1933 Series Instruction Sheet
Opening your OtterBox 1933 Case
Step 1
Remove the silicone skin from
the hard shell.
Step 2
Step 3
Remove the clear membrane and insert.
Separate the two halves of the case.
Installing Your BlackBerry™ Into The Case
Step 1
Step 2
Step 3
Place the phone into the plastic lid. If you are
not using the clear membrane proceed to step
4, otherwise go to the next step.
For maximum protection align the front of the clear
membrane with the keyboard. It is recommended that
you use the provided installation card and microfiber
cloth at this time to reduce any air bubbles trapped
beneath the clear screen film.
Wrap back of clear membrane over your BlackBerry.
Note: This is an optional step, however the clear
membrane provides added protection to the
keypad and screen.
Step 5
Cleaning/ Maintenance
Included in the package is an installation card and
microfiber cleaning cloth.
Step 4
Snap together the plastic lid and the base.
Wrap the silicone skin around the device.
Make sure to locate the retaining slots for the
silicone as shown. Note: If any part is mis-
aligned take apart the case and start over.
Pay close attention to the alignment of
keyboard, screen & case features at every
step of installation.
Installation Card: Use the installation card at any
time to smooth out any air bubbles between the clear
membrane and the screen of the BlackBerry.
Cleaning Cloth: Use this microfiber cloth for cleaning
the clear plastic membrane, or screen of the phone.
SM40116A
|