D.Connect the connecting cable assembly to the monitor.
E.Ensure there is no foreign material is trapped inside the enclosure, before
pushing the monitor into the headrest shroud make sure that the monitor
is securely locked in place.
Maintenance
To avoid electrical shock ,do not open the enclosure. high voltage is present.
No user serviceable parts inside the enclosure
E
C
D
Do not use any chemical solvent, cleaning agent or corrosive detergent to
clean away dirt on the surface of the screen. To clean off dirt or finger print,
we recommend the use of a soft damp lens cleaning cloth.
Monitor
Headrest Shroud
Should there be requirement to replace blown fuse, do remember to disconnect
all power supply and switched off the unit before replacing it with a new one. Use
only correct rating fuse to avoid damaging the unit.
Removal:
Insert durable card between monitor and headrest shroud to remove
the monitor.
CAUTION
1.Do not operatethe monitor attemperatures below 0 or above 40
2.Keep the monitorclean and dry.
3.always seek pualifiedpersonnel to performrepairs . Neverattempt you ownrepairs
4.Do not dropthe monitor orexpose to strongimpacts.
Focus on theconcave of
Durable
monitor and headrest
card
shroud to insert
5.Do not exposeto direct sunlightfor extended periodsof time.
Trimount Mounting
+
SEL
-
POWER
AV
PHONE
+
SEL
-
(Headrest)
POWER
AV
PHONE
+
(Sun-Visor)
SEL
-
POWER
AV
PHONE
(Stand)
5
2
Basic Operating instructions
3) Remote Control Operating Instruction:
1.mute
2.sleep
1
3.contrast control+
4.brightness control-
5.contrast control-
6.brightness control+
7.Hue control+
SLEEP
2
12
13
14
15
16
1
3
4
5
+
1.SEL+
2
SEL
2.SELCT
3
-
3.SEL-
4
8.volume control+
9.Hue control-
POWER
6
7
4.POWER ON/OFF
5
AV
5.AUDIO/VIDEO SWITCH
10.volume control-
11.video1/video2
12.power on/off
13.color control+
14.color control-
15.mode:16:9/4:3
16.prference
6
MODE
PP
8
9
PHONE
6.EARPHONE
10
Precautions:
11
SYS
AV
17
1.This unit should be install by qualified technicians or service personnel.
2.this product is designed to operate with a 12V, negative ground battery
system.
17.system
3.Disconnect the ground wire from the battery terminal before connecting
the electrical system.
4.Refer to the electrical connection diagram to avoid wrong connection of
the electrical system. Always use authorized service center for service
assistance.
CONNECTOR
5.Use proper insulation material to prevent short-circuiting of the supply
system.
6.Tighten all loose wires after installation.
+
SEL
-
7.Refer to is operating instruction for system upgrade and operation.
POWER
Accessories Supplied
AV
PHONE
Item
1
Description
Monitor
Q ty
1
Mark
Remote Control
Power Cable
AV Cable
2
1
1
1
1
W/Battery
3
4
5
6
7
8
Bracket
Earphone
ACC.Bag
1
1
Manual
1
CAR AUDIO(DVD OR VCD)
BATTERY
4
3
|