The 1.4X Teleconverter (SAL14TC)/2X Teleconverter (SAL20TC) functions
to increase the focal length of the attached lens by 1.4X (SAL14TC)/2.0X
(SAL20TC) when mounted between the camera and lens.
2-685-152-11(1)
WARNING
To reduce fire or shock hazard, do not expose the unit to rain or moisture.
Do not directly look at the sun through this lens.
Doing so might harm your eyes or cause loss of eyesight.
Keep the lens out of reach of small children.
This teleconverter is designed for Sony
cameras.
Lens for Digital Single Lens
Reflex Camera
There is danger of accident or injury.
Notes on use
• Do not leave the teleconverter in direct sunlight. If sunlight is focused onto
a nearby object, it may cause a fire. If circumstances necessitate leaving the
teleconverter in direct sunlight, be sure to attach the lens cap.
Disposal of Old Electrical & Electronic Equipment
(Applicable in the European Union and other
European countries with separate collection
systems)
• Be careful not to subject the teleconverter to mechanical shock while attaching
it.
Operating Instructions
This symbol on the product or on its packaging indicates that
this product shall not be treated as household waste. Instead it
shall be handed over to the applicable collection point for the
recycling of electrical and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences
for the environment and human health, which could otherwise be caused
by inappropriate waste handling of this product. The recycling of materials
will help to conserve natural resources. For more detailed information
about recycling of this product, please contact your local Civic Office, your
household waste disposal service or the shop where you purchased the
product.
• Always place the lens caps on the teleconverter when storing.
• Do not keep the teleconverter in a very humid place for a long period of time to
prevent mold.
1.4X Teleconverter
2X Teleconverter
• Hold both the camera and lens, when you carry the camera with the lens
attached.
• Do not touch the lens contacts. If dirt, etc., gets on the lens contacts, it may
interfere or prevent the sending and receiving of signals between the lens and the
camera, resulting in operational malfunction.
SAL14TC/20TC
Condensation
©2006 Sony Corporation Printed in Japan
If your lens is brought directly from a cold place to a warm place,
condensation may appear on the lens. To avoid this, place the teleconverter in
a plastic bag or something similar. When the air temperature inside the bag
reaches the surrounding temperature, take the teleconverter out.
For the customers in the U.S.A.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
Cleaning the teleconverter
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,
AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE
RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
• Do not touch the surface of the lens directly.
• If the lens gets dirty, brush off dust with a lens blower and wipe with a soft,
clean cloth (Cleaning Cloth KK-CA (optional) is recommended).
• Do not use any organic solvent, such as thinner or benzine, to clean the
teleconverter.
CAUTION
You are cautioned that any changes or modifications not expressly approved
in this manual could void your authority to operate this equipment.
Compatible Lenses and Functions
NOTE:
This teleconverter is designed exclusively for use with the
lenses listed below. Do not attach other lenses, otherwise the
teleconverter or lens may be damaged.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
How to read the table
AF: Auto focus
MF: Manual focus. The viewfinder focus indicator is lit when the subject
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
is in focus.
1.4X
2X
Teleconverter
Teleconverter
70-200mm F2.8 G
(SAL70200G)
AF MF
AF MF
MF*
AF MF
AF MF
MF*
– Reorient or relocate the receiving antenna.
300mm F2.8 G
(SAL300F28G)
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
135mm F2.8 [T4.5] STF
(SAL135F28)
– Consult the dealer or an experienced radio/TV technician for help.
*
The viewfinder focus indicator does not work.
Focus manually, monitoring the subject.
For the customers in Canada
This Class B digital apparatus complies with Canadian ICES-003.
|