TSD ■ Service Manual
P526
Service Manual
1
TSD ■ Service Manual
2. Disassembly / Assembly Procedure
2.1 Introduction
This section describes how to disassemble P526 telephone.
Many of the integrated devices used in this phone are vulnerable to damage.
Ensure adequate static protection is in place when handling, shipping,
and servicing any internal components.
2.2 Recommended Tools
Anti-Static Mat (Ground Cord included)
Anti-Static Wrist Strap
Torque Screw Driver (T5 type, torque is set to 1.2kg-cm)
Tweezers
Plastic blade
TSD ■ Service Manual
2.3 Disassembly Procedure
The following set of diagrams will demonstrate the correct sequence and action to disassemble
P526.
1. Remove the Stylus
2. Remove Battery cover
3. Remove Battery
4
TSD ■ Service Manual
4. Remove the ANTENNA Cover
5. Remove 4 SCREWS M1.6*4L T5
6. Disassemble FRONT COVER ASS'Y and MIDDLE COVER ASS'Y by Plastic
Wrench
5
TSD ■ Service Manual
7. Remove VIBRATOR and SPEAKER from MIDDLE COVER ASS'Y
8. Remove Main Board from FRONT COVER ASS'Y
6
TSD ■ Service Manual
9. Remove LCD TFT, KEYPAD and 4 GASKETS from FRONT COVER ASS'Y
10. Remove RECEIVER from FRONT COVER ASS'Y
7
TSD ■ Service Manual
2.4 Assembly Procedure
It is carried out in the exact reverse sequence as the disassembly.
1. Assemble FRONT COVER ASS'Y: Put RECEIVER in FRONT COVER ASS'Y
2. Assemble LCD module
3．Put Keypad in FRONT COVER ASS'Y
8
TSD ■ Service Manual
4. Assemble FRONT COVER ASS'Y and Main Board
5．Connect the LCM Module
6. Assemble MIDDLE COVER ASS'Y：Put VARISTOR in MIDDLE COVER
ASS'Y
9
TSD ■ Service Manual
7．Put OK KEY MIDDLE COVER ASS'Y
8．Put CAMERA KEY in MIDDLE COVER ASS'Y
9．Put POWER KEY in MIDDLE COVER ASS'Y
10．Assemble MIDDLE COVER ASS'Y and MIDDLE COVER ASS'Y
10
TSD ■ Service Manual
11．Put on 4 SCREWS M1.6*4L T5
12．Put on Battery
13．Put on Battery Cover
11
TSD ■ Service Manual
14. Assemble Styluses：Put in Stylus
12
|