Transition Networks MEDIA CONVERTERS E 100BTX FRL 01 User Manual

MEDIA CONVERTER TECHNICAL SPECIFICATIONS  
Standards  
IEEE 802.3  
Minneapolis, MN 55344 USA  
100BASE-TX/100BASE-FX Media Converters  
E-100BTX-FRL-01, E-100BTX-FRL-01(SC), E-100BTX-FRL-01(SM)  
Case dimensions  
Environment  
3.9" x 3.0" x 1.0"  
(99mm x 76mm x 25mm)  
Temperature:  
Humidity  
Altitude  
0-40°C (32° to 104° F )  
10-90%, non condensing  
0-10,000 feet  
USER’S GUIDE  
Warranty  
Five years  
The TRANSITION Networks Ethernet™ 100BASE-TX to 100BASE-FX media  
converters connect 100BASE-TX unshielded twisted pair cable to 100BASE-FX  
multimode or singlemode fiber-optic cable. Media converter models are selected  
according to the fiber mode and fiber connector required at the site. Multimode  
fiber-optic cable can use either an ST connector (E-100BTX-FRL-01) or an SC  
connector (E-100BTX-FRL-01(SC)). Singlemode fiber (E-100BTX-FRL-01(SM)) uses  
only an SC connector. All media converters function in half-duplex mode or, when  
connected to devices capable of full-duplex connectivity, in full-duplex mode.  
Power Supply Requirements Replace power supply with only the equivalent input  
rating (see below) and output rating (regulated 9VDC at 0.5 A).  
TN PN  
3517  
3516  
3518  
3514  
3515  
Requirement  
Location  
United Kingdom  
Europe  
USA/Canada/Mexico  
Japan  
Australia  
240 volts, 50 hertz  
230 volts, 50 hertz  
120 volts, 60 hertz  
100 volts, 50-60 hertz  
240 volts, 50 hertz  
E-100BTX-FRL-01  
UTP  
Provides an RJ-45 unshielded twisted  
pair 100BASE-TX connector and a set  
of RX (receive) and TX (transmit) ST  
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE  
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in  
damage to the public telephone network.  
100BASE-FX connectors to multimode  
Multimode Fiber  
fiber-optic cable.  
E-100BTX-FRL-01  
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten  
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur  
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen  
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.  
E-100BTX-FRL-01(SC)  
UTP  
Provides an RJ-45 unshielded twisted  
pair 100BASE-TX connector and an  
RX (receive) and TX (transmit) SC  
Compliance Information  
UL Listed  
C-UL Listed (Canada)  
CISPR/EN55022 Class A  
100BASE-FX connector to multimode  
Multimode Fiber  
fiber-optic cable.  
E-100BTX-FRL-01(SC)  
FCC Regulations  
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant  
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful  
interference when the equipment is operated in a commercial environment. This equipment generates,  
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the  
instruction manual, may cause harmful interference to radio communications. Operation of this  
equipment in a residential area is likely to cause harmful interference, in which case the user will be  
required to correct the interference at the user’s own expense.  
E-100BTX-FRL-01(SM)  
UTP  
Provides an RJ-45 unshielded twisted  
pair 100BASE-TX connector and an  
RX (receive) and TX (transmit) SC  
100BASE-FX connector to singlemode  
Singlemode Fiber  
fiber-optic cable.  
Canadian Regulations  
E-100BTX-FRL-01(SM)  
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on  
the radio interference regulations of the Canadian Department of Communications.  
Link  
Status LEDs on the connector side of the media  
converters provide the following information:  
Pwr (Power) Illuminated green LED  
European Regulations  
Warning  
ST Connectors  
RX  
TX  
RX  
Link  
Link  
This is a Class A product. In a domestic environment this product may cause radio interference in which  
case the user may be required to take adequate measures.  
Pwr  
indicates connection to external  
AC power.  
RX  
RX  
RJ-45 Connector  
10BASE-T  
10BASE-FL  
TX  
RX  
Link  
Link  
Pwr  
RJ-45 Connector  
Copyright Restrictions  
© 1996, 1997 TRANSITION Networks.  
All rights reserved. No part of this work may be reproduced or used in any form or by any means –  
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.  
RX  
(Receive) Flashing green LED  
indicates port is receiving  
RX  
RX  
10BASE-T  
10BASE-FL  
Link  
RX  
SC Connectors  
data.  
Pwr  
Link Steady green LED indicates port is  
Trademark Notice  
receiving link signal.  
All registered trademarks and trademarks are the property of their respective owners.  
33009.C  

Westcott 1810 User Manual
Vivitar DVR 785HD User Manual
Sony XCG 5005E User Manual
Sony VCL HG0872 User Manual
Sony MEX R1 User Manual
Sony HVL FH1100 User Manual
Sony FCB EX480C User Manual
Sony Camcorder CCD TRV81 User Manual
Sanyo CE42LH2DPB User Manual
Samsung VP W87D User Manual