Light Modifiers
Page 1 of 1
Setup Instructions
PokerLite
Style: 7051
Description
With a 360-degree light spread, the Pokerlite is the perfect lighting accessory for an interview or table
setting. The Pokerlite™ is 17” tall by 21.5” wide and is composed of a white diffusion material with a
removable black duvetyn skirt. There are three densities of bottom diffusion available: Full Stop, ¾ and ½
Stop. The skirt and bottom diffusions attach to the Pokerlite™ with hook and loop tape.
ƒ
Product Contains
ƒ [1] PokerLite
ƒ [4] Metal Rods
ƒ [1] Full Stop Diffusion Panel
ƒ [1] 3/4 Stop Diffusion Panel
ƒ [1] 1/2 Stop Diffusion Panel
ƒ [2] Black Skirts (cover ½ side each)
ƒ [1] Carry Bag
Instructions
•
Remove the Pokerlite and rods from the carry case
•
On the black base, there are four Velcro tabs. Find the holes at the end of these pointing towards the
center opening.
•
•
Insert the rods into the openings under the hook tape making sure they’re completely in. You can tell if
you have them in far enough if all rods pointing out are of the same length.
First, insert one rod into one of the four holes on an adapter ring (sold separately). Second, insert the rod
directly opposite the first one. Repeat using the remaining open two holes. The rods are constructed of
sprung stainless steel so they’re made to bend for the purpose of our lighting accessories.
•
•
Attach one of the Full Stop, ¾ or ½ Stop densities of diffusion to the bottom of the Pokerlite per your
needs/preference matching up the hook and loop tape along the white edge on the larger opening of the
Pokerlite.
Again, per your needs/preference, you can attach the black duvetyn skirt using the hook and loop tape on
the outside edge of the black surface. You can also use the hook and loop tape to hold back portions of
the black duvetyn skirt if you want partial coverage; more light exposure. To fold the skirt up for ½ the
vertical coverage, connect the hook and loop tabs at the bottom with the same strip the top is connected
to.
©F.J. Westcott Company
|