Marshall Electronics
8
Standard Accessories
1910 East Maple Ave.
El Segundo, CA 90245
Accessories Supplied with the V-RD171P-HDA:
Tel.: 800-800-6608 • 310-333-0606
Fax: 310-333-0688
• Users manual
• “Brick” type 12VDC power supply, Part #: V-PS12-5V-1
Email: [email protected]
V-RD171P-HDA Users Guide
Product Overview
Features
1
2
3
4
5
6
7
8
9
Specifications
9
Warranty
Operational Setup
Connectors
Marshall Electronics warranties to the first consumer, that this V-R171P-HDA 17 inch LCD rack mounted monitor will, under normal use, be free from defects in work-
manship and materials, when received in its original container, for a period of one year from the purchase date.
This warranty is extended to the purchasing end user only and proof of purchase is necessary to honor the warranty. If there is no proof of purchase provided with a
warranty claim, Marshall Electronics reserves the right not to honor the warranty set forth above. Therefore, labor and parts may be charged to you.
This warranty does not apply to product exterior and cosmetics. Misuse, abnormal service or handling, improper alterations or modifications in design or construc-
tion, voids this warranty. No sales personnel of the seller, nor any other person is authorized to make any warranties other than those described above, or to extend
the duration of any warranties on behalf of Marshall Electronics, beyond the time period described above.
An extra note about LCD displays: It is considered normal for a minimal amount of pixels, not to exceed three, to fail on the periphery of the display active viewing
area. Marshall Electronics has the option to reserve service for display pixel failure if deemed unobtrusive to effective use of the monitor by our technicians.
Due to constant effort to improve products and product features, specifications may change without notice.
Front Panel Indicators and Controls
Menu Functions
Standard Accessories
Warranty
06/19/2006
4
Operational Setup
1. Unpack the V-RD171P-HDA and accompanying power supply. Physically inspect for any damage that may have occurred
during shipping. Should there be any damage, immediately contact Marshall Electronics at 800-800-6608. If you are not
located within the continental United States call +1 310-333-0606.
2. Install in your desired location.
3. Connect required cables for signal input and output.
4. Attach power connector from power supply to the back of the unit.
5. Plug the power supply into the A.C. source
6. Turn on the V-RD171P-HDA by pressing the power switch located on the front of the unit.
Refer to picture below for location of switch settings.
7. Perform input selections and screen adjustments as detailed in the following sections of this document.
5
Connectors
Composite Video
75Ω Terminated
12 VDC from
power supply
Component Video
75Ω Terminated
S-Video
75Ω Terminated
DVI-D in
VGA in
6
Front Panel Indicators and Controls
Power On/Off selection button
Illuminates bright red when power is applied.
Turns dim red when monitor is switched on
On Screen Display (OSD)
MENU Activation Button
Dual Function EXIT button
1- Cycles Input selection
(Selection Displayed lower right of screen)
2- Exits OSD Menu Mode
UP / DOWN / LEFT / RIGHT
menu selections for OSD functions
Marshall Electronics
3
7
Menu Functions
Note: Menu may be activated if signal on the selected input is detected.
Menu functions are different for the selected inputs.
MENU select will toggle through 5 menus, FUNCTION, PICTURE, AUDIO (NOT USED), TV-SETUP and WINDOW
Function Menu
Use UP/DOWN/LEFT/RIGHT buttons to select function.
LANGUAGE-English, French, Spanish
AUTO ADJUST- Used for PC and DVI signals to auto fit
image to screen.
OSD TIME-OUT - Set time in seconds (0 to 60) for OSD
to drop from screen after last button push
SLEEP TIMER- Used to automatically turn monitor off
after programmed delay
Picture Menu
Use UP/DOWN/LEFT/RIGHT buttons to select function.
PSM - (Picture Status Memory) Used only with video signals.
Select one of four choices
STANDARD- Default brightness, contrast and color.
DYNAMIC- Brightness, contrast and color adjusted for changes
in source video.
CINEMA- Brightness, contrast and color adjusted for viewing in
a darkened environment.
CUSTOM- User defined picture adjustment.
COLOR TONE- Select from four presets or create a user de-
fined color temperature.
CUSTOM- User defined
STANDARD- 6900° Kelvin
COOL 2- 7500°Kelvin
COOL 1- 7200° Kelvin
WARM 1- 6500° Kelvin
WARM 2- 6100° Kelvin
TV SETUP
Use UP/DOWN/LEFT/RIGHT buttons to select function.
SEARCH AND TUNE FUNCTIONS ARE NOT USED ON
THE V-R171P-HDA
Use CCD functions for VIT close caption display
V-RD171P-HDA Users Guide
4
|