Connect
1
A
Subwoofer
(optional)
Antenna
+
–
+
–
Illumination switch
To the +12V car
battery which is
energized at all time
Motor/electric
antenna relay control
lead/Amplifier relay
control lead
+
+
–
–
Ground
Ignition Key +12V
DC when ON/ACC
Caution
Ensure that all leads are insulated with electrical tape.
Note
Consult a professional to connect CE150 different from user manual instructions.
Subwoofer
(optional)
Antenna
or
Illumination switch
To the +12V car
battery which is
energized at all time
Motor/electric
Amplifer input
Right
antenna relay control
lead/Amplifier relay
control lead
Rear
Front
Left
Ground
Ignition Key +12V
DC when ON/ACC
Mount into dashboard
2
A
B
183mm
53.5mm
C
D
D
E
1
2
Remote control
1
2
CR2025
CR2025
3V
CR2025
3V
Get started
3
Turn on /Turn off
Turn on
Turn off
3 seconds
Adjust volume
Mute
Maximizing
volume
Dynamic Bass
Boost
Press and
hold
Source
*
**
* if SD card is inserted
** if USB device is inserted
Adjust system settings
Bluetooth
USA
Latin
Europe
Russia
Area: USA, Latin
Area: Europe, Russia
Set clock
Adjust sound settings
Press and
hold
Subwoofer
Reset
Equalizer
View clock
Caution
Once it is restore, it cannot be undone.
Press and
hold
Connect Bluetooth
Pairing
Make a call
1234....
Redail
Philips
PIN: 0000
End a call
Answer a call
Reject a call
Transfer a call
A
Press and
hold
B
Radio
Manual tune
Auto tune
Press and
hold
Select band
Preset station
Press and
hold
Play preset station
SD card / USB
Insert SD card
1
2
Insert USB device
Play option
Song
information
Search folder
Track number and
elapsed play time
Folder
File
Search track
Album
Title
Artist
MP3-Link
Listen to other source
SD card / USB
Bluetooth audio
Search within a
track
Skip track
Press and
hold
Product information
Compatible USB devices
Note
•
•
•
USB flash memory: USB 1.1 host with
interface reading all speed support (1.1, 2.0)
USB flash players: USB 1.1 host with
interface reading all speed support (1.1, 2.0)
memory cards (SD / SDHC)
Product information is subject to change without
prior notice.
Power supply
12VDC (11V-16V),
negative ground
15A
Fuse
Suitable speaker 4 - 8 Ω
impedance
Maximum power 45 W x 4 channels
output
Supported formats
•
USB or memory file format: FAT16,
FAT32
•
MP3 bit rate (data rate): 32-320 Kbps and
variable bit rate
Continuous
22 W x 4 RMS (4Ω 10%
power output
T.H.D.)
•
•
WMA V4, V7, V8, V9 (L1, L2)
Maximum title number: 512 (depending
on file name length)
Pre-Amp output 2.5 V
voltage
Aux-in level
Dimensions
(W x H x D)
Weight
≥500 mV
188 x 58 x 140 mm
•
•
Maximum album number: 255
Supported sampling frequencies: 2 kHz,
44.1 kHz, 48 kHz
0.8 kg
•
•
•
Supported Bit-rates: 2~256 (kbps),
variable bit rates
Directory nesting up to a maximum of 8
levels
Number of albums/ folders: USB
maximum 199
Radio
Frequency range - 87.5 - 108.0 MHz
FM (100kHz per step in auto
search and 50kHz per
step in manual search)
Frequency range - 522 - 1620 KHz (9 kHz)
AM(MW) 530 - 1710 kHz (10 kHz)
•
•
•
Number of tracks/titles: maximum 999
ID3 tag v2.0 or later
File name in Unicode UTF8 (maximum
length 64 bytes)
Usable sensitivity 8 μV
- FM
Usable sensitivity 30 μV
- AM(MW) (S/
N= 20 dB)
Unsupported formats
•
Empty albums: an empty album is an
album that does not contain MP3/WMA
files, and is not be shown in the display.
Unsupported file formats are skipped. For
example, Word documents (.doc) or MP3
files with extension .dlf are ignored and
not played.
Bluetooth
•
Output power
0 dBm (Class 2)
Frequency band 2.4000 GHz - 2.4835
GHz ISM Band
3 meters(free space)
Bluetooth 2.0
Range
Standard
•
•
AAC, WAV, PCM audio files
DRM protected WMA files (.wav, .m4a,
.m4p, .mp4, .aac)
specification
•
WMA files in Lossless format
Troubleshooting
Display show ERR-5
Caution
•
Communication error or component is
Never remove the casing of this apparatus.
damaged.
To keep the warranty valid, never try to repair
the system yourself.
About Bluetooth device
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/support).When you contact Philips,
ensure that your apparatus is nearby and the
model number and serial number are available.
Cannot pair the Bluetooth enabled device
with the car audio system.
•
The device does not support the profiles
required for the system.
•
The Bluetooth function of the device is
not enabled. Refer to the user manual of
the device for how to enable the function.
No power or no sound
•
Car engine is not on. Turn the car engine
on.
Cable is not correctly connected. Check
connections.
Fuse is burnt. Replace fuse .
Volume is too low. Adjust volume.
If the above solutions cannot help, press
the RESET button.
The audio quality is poor after connection
with a Bluetooth-enabled device.
•
•
The Bluetooth reception is poor. Move
the device closer to the car audio system
or remove any obstacle between the
device and the system.
•
•
•
Music playback is unavailable on the system
even after successful Bluetooth connection.
The device cannot be used with the system to
play music.
•
Ensure that the track played is of a
compatible format.
Noise in broadcasts
•
Signals are too weak. Select other
stations with stronger signals.
Check the connection of the car antenna.
Change broadcast from Stereo to mono .
The paired mobile phone connects and
disconnects constantly.
•
•
•
The Bluetooth reception is poor. Move
the mobile phone closer to the car audio
system or remove any obstacle between
the mobile phone and the system.
Some mobile phones may connect and
disconnect constantly when you make
or end calls. This does not indicate any
malfunction of the system.
Preset stations lost
•
Battery cable is not correctly connected.
Connect the battery cable to the terminal
that is always live.
•
Display show ERR-1
•
•
•
For some mobile phones, the Bluetooth
connection may be deactivated
automatically as a power-saving feature.
This does not indicate any malfunction of
the system.
The disc, USB or SD device cannot be
read in two minutes.
Display show ERR-3
USB/SD data error.
•
Important
Safety
Notice
• Read and understand all instructions
before you use your apparatus. If damage is
caused by failure to follow instructions, the
warranty does not apply.
• This apparatus is designed for negative
ground (earth) 12 V DC operation only.
• To ensure safe driving, adjust the volume to
a safe and comfortable level.
The making of unauthorized copies of
copy-protected material, including computer
programs, files, broadcasts and sound
recordings, may be an infringement of
copyrights and constitute a criminal offence.
This equipment should not be used for such
purposes.
• Improper fuses can cause damage or fire.
When you need to change the fuse, consult
a professional.
Recycling
• Use only the supplied mounting hardware
for a safe and secure installation.
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
When you see the crossed-out wheel bin
symbol attached to a product, it means the
product is covered by the European Directive
2002/96/EC:
• To avoid short circuit, do not expose the
apparatus, remote control or remote
control batteries to rain or water.
• Never insert objects into the ventilation
slots or other openings on the apparatus.
• Clean the apparatus and frame with a soft,
damp cloth. Never use substances such as
alcohol, chemicals or household cleaners on
the apparatus.
• Never place any objects other than discs
into the apparatus.
• Never use solvents such as benzene,
thinner, cleaners available commercially, or
anti-static sprays intended for discs.
• Visible and invisible laser radiation when
open. Avoid exposure to beam.
• Risk of damage to the apparatus screen!
Never touch, push, rub or strike the screen
with any object.
Never dispose of your product with other
household waste. Please inform yourself about
the local rules on the separate collection of
electrical and electronic products.The correct
disposal of your old product helps prevent
potentially negative consequences on the
environment and human health.
Your product contains batteries covered by the
European Directive 2006/66/EC, which cannot
be disposed of with nvormal household waste.
Please inform yourself about the local rules on
separate collection of batteries.The correct
disposal of batteries helps prevent potentially
negative consequences on the environment and
human health.
Caution
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
All registered and unregistered trademarks are the property of their respective owners.
Specifications are subject to change without notice
Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners
© 2010 Koninklijke Philips Electronics N.V.
CE150_55_UM_EN_V.01
wk10281
All rights reserved.
|