 12 oz (790 g)
Specifications are typical; individual units might vary. Specifications and designs are
subject to change and improvement without notice.
Limited Ninety-Day Warranty
This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal
use for ninety (90) days from the date of purchase from RadioShack company-owned stores and authorized Ra-
dioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WAR-
RANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WAR-
RANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY OR
RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY,
LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT
OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAM-
AGES RESULTING FROM INCONVENIENCE, LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR
ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow the limitations on how long an implied warranty lasts or the exclusion of incidental or con-
sequential damages, so the above limitations or exclusions may not apply to you.
In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt as
proof of purchase date to any RadioShack store. RadioShack will, at its option, unless otherwise provided by law:
(a) correct the defect by product repair without charge for parts and labor; (b) replace the product with one of the
same or similar design; or (c) refund the purchase price. All replaced parts and products, and products on which a
refund is made, become the property of RadioShack. New or reconditioned parts and products may be used in the
performance of warranty service. Repaired or replaced parts and products are warranted for the remainder of the
original warranty period. You will be charged for repair or replacement of the product made after the expiration of the
warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident, mis-
use, improper or abnormal usage, failure to follow instructions, improper installation or maintenance, alteration,
lightning or other incidence of excess voltage or current; (b) any repairs other than those provided by a RadioShack
Authorized Service Facility; (c) consumables such as fuses or batteries; (d) cosmetic damage; (e) transportation,
shipping or insurance costs; or (f) costs of product removal, installation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
RadioShack Customer Relations, Dept. W, 100 Throckmorton St., Suite 600, Fort Worth, TX 76102
We Service What We Sell
3/97
RadioShack
A Division of Tandy Corporation
Fort Worth, Texas 76102
11A98
Printed in the Philippines
|