CA1750 Mount Adapter
Installation Instructions
C209M (4/98)
®
1.0 DESCRIPTION
The CA1750 Mount Adapter is used when installing a bottom-mount camera on a
BS1750, CM1750, CM1750S, orTB1750 mount only when the mount is attached to
a ceiling. Use of the adapter, in this situation, will allow the camera to be mounted in
its correct orientation, rather than being inverted.
2.0 INSTALLATION
To install the adapter (refer to Figure 1):
1. Place the camera inside the adapter and align the camera mount boss with
the elongated hole in the adapter.
CAUTION: Be careful
not to damage the cam-
era by screwing the
adapter too far onto the
threaded stud. As soon as
the stud threads appear
through the adapter cap-
tive nut, tighten the
knurled nut.
2. Attach the camera to the adapter with the provided 1/4-20 bolt and washers.
3. Attach the adapter with camera to the 1/4-20 threaded stud on the installed
mount swivel head.Tighten the knurled nut on the mount against the adapter.
Figure 1. CA1750 Mount Adapter
In North America and Canada: Tel (800) 289-9100 • FAX (800) 289-9150 • DataFAX (800) 289-9108
International Customers: Tel (1-559) 292-1981 or FAX (1-559) 348-1120 • DataFAX (1-559) 292-0435
|