JBL GT5 A3011 User Manual

GT5-A3011  
OWNER’S MANUAL  
BEDIENUNGSAN-  
LEITUNG  
MODE D'EMPLOI  
MANUAL DE USO  
HANDLEIDING  
MANUALE DEL  
PROPRIETARIO  
ANVÄNDARHANDBOK  
BRUGSVEJLEDNING  
OMISTAJAN KÄSIKIRJA  
PODRĘCZNIK  
UŻYTKOWNIKA  
РУКОВОДСТВО  
ПОЛЬЗОВАТЕЛЯ  
ENGLISH  
GT5-A3011 CAR AUDIO SUBWOOFER AMPLIFIER OWNER’S MANUAL  
0
4
Installation Warnings and Tips  
Speaker Output Connectors  
Input Connectors (RCA)  
• Connect the subwoofer to these terminals,  
observing proper polarity. Either + or –  
terminal may be used. Minimum total  
impedance is 1 ohm.  
• Connect to the RCA outputs from the source unit  
• Disconnect the negative (–) lead from your vehicle’s  
or signal processor.  
battery.  
5
Input-Level Control  
• At the installation sites, locate and make a note of  
all fuel lines, hydraulic brake lines, vacuum lines  
and electrical wiring. Use extreme caution when  
cutting or drilling in and around these areas.  
• Choose a safe mounting location away from moisture.  
• Make sure there is sufficient air circulation at the  
mounting location for the amplifier to cool itself.  
• Mount the amplifier, using the supplied hardware.  
• Used to match the input level of the amplifier  
1
2
Fuses  
to the output level of the source unit.  
• Replace only with the same type and rating.  
Power Input Connectors  
9
• See  
for the adjustment procedure.  
6
7
Protect LED  
• +12V: Connect to the positive terminal of the  
vehicle’s battery. 8 AWG wire is recommended.  
Install an appropriate fuse holder and fuse (40A  
minimum) within 18 inches of the battery. Make  
sure the wire is not damaged or pinched during  
installation. Install protective grommets when  
routing wires through the firewall or other sheet  
metal.  
• Illuminated under any of the following fault  
conditions: battery over/under voltage, short  
circuit in speaker wires, amplifier is too hot,  
amplifier’s output circuit has failed (DC voltage is  
present in the amplifier’s output).  
Low-Pass Filter Frequency Control  
• 12dB/octave low-pass filter,  
Specifications  
• 200W RMS x 1 @ 4 ohms and 1% THD + N*  
• 300W RMS x 1 @ 2 ohms, 14.4V supply and  
1% THD + N*  
• Maximum input signal: 6V*  
• Maximum sensitivity: 200mV*  
• THD + N: 0.05%*  
• Signal-to-noise ratio: 95dBA  
(reference 1W into 4 ohms)*  
• Signal-to-noise ratio: 120dBA  
(reference rated power into 4 ohms)  
• Frequency response: 10Hz – 300Hz (–3dB)*  
• Total peak power: 600 watts  
* CEA-2006A-compliant  
variable from 32Hz to 320Hz.  
• GND: Connect to the vehicle’s chassis. Refer to  
the picture below.  
A
• See  
for the adjustment procedure.  
8
9
Power On LED  
• Illuminated when the amplifier is on.  
Setting Input Level  
A Turn Input Level control counterclockwise to  
6V (minimim).  
B With a dynamic music track playing, turn the  
head unit’s volume control to the 3/4 position.  
C Turn Input Level control clockwise until the  
bass output is proportionate to the output of  
the high-frequency speakers, according to  
your preference.  
D Input level is now adjusted correctly.  
Setting the Crossover  
A
A Crossover setting for subwoofers.  
Note: Acceptable frequency ranges are indicated  
in gray.  
• REM: Connect to the “Remote Out” lead from the  
source unit or to a source of switched  
+12V (ACC).  
3
Aux Output Connectors (RCA)  
• Nonfiltered pass-through output. Connect to  
the input of an additional amplifier.  
This product is designed for mobile applications and is not  
intended for connection to the mains.  
A valid serial number is required for warranty coverage.  
Features, specifications and appearance are subject to change  
without notice.  
Declaration of Conformity  
Harman Consumer Group, Inc.  
250 Crossways Park Drive, Woodbury, NY 11797  
We, Harman Consumer Group, Inc.  
2, route de Tours  
72500 Château du Loir  
France  
© 2008 Harman International Industries, Incorporated. All rights reserved.  
declare in own responsibility that the product described in this owner’s  
manual is in compliance with technical standards:  
EN 55013:2001+A1:2003  
JBL is a trademark of Harman International Industries, Incorporated,  
registered in the United States and/or other countries. GT Series is a  
trademark of Harman International Industries, Incorporated.  
EN 55020:2002+A1:2003  
Klaus Lebherz  
Harman Consumer Group, Inc.  
Château du Loir, France 7/08  
Part No. GT5A3011OM 7/08  
www.jbl.com  

Blaupunkt ACAPULCO Acapulco CD51 User Manual
Canon 6569B001 User Manual
Canon MVX300 User Manual
Contour VholdR J61250712V1100 User Manual
Dual SD XDMA6370 User Manual
FOCUS Enhancements FS 2E User Manual
Hamilton Beach 70610C User Manual
Hitachi BE IR30 User Manual
JVC Car Speaker KD R338 User Manual
JVC GET0651 002A User Manual