| Cat. No. 40-1019   PRO-CSW1200 12 Car Subwoofer   " Your RadioShack PRO-CSW1200 12" Car Subwoofer   ENCLOSURE SIZES   lets you increase the bass response of your vehicle’s   sound system. When mounted inside an enclosure, your   sub-woofer’s high-output, low-distortion design provides   quality, bass sound reproduction. The subwoofer’s long-   travel voice coil lets it handle high input power with ease.   After you choose an enclosure type for your subwoofer,   for the best results, build the enclosure to the dimensions   recommended in this section.   Acoustic Suspension (sealed)   C A B A C B Note: To connect the subwoofer to your stereo amplifier’s   wires, you need 2 banana plugs such as Cat. No. 278-   306 (not supplied).   15 × 15 × 131/2 Inches (HWD)   1.25 Cubic Feet   A (2) — 15" × 15" (one with 111/16" diameter cutout)   B (2) — 15" × 12" HW   C (2) — 131/2" × 12" HW   CHOOSING AN ENCLOSURE   F3: 46 Hz   Ripple: 0.31 dB   To get the best performance from your subwoofer, you   must mount it inside an enclosure. An enclosure makes   your subwoofer more efficient and improves its sound   quality.   Excursion Limited Power Handling: 200 Watts   Ported Reflex (vented)   Some common enclosure designs are:   • Acoustic suspension (sealed)   • Ported reflex (vented)   A C B • Single reflex bandpass (vented)   C For more information about a single reflex bandpass en-   closure, see “Single Reflex Bandpass (vented)” on   Page 2.   A B To learn more about and build an acoustic suspension or   ported reflex enclosure, we recommend you use the book   Building Speaker Systems (Cat. No. 62-1087A, available   at your local RadioShack store) along with this Owner’s   Manual. That book has complete information about build-   ing enclosures, including obtaining construction materi-   als, and design and construction tips.   15 × 19 × 171/2 Inches (HWD)   2.25 Cubic Feet   A (2) — 15" × 19" (one with 111/16" and 4" diameter cutout)   B (2) — 15" × 161/2" HW   C (2) — 171/2" × 161/2" HW   Note: Check with RadioShack Unlimited for a pre-built   enclosure for this subwoofer.   Tuning Frequency: 36 Hz   F3: 38 Hz   Ripple: 2.0 dB   Excursion Limited Power Handling: 200 Watts   © 1998 Tandy Corporation.   All Rights Reserved.   RadioShack is a registered trademark used by Tandy Corporation.   FREQUENCY RESPONSE   97   94   91   88   85   82   79   76   73   70   100   30   40   50   60   70   80   90   20   Frequency (Hz)   1.25 Ft3 Acoustic Suspension   2.25 Ft3 Ported Reflex   2.5 Ft3 Single Reflex Bandpass (s=0.6   SPECIFICATIONS   Frequency Range .................................................................................................................................................. 31–150 Hz   Resonant Frequency .................................................................................................................................................. 31.3 Hz   Power Handling .................................................................................................................... 200 Watts RMS/400 Watts Max   Nominal Impedance ................................................................................................................................................... 4 Ohms   Piston Area ................................................................................................................................................. 82.5 In2, .0532 M2   Magnet Weight ............................................................................................................................................................... 28 oz   Flux Density ............................................................................................................................................................. 11.52 Tm   DC Voice Coil Resistance ..................................................................................................................................... 3.41 Ohms   Voice Coil Inductance ................................................................................................................................................. 2.2 mH   Total Q Factor ............................................................................................................................................................. .57 Qts   Electrical Q Factor ...................................................................................................................................................... .60 Qes   Mechanical Q Factor ............................................................................................................................................. 13.97 Qms   Equivalent Acoustic Volume .......................................................................................................................................3 .09 Ft3   Mechanical Suspension Compliance .................................................................................................................... .220 mm/N   Mechanical Mass of Cone Assembly and Free Air Load ............................................................................................ 118.0 g   Mechanical Mass of Cone Assembly only .................................................................................................................. 110.9 g   Peak to Peak (maximum) Linear Excursion ............................................................................................................... .7187 In   Sensitivity .................................................................................................................................... 89.0 dB (1 Watt @ 1 Meter)   Cone ................................................................................................................................ 12 inches, Wet Look Treated Fiber   Voice Coil ............................................................................................................................. 1.5 inches, Kapton MTB Former   Surround (material of construction) ............................................................................................................... Polyether Foam   Connectors .............................................................................................................................................. 5-Way, Gold-Plated   Mounting Cutout ................................................................................................................................................. 111/16 Inches   (28.01 cm)   Mounting Depth ..................................................................................................................................................... 55/8 Inches   (14.19 cm)   Specifications are typical; individual units might vary. Specifications are subject to change and improvement without notice.   3 Limited Ninety-Day Warranty   This product is warranted by RadioShack against manufacturing defects in material and workman-   ship under normal use for ninety (90) days from the date of purchase from RadioShack company-   owned stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED   HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES,   INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,   ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES   CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABIL-   ITY OR RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RE-   SPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE   OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WAR-   RANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVE-   NIENCE, LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT,   SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN AD-   VISED OF THE POSSIBILITY OF SUCH DAMAGES.   Some states do not allow the limitations on how long an implied warranty lasts or the exclusion of in-   cidental or consequential damages, so the above limitations or exclusions may not apply to you.   In the event of a product defect during the warranty period, take the product and the RadioShack   sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, un-   less otherwise provided by law: (a) correct the defect by product repair without charge for parts and   labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase   price. All replaced parts and products, and products on which a refund is made, become the prop-   erty of RadioShack. New or reconditioned parts and products may be used in the performance of   warranty service. Repaired or replaced parts and products are warranted for the remainder of the   original warranty period. You will be charged for repair or replacement of the product made after the   expiration of the warranty period.   This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse,   accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or   maintenance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs   other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as   fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs   of product removal, installation, set-up service adjustment or reinstallation.   This warranty gives you specific legal rights, and you may also have other rights which vary from   state to state.   RadioShack Customer Relations, Dept. W, 100 Throckmorton St., Suite 600, Fort Worth, TX 76102   We Service What We Sell   3/97   RadioShack   A Division of Tandy Corporation   Fort Worth, Texas 76102   21A2652   4/98   Printed in the USA   |