iSimple Car Stereo System User Manual

IS76  
TM  
MediaWire  
Owner’s Manual  
CAR STEREO  
INTEGRATION FOR YOUR iPod  
OR  
A/V SYSTEM  
MAKE THE CONNECTION  
to your  
iPod  
to your  
iPhone  
RCA audio/video output  
iSimple®  
REG. 03-19-09  
Accessing your auxiliary audio source  
Please refer to the owners manual that came with your radio or vehicle for  
directions on how to access your radio’s auxiliary input source.  
On some iPod models you will need to enter the settings menu, and select video,  
select TV out, and set this option to “ASK”. When a video is selected to play, the  
iPod will ask “do you want to enable TV out?” select on, to view video on an external  
screen using this product.  
Some newer iPod / iPhone models do not have this option in the video settings  
menu. Instead, after connecting your iPod / iPhone to our product, and selecting a  
video to play, the device will ask you automatically “Display on TV?”  
Choose “YES” to watch the video on an external monitor.  
4. Troubleshooting  
Symptom  
Cause  
Remedy  
Check the fuse in the power lead of the  
MediaWire™. If the fuse is blown, replace  
with a fuse of the same amperage. If fuse  
blows again, please call tech support.  
iPod/iPhone is  
not charging  
Fuse is blown  
iPod/iPhone is  
not charging  
and fuse isn’t  
blown  
Check the Power (RED) and Ground  
(BLACK) wires to ensure that they are  
correctly connected to 12V+ and Ground.  
Weak wiring  
connection  
iPod is not set  
for video out  
No video  
No audio  
In settings menu select Video Output ON.  
Verify connection of RCA’s to Receiver.  
RCA is not  
connected  
5. Warranty  
One Year Limited Warranty  
The quality controls used in the manufacture of this product will ensure your  
satisfaction. This warranty applies only to the original purchaser of this product from  
an authorized iSimple® dealer. This warranty covers any supplied or manufactured  
parts of this product that, upon inspection by iSimple® authorized personnel, is found  
to have failed in normal use due to defects in material or workmanship. This warranty  
does not apply to installation expenses. Attempting to service or modify this unit,  
operating this unit under conditions other than the recommended voltage will render this  
WARRANTY VOID.  
Unless otherwise prescribed by law, iSimple® shall not be liable for any personal  
injury, property damage and or any incidental or consequential damages of any  
kind (including water damage) resulting from malfunctions, defects, misuse,  
improper installation or alteration of this product. All parts of this iSimple® product  
are guaranteed for a period of 1 year as follows:  
3
Within the first 12 months from date of purchase, subject to the conditions above,  
iSimple® will repair or replace the product at our discretion, if it is defective in  
material or workmanship providing it is returned to an Authorized iSimpleTM dealer,  
with PROOF OF PURCHASE from an authorized iSimple® dealer.  
Warning:  
This equipment may be reset by unintentional electrostatic discharge during  
operation. Exposure to direct sunlight or extreme heat may cause damage or malfunction.  
FCC Class B Radio Frequency Interference Statement  
This equipment has been tested and found to comply with the limits for a Class  
B digital device, pursuant to Part 15 of FCC rules. These limits are designed to  
provide reasonable protection against harmful interference in a residential installa-  
tion. This equipment generates, uses, and can radiate radio frequency energy and,  
if not installed and used in accordance with the instructions, may cause harmful  
interference to radio communications. However, there is no guarantee that interfer-  
ence will not occur in a particular installation. If this equipment does cause harmful  
interference to radio or television reception, which can be determined by turning  
the equipment off and on, the user is encouraged to try to correct the interference  
by one or more of the following measures:  
1. Re-orientate or relocate the receiving antenna.  
2. Increase the separation between the equipment and receiver.  
3. Connect the equipment into an outlet on a circuit different from  
that of which the receiver is connected.  
4. Consult the dealer or an experienced radio / television technical for help.  
Notice : The changes or modifications not expressly approved by the party responsible  
for compliance could void the user authority to operate the equipment.  
For Best Performance Have It  
Professionally Installed.  
A division of AAMP of America™  
13190 56th Court Clearwater, Florida 33760  
Ph. 866-788-4237  
©2009 AAMP of Florida, Inc.  
“Made for iPod” means that an electronic accessory has been designed to connect specifically to iPod and has been certified  
by the developer to meet Apple performance standards.  
Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.  
“Works with iPhone” means that an electronic accessory has been designed to connect specifically to iPhone and has been  
certified by the developer to meet Apple performance standards.  
Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.  
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.  
iPhone is a trademark of Apple Inc.  
4

Agilent Technologies 34401A User Manual
Bosch Appliances Car Video System VIP User Manual
Cuisinart CBT 500 Series User Manual
Dynex DX MW010 User Manual
Hifionics ZRX15SQD2 User Manual
HP (Hewlett Packard) 39G User Manual
Jawbone Prime User Manual
JVC GR AX77 User Manual
JVC GR DVX509ED User Manual
JVC GR FXM383 User Manual